Diluted chemical bath deposition of CdZnS as prospective buffer layer in CIGS solar cell

In this study, dilute chemical bath deposition technique has been used to deposit CdZnS thin films on soda-lime glass substrates. The structural, morphological, optoelectronic properties of as-grown films have been investigated as a function of different Zn²⁺ precursor concentrations. The X-ray diffractogram of CdS thin-film reveals a peak corresponding to (002) plane with wurtzite structure, and the peak shift has been observed with the increase of the Zn²⁺ concentration upon formation of CdZnS thin film. From morphological studies, it has been revealed that the diluted chemical bath deposition technique provides homogeneous distribution of film on the substrate even at a lower concentration of Zn²⁺. Optical characterization has shown that the transparency of the film is influenced by Zn²⁺ concentration and when the Zn²⁺ concentration is varied from 0 M to 0.0256 M, bandgap values of resulting films range from 2.42 eV to 3.90 eV while. Furthermore, electrical properties have shown that with increasing zinc concentration the resistivity of the film increases. Finally, numerical simulation validates and suggests that CdZnS buffer layer with composition of 0.0032 M Zn²⁺ concentration would be a promising candidate in CIGS solar cell.     

Smart Edge Computing for 5 g/6 g Satellite IOT for Reducing Inter Transmission Delay

Mobile Networks and Applications - 5G/6G communication are first generation high speed wireless communication network which integrates the aerial data, terrestrial data and maritime data via...     

Review on zirconate-cerate-based electrolytes for proton-conducting solid oxide fuel cell

The performance of low-to-intermediate temperature (400–800?°C) solid oxide fuel cells (SOFCs) depends on the properties of electrolyte used. SOFC performance can be enhanced by replacing electrolyte materials from conventional oxide ion (O^2-) conductors with proton (H⁺) conductors because H⁺ conductors have higher ionic conductivity and theoretical electrical efficiency than O^2- conductors within the target temperature range. Electrolytes based on cerate and/or zirconate have been proposed as potential H⁺ conductors. Cerate-based electrolytes have the highest H⁺ conductivity, but they are chemically and thermally unstable during redox cycles, whereas zirconate-based electrolytes exhibit the opposite properties. Thus, tailoring the properties of cerate and/or zirconate electrolytes by doping with rare-earth metals has become a main concern for many researchers to further improve the ionic conductivity and stability of electrolytes. This article provides an overview on the properties of four types of cerate and/or zirconate electrolytes including cerate-based, zirconate-based, single-doped cerate–zirconate and hybrid-doped cerate–zirconate. The properties of the proton electrolytes such as ionic conductivity, chemical stability and sinterability are also systematically discussed. This review further provides a summary of the performance of SOFCs operated with cerate and/or zirconate proton conductors and the actual potential of these materials as alternative electrolytes for proton-conducting SOFC application.     

Design of an Electromagnetic Frequency Tunned Antenna for Mobile Communications

Wireless Personal Communications - Current mobile communications technology relies heavily on efficient design of antennas, where the operational characteristics of the wireless communication...     

Stabilization of 6H-Hexagonal SrMnO3 Polymorph by Al2O3 insertion

We demonstrate the structural evolution of polymorphic phases in Al₂O₃-inserted SrMnO₃ ceramics synthesized by solid state reaction. While the 4H-hexagonal phase is predominant in pure SrMnO₃ ceramics, a small amount of 6H-hexagonal polymorph is identified in addition to the primary 4H-hexagonal SrMnO₃ and the secondary hexagonal SrAl₂O₄ phases in the as-sintered ceramics, evidenced by x-ray diffraction and subsequent Rietveld refinement analyses. The existence of the 6H-hexagonal SrMnO₃ phase is corroborated using Raman spectroscopy. The chemical compositions and electronic structures of the Al₂O₃-inserted SrMnO₃ compounds are also examined using energy dispersive spectroscopy and x-ray photoelectron spectroscopy, respectively. The first-principles calculations reveal that there is no clear difference between the total energies of 4H- and 6H-hexagonal polymorphs regardless of the presence/absence of Sr and oxygen vacancies. Possible origins are discussed with the estimation of actual strain based on the refined lattice parameter of 6H SrMnO₃.     

Analyzing the determinants of carbon emissions from transportation in European countries: the role of renewable energy and urbanization

Clean Technologies and Environmental Policy - The continuous growth of transport sector and the increase in carbon emissions from transportation attract the attention of policy makers in...     

An aldose reductase inhibitor and aminoguanidine prevent vascular endothelial growth factor expression in rats with long-term galactosemia

OBJECTIVE: To study the effects of an aldose reductase inhibitor (ARI-509, Wyeth-Ayerst, Princeton, NJ) and aminoguanidine (AMG), agents that have been reported to prevent or delay diabetic retinopathy, on retinal vascular abnormalities and the immunocytochemical expression in the retina of vascular endothelial growth factor (VEGF) in rats maintained for up to 2 years on a 50% galactose diet. METHODS: Albino rats were placed on a control diet, a diet containing 50% galactose, or the 50% galactose diet containing either ARI-509 or AMG. Treatment with ARI-509 or AMG was initiated at the beginning of the experiment or after 12 months of galactose feeding. After 22 to 24 months, the rats were killed and the retinal vasculature from half of one eye was isolated by trypsin-elastase digestion for semiquantitative evaluation of retinal vascular lesions. The other half of the retina was prepared for immunocytochemistry and stained for the presence of VEGF, factor VIII, vimentin, and glial fibrillary acidic protein. Red blood cells, sciatic nerves, and a portion of the retina from the second eye were assayed for glucose, galactose, fructose, sorbitol, galactitol, and myo-inositol. Red blood cells were also assayed for galactosylated hemoglobin. RESULTS: Galactose-fed animals developed a vascular retinopathy characterized by severe cellular loss in the retinal capillaries and intensification of periodic acid-Schiff staining of the vascular basement membranes. Some animals also displayed dilation and hypercellularity of vessels in the posterior retina. These changes were substantially reduced in animals receiving ARI-509 from the beginning of the galactose diet, but were unaffected in all of the other treatment groups. None of the rats receiving ARI-509 or AMG treatment, whether initiated from the onset or after 12 months of galactosemia, demonstrated VEGF immunoreactivity. With the exception of the animals receiving ARI-509 from the beginning of the experiment, all of the galactose-fed animals developed dense cataracts within 6 weeks of the beginning of the galactose diet. Galactitol levels in animals receiving ARI-509 were 86% to 93% lower in red blood cells, retina, and sciatic nerve than those in the other galactose-fed groups. CONCLUSIONS: Although ARI-509 and AMG have different abilities to delay or prevent the diabetic-like retinopathy in galactosemic rats, even when substantial retinal microvascular acellularity occurs, both drugs prevent the immunocytochemical expression of VEGF. These results suggest that factors other than hypoxia may be responsible for VEGF expression in the retina, and that aldose reductase inhibitors and AMG have potential roles in preventing such expression and, thus, perhaps preventing retinal neovascularization.     

Preparation and properties of novel polyurethane insulating coatings based on glycerin‐terminated urethane prepolymers and blocked isocyanate

Novel polyurethane insulating coatings were prepared from the reaction of glycerin‐terminated polyurethane prepolymers (GPUPs) and a blocked isocyanate curing agent (BIC). The GPUPs were prepared from the reaction of one equivalent of polycaprolactone polyol (CAPA 210) with an excess amount of 4,4′‐methylene bis(phenyl isocyanate) (MDI) and subsequent reaction of the NCO‐terminated polyurethane with glycerin. The BIC was prepared from the reaction of trimethylol propane (TMP), toluene diisocyanate (TDI) and N‐methylaniline (NMA). The polyols and curing agent were characterized by conventional methods while the curing condition was optimized via gel content measurements. The curing kinetics of the polyurethane coating were investigated and the kinetic parameters derived. The crosslink densities of the samples were determined via the equilibrium swelling method, using the Flory–Rehner equation. The relationships between the crosslink density and the electrical, physical, mechanical and dynamic mechanical properties of the coatings were also studied. Copyright © 2005 Society of Chemical Industry     

逆向反射镜光度测量

为了正确评价逆向反射镜的加工质量与使用效果，且将二者有机地统一起来，本文提出应根据测试目的来选择合适的光度测量方法，并进一步分析了不同测试目的将导致测量装置的组成、几何条件（距离，孔径角，工作姿态等）、光度条件（光源色温、稳定性与均匀性，接收器线性、灵敏度与光谱修正等）、测量参数（反光强度系数、逆反射系数、逆亮度系数等）等各不相同。