Nonstationary Simulation Model of Absorber with Falling Film of Suspension

A nonstationary model of SO₂ absorption from a gas phase to a countercurrent falling film of absorbing slurry was developed. Laminar, wavy and turbulent film structures were considered based on published information. Resistances to the mass transfer on the gas and the liquid sides of the interphase were considered, together with chemical reactions in the liquid phase. Relevant chemical equilibria in the liquid phase were modeled. Original experimental data on the neutralization reagent dissolution rate presented as a polydispersed two‐phase system of solids and on the rate of dissolved sulfite oxidation were used. The model was verified with experimental data from a laboratory‐scale falling‐film absorber using a single vertical tube under various geometrical and operating conditions, and a very good agreement was found with the experiment. Parametric sensitivity analysis showed the critical parts of the model.     

Anthocyanin composition of the red wine Babić affected by maceration treatment

Identification of anthocyanins in the wine made of the Croatian autochthonous grape variety of Babić (Vitis vinifera L.) was carried out and their profile was determined by means of high-performance liquid chromatography with diode array and mass spectrometric detection. Dependence of anthocyanins content and profile on maceration treatment conditions was investigated. Statistically significant differences of anthocyanins concentration in wines Babić produced by various maceration treatments were confirmed by the use of multivariate analysis of variances. The investigation results indicated that the maceration temperature exerts higher influence on anthocyanins concentration than the duration of maceration. In addition, on the basis of anthocyanin composition and using different multivariate statistical analyses, differentiation of wines Babić according to maceration treatments was procured.     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Nonuniformity of phase structure in immiscible polymer blends

This article is focused on the phase structure development in immiscible polymer blends during melt mixing. Nonuniformity of the phase structure, i.e., the coexistence of areas containing particles with markedly different size distribution, was detected in quenched and compression molded samples of a number of various blends prepared by long and intensive mixing in the chamber of a Plasticorder. The same effect was found also for polystyrene/polyamide blends prepared in a twin‐screw extruder. It was shown that neglecting nonuniformity of the phase structure can lead to considerable error in evaluation of the effect of system parameters on the blend morphology. The reasons for the effect were discussed and it was found that inhomogeneous flow field in mixers is a plausible explanation of the nonuniform phase structure. POLYM. ENG. SCI., 2008. © 2008 Society of Plastics Engineers     

Development of catalysts for hydrogen generation from hydride compounds

Catalytic hydrolysis of NaBH₄ and NH₃BH₃ has been studied. It was shown that the nature of the support and the active component of the catalyst affect the H₂ generation rate. Despite similar sizes of rhodium particles formed on the surface of different supports (γ-Al₂O₃, TiO₂, carbon), their reactivity is different. Rh/TiO₂ with low rhodium concentration (1 wt.%) is the most active catalyst both in the hydrolysis of NaBH₄ and NH₃BH₃. The obtained results show that the rhodium chloride interaction with titania determines the reactivity of rhodium particles formed under action of NaBH₄ medium. TEM, DRS UV–vis and XPS were used to characterize the catalysts.     

Influence of To?pa Peat Preparation on the phagocytic activity and bactericidal properties of granulocytes in healthy volunteers

It was found, that To?pa Peat Preparation (TPP) administered to healthy volunteers in doses of 100-300 mg/day during 14 days evoked the stimulation of the phagocytic and bactericidal activity of the granulocytes. The dose of 600 mg/day causes only a transient and insignificant increase of phagocytic and bactericidal properties of the granulocytes.     

Trypsin inhibitor activity of soybean as affected by genotype and fertilisation

The presence of protease inhibitors in soybean prohibits the utilisation of the raw beans for food and feed. However, little information is available about environmental influences and the effects of nitrogen and sulphur supply on the antinutritional constituents of soybean. As these factors may influence protease inhibitors, soybean genotypes segregated according to the presence or absence of the Kunitz trypsin inhibitor have been evaluated for trypsin inhibitor activity (TIA) in field trials. TIA was affected significantly by environment (geographical location), fertilisation treatment and genotype. Environmental means of TIA were between 69.5 and 104.8 mg g^?1. Nitrogen application, which caused an increase in seed protein content, resulted in a reduction in TIA by about 15% as compared with the control. Remarkably, simultaneous application of nitrogen and sulphur in the form of ammonium sulphate had a similar reductive effect on TIA to that of nitrogen application alone, although soybean protease inhibitors are rich in sulphur amino acids. Significant genetic variation in TIA was found both within the genotype class with the Kunitz inhibitor present as well as within the class lacking this inhibitor. The results suggest that TIA of soybean may be modified considerably by genetic improvement and appropriate agronomic management. Copyright © 2003 Society of Chemical Industry     

What are the key elements of a sustainable university?

Nowadays, the principles of sustainable development are becoming increasingly important and universities are acting as agents in promoting these principles within society. In the future, universities will inevitably play crucial role in propagating these principles. This paper highlights important documents and discusses definitions of the term education for sustainable development. Elements, based on continuous feedback loop (Deming spiral) are discussed, in order to incorporate sustainability principles into university activities. The University of Maribor has been used as a case study to test the effectiveness of the proposed integration of sustainable development principles.     

Flux Jumps and H-T Diagram of Instability for MgB2

We present a study of magneto-thermal instabilities in polycrystalline MgB₂ superconductor, by magnetic hysteresis loop measurements and by investigations of magnetic flux dynamics with a miniature Hall probe. Temperature and magnetic field ranges where the flux jumps may be observed have been determined. On the basis of measurements of the magnetic flux dynamics, an average magnetic diffusivity describing the process of the flux jump is estimated. This parameter is compared with the thermal and magnetic diffusivities calculated on the basis of available data for thermal conductivity, heat capacity and resistivity. It is shown that the estimated value of the field of the first flux jump is influenced significantly by the field dependence of specific heat. In order to explain the observed phenomenon, the temperature reached by the sample during the flux jump at different magnetic fields is calculated.