Development of core mode blocker with H/sub 2/-loaded Ge-B codoped fibres

A novel fabrication method of the core mode blocker by exposing H/sub 2/-loaded Ge-B codoped fibres to local electric arc discharge for application to the LPFGs-based tunable all-fibre bandpass filter with 6.5 nm bandwidth and 40 nm tuning range is presented.     

N-Type Field-Effect Transistors Using Multiple Mg-Doped ZnO Nanorods

Nanorod field-effect transistors (FETs) that use multiple Mg-doped ZnO nanorods and a SiO₂ gate insulator were fabricated and characterized. The use of multiple nanorods provides higher on-currents without significant degradation in threshold voltage shift and subthreshold slopes. It has been observed that the on-currents of the multiple ZnO nanorod FETs increase approximately linearly with the number of nanorods, with on-currents of ~1 muA per nanorod and little change in off-current (~4times10^-12). The subthreshold slopes and on-off ratios typically improve as the number of nanorods within the device channel is increased, reflecting good uniformity of properties from nanorod to nanorod. It is expected that Mg dopants contribute to high n-type semiconductor characteristics during ZnO nanorod growth. For comparison, nonintentionally doped ZnO nanorod FETs are fabricated, and show low conductivity to compare with Mg-doped ZnO nanorods. In addition, temperature-dependent current-voltage characteristics of single ZnO nanorod FETs indicate that the activation energy of the drain current is very low (0.05-0.16 eV) at gate voltages both above and below threshold     

Parasitic Bipolar Junction Transistors in a Floating-Gate MOSFET for Fluorescence Detection

In this letter, we examined whether the parasitic bipolar junction transistors (BJTs) in the MOSFET fabricated by the standard CMOS process can play a role as a fluorescence detector. To suppress the action of two vertical parasitic BJTs, the gate and n-well were tied in the parasitic BJTs, and the body node was connected to the drain. The proposed device was compared with the inherent and the parasitic diodes in the MOSFET. It had 100 times higher photocurrents than the diodes in the MOSFET. In addition, it was applied for the detection of the fluorescent signal, and could detect near 10 nM of Alexa 546. Therefore, CMOS-process-compatible parasitic BJTs can be used as a photodetector in an integrated fluorescence detector.     

Effect of Nitrogen Atmosphere on the Densification of a 3-mol%-Yttria-Doped Zirconia

The densification behavior of a 3-mol%-Y₂O₃-doped ZrO₂ (3Y-ZrO₂) has been investigated under N₂ and O₂ atmospheres. Powder compacts have been sintered at 1550° and 1400°C for various times. The density of the specimen sintered at 1550°C is higher in N₂ than in O₂, while the contrary result is obtained in the case of the specimen sintered at 1400°C. Such results can be explained in terms of nitrogen solubility and oxygen vacancy in a ZrO₂ matrix. Because nitrogen solubility into the ZrO₂ increases with an increase in heat-treatment temperature, leading to the formation of oxygen vacancy, the densification rate becomes higher. The present study thus shows evidence of nitrogen solubility into the ZrO₂ and its role on the densification behavior of 3Y-ZrO₂.     

Nonparametric approach for uncertainty-based multidisciplinary design optimization considering limited data

Uncertainty-based multidisciplinary design optimization (UMDO) has been widely acknowledged as an advanced methodology to address competing objectives and reliable constraints of complex systems by coupling relationship of disciplines involved in the system. UMDO process consists of three parts. Two parts are to define the system with uncertainty and to formulate the design optimization problem. The third part is to quantitatively analyze the uncertainty of the system output considering the uncertainty propagation in the multidiscipline analysis. One of the major issues in the UMDO research is that the uncertainty propagation makes uncertainty analysis difficult in the complex system. The conventional methods are based on the parametric approach could possibly cause the error when the parametric approach has ill-estimated distribution because data is often insufficient or limited. Therefore, it is required to develop a nonparametric approach to directly use data. In this work, the nonparametric approach for uncertainty-based multidisciplinary design optimization considering limited data is proposed. To handle limited data, three processes are also adopted. To verify the performance of the proposed method, mathematical and engineering examples are illustrated.     

Ultrastructural investigation of intact orbital implant surfaces using atomic force microscopy

This study examined the surface nanostructures of three orbital implants: nonporous poly(methyl methacrylate) (PMMA), porous aluminum oxide and porous polyethylene. The morphological characteristics of the orbital implants surfaces were observed by atomic force microscopy (AFM). The AFM topography, phase shift and deflection images of the intact implant samples were obtained. The surface of the nonporous PMMA implant showed severe scratches and debris. The surface of the aluminum oxide implant showed a porous structure with varying densities and sizes. The PMMA implant showed nodule nanostructures, 215.56 ± 52.34 nm in size, and the aluminum oxide implant showed crystal structures, 730.22 ± 341.02 nm in size. The nonporous PMMA implant showed the lowest roughness compared with other implant biomaterials, followed by the porous aluminum oxide implant. The porous polyethylene implant showed the highest roughness and severe surface irregularities. Overall, the surface roughness of orbital implants might be associated with the rate of complications and cell adhesion. SCANNING 33: 211–221, 2011. © 2011 Wiley Periodicals, Inc.     

Control of the leakage current in SrTiO3 films by acceptor doping

Stoichiometric SrTiO3 (STO) films doped with Fe or Cr were prepared by r.f. magnetron sputtering technique. The effects of Fe or Cr doping in the SrTiO3 films were studied on the leakage current property which was discussed by defect chemistry. The experimental results can be explained by a model in which oxygen vacancies are the key defects responsible for the leakage current. Acceptor doping, with a small concentration of Fe or Cr, has led to a substantial improvement to 10–9 order in the leakage current density. Above the concentration of 0.010.02 mol% Fe2O3, Cr2O3, however, as the concentration increased, the leakage current increased. These acceptors in Ti4+ site are expected to electrically compensate for donor species such as oxygen vacancies, thereby reducing the concentration of mobile carriers that contribute to electrical conduction. Consequently, acceptor doped STO films have been shown to be superior to undoped films for applications requiring high leakage resistance, such as dynamic random access memory capacitors. © 1998 Chapman & Hall     

Impact of a simple load balancing approach and an incentive-based scheme on MANET performance

Most reactive mobile ad hoc network (MANET) routing protocols such as AODV and DSR do not perform search for new routes until the network topology changes. But, low node mobility does not affect the MANET connectivity and the same routes may be used for a long time. This may cause concentration of traffic on few mobile stations (MSs), which results in congestion and hence longer end-to-end delay. In addition, continuous use of MSs may cause their battery power to get exhausted rapidly. Expiration of MS energy causes disruption of connections traversing through the MSs and could generate many simultaneous new routing requests. Therefore, we propose a load balancing approach called Simple Load Balancing Approach (SLBA), which can be transparently added to any current reactive routing protocol such as AODV and DSR. SLBA minimizes the traffic concentration by allowing each MS to drop RREQ or to give up packet forwarding depending on its own traffic load. Meanwhile, MSs may deliberately give up forwarding packets to save their own energy. For encouraging MSs to volunteer in forwarding packets, we introduce a reward scheme for packet forwarding, named Protocol-Independent Fairness Algorithm (PIFA). We compare the performance of AODV and DSR with and without SLBA and PIFA. Simulation results indicate that SLBA can distribute traffic very well and improve the MANET performance. PIFA is also observed to prevent MANET partitioning and any performance degradation due to selfish nodes.     

Energy- and Latency-Efficient Processing of Full-Text Searches on a Wireless Broadcast Stream

In wireless mobile computing environments, broadcasting is an effective and scalable technique to disseminate information to a massive number of clients, wherein the energy usage and latency are considered major concerns. This paper presents an indexing scheme for the energy- and latency-efficient processing of full-text searches over the wireless broadcast data stream. Although a lot of access methods and index structures have been proposed in the past for full-text searches, all of them are targeted for data in disk storage, not wireless broadcast channels. For full-text searches on a wireless broadcast stream, we firstly introduce a naive, inverted list-style indexing method, where inverted lists are placed in front of the data on the wireless channel. In order to reduce the latency overhead, we propose a two-level indexing method which adds another level of index structure to the basic inverted list-style index. In addition, we propose a replication strategy of the index list and index tree to further improve the latency performance. We analyze the performance of the proposed indexing scheme with respect to the latency and energy usage measures, and show the optimality of index replication. The correctness of the analysis is demonstrated through simulation experiments, and the effectiveness of the proposed scheme is shown by implementing a real wireless information delivery system.     

Two versions of architectures for dynamic implied addressing mode

The complexity of today’s embedded applications increases with various requirements such as execution time, code size or power consumption. To satisfy these requirements for performance, efficient instruction set design is one of the important issues because an instruction customized for specific applications can make better performance than multiple instructions in aspect of fast execution time, decrease of code size, and low power consumption. Limited encoding space, however, does not allow adding application specific and complex instructions freely to the instruction set architecture. To resolve this problem, conventional architectures increases free space for encoding by trimming excessive bits required beyond the fixed word length. This approach however shows severe weakness in terms of the complexity of compiler, code size and execution time. In this paper, we propose a new instruction encoding scheme based on the dynamic implied addressing mode (DIAM) to resolve limited encoding space and side-effect by trimming. We report our two versions of architectures to support our DIAM-based approach. In the first version, we use a special on-chip memory to store extra encoding information. In the second version, we replace the memory by a small on-chip buffer along with a special instruction. We also suggest a code generation algorithm to fully utilize DIAM. In our experiment, the architecture augmented with DIAM shows about 8% code size reduction and 18% speed up on average, as compared to the basic architecture without DIAM.