Analysis of corrosion resistance behavior of inhibitors in concrete using electrochemical techniques

Reinforced concrete is one of the most durable and cost effective construction materials. However, in high chloride environments, it can suffer from corrosion due to chloride induced breakdown of the normal passive layer protecting the reinforcing steel bars inside concrete. One means of protecting embedded steel reinforcement from chloride induced corrosion is the addition of corrosion inhibiting admixtures. In the present investigation, various inhibitors such as sodium nitrite, zinc oxide, mono ethanol amine, diethanolamine, and triethanol amine have been used in concrete in different percentages. Their effectiveness was then studied using various electrochemical techniques such as rapid chloride ion penetration test, open circuit potential measurement, electrochemical impedance measurement, potentiodynamic polarization measurement, and gravimetric weight loss measurement. The results thus obtained indicate that the addition of inhibitors enhances the corrosion resistance properties.     

A Review on InGaSb Growth under Microgravity and Terrestrial Conditions Towards Future Crystal Growth Project Using Chinese Recovery Satellite SJ-10

The paper reviewed the previous microgravity experiment using Chinese recovery satellite, the in-situ measurement of composition profile in the solution by X-ray penetration method and homogeneous growth of InGaSb by temperature freezing method under terrestrial condition for making clear the effect of gravity on the growth of InGaSb ternary alloy semiconductor crystals. The previous experimental results showed that the shape of solid/liquid interfaces and composition profile in the solution were significantly affected by gravity. Based on the previous microgravity experimental results, experimental conditions were investigated to grow homogeneous In _xGa _1?xSb with higher indium composition at Chinese recovery satellite SJ-10 in near future.     

Alkylation of phenol with 1-propanol and 2-propanol over catalysts derived from hydrotalcite-like anionic clays

Vapour phase alkylation of phenol with 1-propanol and 2-propanol was carried out in a fixed-bed flow reactor over calcined magnesium aluminium hydrotalcites (MgAl-CHT) with Mg/Al atomic ratios 2, 3 and 4. MgAl 3.0-CHT showed higher phenol conversion (80% at 350C, in the alkylation of phenol with 1-propanol. Both O- and C-alkylations were found to be taking place without any skeletal isomerization of the propyl moiety, suggesting an S_N2 type mechanism. Isomorphous substitution of Mg²⁺ by Cu²⁺ or Ni²⁺ in the hydrotalcite framework resulted in the predominant C-alkylation to give 2-n-propylphenol (60–70%) with nearly 40–50% phenol conversion at 350C. When 2-propanol was used as an alkylating agent, the phenol conversion decreased over all these catalysts and the alkylation was noticed exclusively at C-centers. Comparison of the product selectivity at constant phenol conversion revealed that CuAl 3.0-CHT is more selective for 2-n-propylphenol and 2-isopropylphenol in the reaction of phenol with 1-propanol and 2-propanol respectively. The participation of a pair of acid-base sites in the calcined hydrotalcites for the alkylation reaction has been proposed. The acid-base properties of these catalysts have been examined by the decomposition of cyclohexanol as a test reaction. Analysis of the spent catalysts revealed that Cu²⁺ in CuO gets reduced into Cu¹⁺ and metallic copper during the reaction in the case of CuAl-CHT, while MgO and NiO phases of MgAl-CHT and NiAl-CHT are retained.     

A 310/spl deg//3.6-dB K-band phaseshifter using paraelectric BST thin films

Ferro- and para-electric BaSrTiO/sub 3/ (/spl epsiv//sub r//spl sim/350 and tg/spl delta//spl sim/5/spl times/10/sup -2/ at 0V) thin films were deposited by low-cost sol-gel techniques. Subsequently, the films were used for fabricating coplanar waveguide phaseshifters using tunable finger-shaped capacitors. A 310/spl deg/ phaseshift was obtained at 30GHz and 35V of tuning voltage with 3.6dB of insertion loss yielding a figure of merit of 85/spl deg//dB.     

Control of attendance applied in higher education through mobile NFC technologies

This paper presents an improved attendance control system, required for continuous evaluation which has become compulsory following the Bologna Process. It provides a solution based on NFC technology and is based on a real project developed and pilot tested at the “Universidad Pontificia de Salamanca, Campus Madrid”.     

Optical,electrical, mechanical,and thermal properties and non-isothermal decomposition behavior of poly(vinyl alcohol)–ZnO nanocomposites

Iranian Polymer Journal - Poly(vinyl alcohol) (PVA) nanocomposites incorporated with ZnO nanofiller were prepared and examined to study the influence of nanofiller on their properties. All the...     

Analysis of Porcine Gelatin DNA in a Commercial Capsule Shell Using Real-Time Polymerase Chain Reaction for Halal Authentication

The presence of pig derivatives, such as porcine gelatin, in any products is prohibited to be consumed by Muslim community. This study is intended to develop a specific primer from mytochondrial D-loop capable of amplifying DNA from porcine gelatin in commercial capsule shells. Two pairs of primers designed from mitochondrial D-loop region were tested in order to confirm the primer specificity in gelatin sources (pork, beef, and catfish) and fresh tissue (pig, cows, goat, chickens, and rat). Primers were then used to perform sensitivity test of six dilution series (1000, 200, 100, 10, 5, and 1 pg/µL) of porcine gelatin and porcine capsule shell. The amplification was also performed on capsule shell from porcine-bovine mixture gelatin at 0, 10, 20, 30, 40, 50, and 100% concentration. The repeatability test was performed by measuring amplification capsule shells from porcine–bovine gelatin mixture. Real time polymerase chain reaction method using primers designed was further applied to analyze capsule shells purchased from markets. From two primers have been designed specifically, only primer D-Loop 108 (forward: 5’-CGT ATG CAA AAA ACC ACG CCA-3’; reverse: 5’-CTT ACT ATA GGG AGC TGC ATG-3’) had the capability to identify the presence of porcine DNA in fresh tissue and gelatin sources at optimum annealing temperature of 58.4ºC. Sensitivity of the developed method expressed as limit of detection of DNA in gelatin and capsule shells is 5 pg.