High energy storage and ultrafast discharge in NaNbO3-based lead-free dielectric capacitors via a relaxor strategy

Dielectric capacitors with decent energy storage and fast charge-discharge performances are essential in advanced pulsed power systems. In this study, novel ceramics (1-x)NaNbO₃-xBi(Ni_2/3Nb_1/3)O₃(xBNN, x = 0.05, 0.1, 0.15 and 0.20) with high energy storage capability, large power density and ultrafast discharge speed were designed and prepared. The impedance analysis proves that the introducing an appropriate amount of Bi(Ni_0·5Nb_0.5)O₃ boosts the insulation ability, thus obtaining a high breakdown strength (E_b) of 440 kV/cm in xBNN ceramics. A high energy storage density (W_total) of 4.09 J/cm³, recoverable energy storage density (W_rec) of 3.31 J/cm³, and efficiency (η) of 80.9% were attained in the 0.15BNN ceramics. Furthermore, frequency and temperature stability (fluctuations of W_rec ≤ 0.4% over 5–100 Hz and W_rec ≤ 12.3% over 20–120 °C) were also observed. The 0.15BNN ceramics exhibited a large power density (19 MW/cm³) and ultrafast discharge time (~37 ns) over the range of ambient temperature to 120 °C. These enhanced performances may be attributed to the improved breakdown strength and relaxor behavior through the incorporation of BNN. In conclusion, these findings indicate that 0.15BNN ceramics may serve as promising materials for pulsed power systems.     

Key-dependent side-channel cube attack on CRAFT

CRAFT is a tweakable block cipher introduced in 2019 that aims to provide strong protection against differential fault analysis. In this paper, we show that CRAFT is vulnerable to side-channel cube attacks. We apply side-channel cube attacks to CRAFT with the Hamming weight leakage assumption. We found that the first half of the secret key can be recovered from the Hamming weight leakage after the first round. Next, using the recovered key bits, we continue our attack to recover the second half of the secret key. We show that the set of equations that are solvable varies depending on the value of the key bits. Our result shows that 99.90% of the key space can be fully recovered within a practical time.     

施工过程中腐蚀隐患的控制

通过分析石化装置施工过程中常见的现象,分析产生由这些现象加重腐蚀的原因和机理, 指出应加强施工过程中的控制,而达到预期的防腐蚀效果,消除腐蚀隐患。     

岩性指示曲线重构及其在储层预测中的应用

大牛地上古生界岩性气藏主要发育在三角洲分流河道沉积的下石盒子组、海陆交互沉积的山西组及以潮坪相沉积为主的太原组,储层是储集性能较差的致密砂岩,平均孔隙度小于10％,渗透率小于1×10-2μm2,储层单层厚度一般小于10 m,砂体横向连通性较差。由于低孔、低渗特征导致储层与围岩的波阻抗差异微弱,用地震资料进行储层预测困难。为此,针对大牛地石板太工区优质储层的岩性特征和测井响应特征进行了测井综合分析,利用对岩性粒度敏感的自然伽马曲线,以及对岩性粒度响应频率较低,且与波阻抗有较好对应关系的中子曲线重构了岩性指示曲线。岩性指示曲线不仅可以有效地识别优质砂体,划分不同岩性,为地震、测井信息结合的岩性反演建立桥梁,同时也为反演结果识别气层打下了基础。利用岩性指示曲线、波阻抗和电阻率曲线进行的地震、测井联合反演技术在石板太工区取得了较好的效果,同时,对石板太工区下石盒子组盒2段、山2段进行了储层和含气性预测,划分了有利含气区带,部署的2口开发井和1口探井有2口井见气,其中1口井获高产气流。     

阜阳地区石炭-二叠系煤系烃源岩特征

阜阳地区石炭-二叠系煤系地层发育，但由于勘探程度较低，对该区煤系地层烃源岩的生烃潜力认识不清，严重制约了该区的油气勘探。在已有资料的基础上，通过有机地球化学和有机岩石学方法并结合模拟实验，探讨了该区煤系烃源岩的生烃潜力。研究结果表明阜阳地区石炭-二叠系煤系烃源岩有机质丰度达到中等-好烃源岩标准，有机质类型以腐殖型为主，盆地模拟结果显示阜阳地区石炭-二叠系煤系地层油资源量为（30.47~152.33）×10⁶t，气资源量为（266.7～1333.7）×10⁸m³，展示阜阳地区石炭-二叠系煤系地层具有较好的生油气潜力。     

Preparation, patterning and luminescent properties of nanocrystalline Gd2O3:A (A=Eu, Dy, Sm, Er) phosphor films via Pechini sol–gel soft lithography

Nanocrystalline Gd₂O₃:A (A=Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺) phosphor films and their patterning were fabricated by a Pechini sol–gel process combined with a soft lithography. X-ray diffraction (XRD), atomic force microscopy (AFM), scanning electron microscopy (SEM) and optical microscopy, UV/vis transmission and photoluminescence (PL) spectra as well as lifetimes were used to characterize the resulting films. The results of XRD indicated that the films began to crystallize at 500 °C and that the crystallinity increased with the elevation of annealing temperatures. Uniform and crack free non-patterned phosphor films were obtained by optimizing the composition of the coating sol, which mainly consisted of grains with an average size of 70 nm and a thickness of 550 nm. Using micro-molding in capillaries technique, we obtained homogeneous and defects-free patterned gel and crystalline phosphor films with different stripe widths (5, 10, 20 and 50 μm). Significant shrinkage (50%) was observed in the patterned films during the heat treatment process. The doped rare earth ions (A) showed their characteristic emission in crystalline Gd₂O₃ phosphor films due to an efficient energy transfer from Gd₂O₃ host to them. Both the lifetimes and PL intensity of the rare earth ions increased with increasing the annealing temperature from 500 to 900 °C, and the optimum concentrations for Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺ were determined to be 5, 0.25, 1 and 1.5 mol% of Gd³⁺ in Gd₂O₃ films, respectively.     

Nonlinear protein binding and enzyme heterogeneity: effects on hepatic drug removal

The kinetics of substrate removal by the liver and the resulting nonlinear changes in unbound fraction along the flow path at varying input drug concentrations were examined by a model simulation study. Specifically, we varied the binding association constant, KA, and the Michaelis-Menten constants (Km and Vmax) to examine the steady state drug removal (expressed as hepatic extraction ratio E) and changes in drug binding for (i) unienzyme systems and (ii) simple, parallel metabolic pathways; zonal metabolic heterogeneity was also added as a variable. At low KA, E declined with increasing input drug concentration, due primarily to saturation of enzymes; only small differences in binding were present across the liver. At high KA, a parabolic profile for E with concentration was observed; changes in unbound fraction between the inlet and the outlet of the liver followed in parallel fashion. Protein binding was the rate-determining step at low input drug concentrations, whereas enzyme saturation was the rate-controlling factor at high input drug concentration. Heterogeneous enzymic distribution modulated changes in unbound fraction within the liver and at the outlet. Despite marked changes in unbound fraction occurring within the liver for different enzymic distributions, the overall transhepatic differences were relatively small. We then investigated the logarithmic average unbound concentration and the length averaged concentration as estimates of substrate concentration in liver in the presence of nonlinear drug binding. Fitting of simulated data, with and without assigned random error (10%), to the Michaelis-Menten equation was performed; fitting was repeated for simulated data obtained with presence of a specific inhibitor of the high-affinity, anteriorly distributed pathway. Results were similar for both concentration terms: accurate estimates were obtained for anterior, high affinity pathways; an overestimation of parameters was observed for the lower affinity posteriorly distributed pathways. Improved estimations were found for posteriorly distributed pathways upon inhibition with specific inhibitors; with added random error, however, the improvement was much decreased. We applied the method for fitting of several sets of metabolic data obtained from rat liver perfusion studies performed with salicylamide (SAM) (i) without and (ii) with the presence of 2,6-dichloro-4-nitrophenol (DCNP), a SAM sulfation inhibitor. The fitted results showed that SAM sulfation was a high-affinity high-capacity pathway; SAM glucuronidation was of lower affinity but comparable capacity as the sulfation pathway, whereas SAM hydroxylation was of lower affinity and lower capacity.     

红外热图技术在气功研究中的应用

本文用红外技术研究发功时上肢体表温度变化的特点和它的规律。     

挤压力对晶体生长速度及枝晶间距的影响

研究了挤压铸造时挤压力对宏观晶体生长速度的影响，给出了晶体生长速度表达式。结果表明：挤压力对合金宏观晶体生长速度的影响除与合金成分有关外，在某些挤压条件下，当形核率的增加幅度超过长大速度时，则挤压力可使宏观晶粒细化；反之，会使宏观晶粒变粗。随着挤压力的提高，合金凝固速度加快，一次枝晶间距和二次枝晶间距都随之减小，从而细化了树枝晶。