Differential Game for Distributed Power Control in Device-to-Device Communications Underlaying Cellular Networks

Wireless Personal Communications - In the formulating of power control for wireless networks, the radio channel is commonly formulated using static models of optimization or game theory. In these...     

Improvement in hydrolytic procedure for GLC determination of non-indolyl glucosinolates in rapeseed as isothiocyanates

Some methods determine the non-indolyl glucosinolates content in rapeseed as their hydrolysates: the isothiocyanates and the oxazolidinethiones. These methods in their present form underestimate the amount of the glucosinolates content. In this investigation, a modified method was developed to give a better quantitative estimate, indicating a glucosinolate level five times that obtained by a typical existing method.     

Thickness-dependence of stoichiometry and microstructure characteristics in correlation with conductivity type of CdTe films

CdTe films were prepared by physical vapour deposition on a substrate at room temperature (RT) as well as on a cold (LT) one using low deposition rate. The thickness-dependence of stoichiometry revealed an abrupt decrease in the Cd/Te ratio as the thickness increases. Change of thickness did not affect the type of observed (111) crystallographic texture, only the degree of preferred orientation is enhanced as the film grows. The internal strain was negligible while the crystallite size increased rapidly at small thickness (up to 400 nm), and less thickness dependence was observed with further film growth. However, thickness dependence of lattice parameters showed a minimum and a maximum at approximately 300 nm in the case of RT and LT, respectively. The observed change in conductivity from n- to p-type and its vital correlation with the stoichiometry and structural characteristics were presented. Based on thickness dependence of stoichiometry and lattice parameters as well as the conductivity type, formation and annihilation of lattice defects were considered.     

Modelling and controller design of an isolated diesel enginepermanent magnet synchronous generator

A method to analyze the steady-state performance of a stand-alone permanent magnet synchronous generator driven by a diesel engine is presented. The proposed method is based on equivalent d-q circuits and the phasor diagram of such a generator under steady-state conditions. A fixed capacitor-thyristor controlled reactor scheme is used to regulate the generator terminal voltage by controlling the thyristor ignition angle. Furthermore the overall system dynamics are modelled in terms of state variables and control inputs. Based on a reduced order linearized model, digital optimal state and output feedback controllers are designed by minimising a quadratic performance index using the dynamic programming technique. The objective of the controller is to maintain the load voltage and frequency constant under varying load conditions. The controller's effectiveness is assessed by examining the closed-loop system response to sudden load changes     

Effect of electron irradiation on alternating current electrical properties of gelatin – cadmium sulfide nano-composite films

Gelatin was doped with 1 %, 3 %, 5 % and 10 % cadmium sulfide nanoparticles in weight concentrations forming the gelatin-cadmium sulfide nanocomposites and irradiated by various electron beam doses equals 50 kGy, 75 kGy, 100 kGy, and 150 kGy using 3 MeV – 3 mA electron accelerator. The applied alternating current electrical field frequency ranging from 70 Hz to 5 MHz is what caused the fluctuation in dielectric properties and alternating current electrical conductivity of these nanocomposites. The results showed that the films of 1 %, 3 %, 5 %, and 10 % for blank (nanocomposite film without electron beam irradiation) nanocomposites had the highest dielectric parameters (έ, ϵ′′, tan δ) at 0.5 kHz with values of (0.696, 0.0233, 0.034), (0.533, 0.0114, 0.0215), (0.402, 0.001196, 0.003), and (0.459, 0.00418, 0.0091), respectively. However, the lowest dielectric parameters were (0.645, 0.00618, 0.0066), (0.523, 0.00165, 0.0215), (0.417, 0.00035, 0.0008), and (0.455, 0.00066, 0.0015) at 5 MHz, respectively. The highest conductivity values for blank nanocomposites of 1 %, 3 %, 5 %, and 10 % were 1.79×10⁻⁴ S/m, 1.45×10⁻⁴ S/m, 1.16×10⁻⁴ S/m, 1.27×10⁻⁴ S/m at 5 MHz, and the lowest values were 1.92×10⁻⁸ S/m, 1.49×10⁻⁸ S/m, 1.13×10⁻⁸ S/m, 1.26×10⁻⁸ S/m at 0.5 kHz, respectively. For irradiated nanocomposites at 5 MHz, the dielectric constant order for 1 % was 100 kGy, 150 kGy, 50 kGy, and 75 kGy with values 0.63, 0.537, 0.532, and 0.523, respectively. For 10 % weight concentration, the order was 50 kGy, 100 kGy, 150 kGy, and 75 kGy with values 0.515, 0.477, 0.47, and 0.437, respectively. Otherwise the dielectric constant order for 3 % and 5 % was 100 kGy, 75 kGy, 150 kGy, and 50 kGy. The highest dielectric properties and conductivity values for blank and irradiated nanocomposites were observed at 100 kGy for 1 %, 3 %, and 5 %.     

A new expert system for learning management systems evaluation based on neutrosophic sets

There has been a sudden increase in the usage of Learning Management Systems applications to support learner's learning process in higher education. Many studies in learning management system evaluation are implemented under complete information, while the real environment has uncertainty aspects. As these systems were described by development organizations with uncertainty terms such as vague, imprecise, ambiguity and inconsistent, that is why traditional evaluation methods may not be effective. This paper suggests neutrosophic logic as a better option to simulate human thinking than fuzzy logic because unlike fuzzy logic, it is able to handle indeterminacy of information which expresses the percentage of unknown parameters. As previous studies suggested neutrosophic decision maker and neutrosophic expert systems as future work in ecommerce and e‐learning applications, this paper presents neutrosphic expert system for learning management systems evaluation. Information for building and validating the neutrosophic expert system is collected from five experts using surveys, and then analysis is done by using Fuzzytech 5.54d software. Finally, the comparison between fuzzy expert system and neutrosophic expert system results show that the neutrosophic logic is capable of representing uncertainty in human thinking for evaluating Learning Management Systems.     

Computerized relational model for powder technology: powder and process selection

Part of a complete expert-system software design for powder technology is presented. This part of the system deals with powder selection according to predetermined, recommended or required material properties, and specific powder characteristics. Then the optimum powder production, i.e processing, method is determined, which satisfies the requirements of the specified powder. For this purpose a detailed database relational model is developed, and the system's software modules are described. A relational model is formulated and a structured query language (SQL) is used in the detailed software design presented.     

Combined Modeling Study of the Binding Characteristics of Natural Compounds,Derived from Psoralea Fruits,to β-Amyloid Peptide Monomer

A dysfunctional protein aggregation in the nervous system can lead to several neurodegenerative disorders that result in intracellular inclusions or extracellular aggregates. An early critical event within the pathogenesis of Alzheimer’s disease is the accumulation of amyloid beta peptide within the brain. Natural compounds isolated from Psoralea Fructus (PF) have significant anti-Alzheimer effects as strong inhibitors of Aβ42 aggregation. Computer simulations provide a powerful means of linking experimental findings to nanoscale molecular events. As part of this research four prenylated compounds, the active ingredients of Psoralea Fructus (PF), were studied as Aβ42 accumulation inhibitors using molecular simulations modeling. In order to resolve the binding modes of the ligands and identify the main interactions of Aβ42 residues, we performed a 100 ns molecular dynamics simulation and binding free energy calculations starting from the model of the compounds obtained from the docking study. This study was able to pinpoint the key amino acid residues in the Aβ42 active site and provide useful information that could benefit the development of new Aβ42 accumulation inhibitors.     

The effect of voluntary hyperventilation on arterial blood gases and gas exchange in patients with chronic obstructive lung disease

A 2 min test of voluntary hyperventilation (VHV) was performed on 19 patients with chronic obstructive lung disease (COLD) and on eight control subjects. The average decrease in PaCO2 in the patients in this test was 4.6 mmHg (11%) and the average increase in PaO2 was 12.3 mmHg (19.1%). The average decrease of PaCO2 in control subjects was 16.5 mmHg (48.6%) and the average increase in PaO2 was 38.0 mmHg (46.2%). In patients with COLD, PaCO2 changes during VHV correlated significantly with respiratory exchange ratio; the correlation with minute and alveolar ventilation and deltaVO2/deltaVE ratio during VHV was of borderline significance. PaCO2 changes during VHV did not correlate with FEV1 (percent of predicted) or FEV1/VC%. The possible mechanisms of changes in blood gas tensions during and after the end of VHV test are discussed. The VHV test seems to be useful in evaluation of patients with COLD.