Role of Nd-Ni on structural,spectral and dielectric properties of strontium-barium based nano-sized X-type ferrites

The influence of neodymium and nickel substitution on structural and dielectric parameters was investigated in strontium-barium X-type hexagonal ferrites having composition SrBaCu_2?xNi_xNd_yFe_28?yO₄₆ (x = 0, 0.2, 0.4, 0.6, 0.8, 1 and y = 0, 0.02, 0.04, 0.06, 0.08, 0.1). Sol-gel method was employed for synthesizing these hexagonal ferrites. The XRD plots of all studied materials which were annealed at 1250 °C show single phase characteristics. Lattice parameter ‘c’ increased as a consequence of larger radius of rare earth ion (Nd³⁺) as compared to (Fe³⁺), while lattice parameter ‘a’ showed very small variation. The cell volume was obtained in the range 2508.32–2523.75 (ų). The inclusion of Nd-Ni also affected X-ray density, bulk density and porosity. The FTIR spectroscopy indicated the particular absorption peaks of hexagonal ferrites and it was performed in the range of 500–700 cm^?1. On account of Nd-Ni doping, the dielectric constant, dielectric loss and AC-conductivity showed decreasing trend. The occupancy of Nd³⁺ ions at octahedral site impedes the valence alternation of Fe³⁺; therefore there was decrease in dielectric permittivity. Ac conductivity has been decreased from 9.14 to 6.49 (Ω cm)^?1 at frequency of 2.7 GHz. The Cole-Cole plots of synthesized materials noticeably revealed grain boundary contribution. The appearance of single semi-circle in impedance Cole-Cole graphs confirms the exceptional role of grain boundaries in the conduction process. The considerably lower dielectric parameters of investigated nano X-type ferrites propose their feasibility for high-frequency applications (phase shifters, dielectric resonators, stealth technology etc).     

Catalase (CAT) Gene Family in Rapeseed (Brassica napus L.): Genome-Wide Analysis,Identification, and Expression Pattern in Response to Multiple Hormones and Abiotic Stress Conditions

Catalase (CAT) is an antioxidant enzyme expressed by the CAT gene family and exists in almost all aerobic organisms. Environmental stresses induce the generation of reactive oxygen species (ROS) that eventually hinder plant growth and development. The CAT enzyme translates the hydrogen peroxide (H₂O₂) to water (H₂O) and reduce the ROS levels to shelter the cells’ death. So far, the CAT gene family has not been reported in rapeseed (Brassica napus L.). Therefore, a genome-wide comprehensive analysis was conducted to classify the CAT genes in the rapeseed genome. The current study identified 14 BnCAT genes in the rapeseed genome. Based on phylogenetic and synteny analysis, the BnCATs belong to four groups (Groups I–IV). A gene structure and conserved motif analysis showed that Group I, Group II, and Group IV possess almost the same intron/exon pattern, and an equal number of motifs, while Group III contains diverse structures and contain 15 motifs. By analyzing the cis-elements in the promoters, we identified five hormone-correlated responsive elements and four stress-related responsive elements. Further, six putative bna-miRNAs were also identified, targeting three genes (BnCAT4, BnCAT6, and BnCAT8). Gene ontology (GO) enrichment analysis showed that the BnCAT genes were largely related to cellular organelles, ROS response, stimulus response, stress response, and antioxidant enzymes. Almost 10 BnCAT genes showed higher expression levels in different tissues, i.e., root, leaf, stem, and silique. The expression analysis showed that BnCAT1–BnCAT3 and BnCAT11–BnCAT13 were significantly upregulated by cold, salinity, abscisic acid (ABA), and gibberellic acid (GA) treatment, but not by drought and methyl jasmonate (MeJA). Notably, most of the genes were upregulated by waterlogging stress, except BnCAT6, BnCAT9, and BnCAT10. Our results opened new windows for future investigations and provided insights into the CAT family genes in rapeseed.     

An improved formalism for quantum computation based on geometric algebra—case study: Grover’s search algorithm

The Grover search algorithm is one of the two key algorithms in the field of quantum computing, and hence it is desirable to represent it in the simplest and most intuitive formalism possible. We show firstly, that Clifford’s geometric algebra, provides a significantly simpler representation than the conventional bra-ket notation, and secondly, that the basis defined by the states of maximum and minimum weight in the Grover search space, allows a simple visualization of the Grover search analogous to the precession of a spin- ${\frac{1}{2}}$ particle. Using this formalism we efficiently solve the exact search problem, as well as easily representing more general search situations. We do not claim the development of an improved algorithm, but show in a tutorial paper that geometric algebra provides extremely compact and elegant expressions with improved clarity for the Grover search algorithm. Being a key algorithm in quantum computing and one of the most studied, it forms an ideal basis for a tutorial on how to elucidate quantum operations in terms of geometric algebra—this is then of interest in extending the applicability of geometric algebra to more complicated problems in fields of quantum computing, quantum decision theory, and quantum information.     

A survey on search results diversification techniques

The quantity of information placed on the web has been greater than before and is increasing rapidly day by day. Searching through the huge amount of data and finding the most relevant and useful result set involves searching, ranking, and presenting the results. Most of the users probe into the top few results and neglect the rest. In order to increase user’s satisfaction, the presented result set should not only be relevant to the search topic, but should also present a variety of perspectives, that is, the results should be different from one another. The effectiveness of web search and the satisfaction of users can be enhanced through providing various results of a search query in a certain order of relevance and concern. The technique used to avoid presenting similar, though relevant, results to the user is known as a diversification of search results. This article presents a survey of the approaches used for search result diversification. To this end, this article not only provides a technical survey of existing diversification techniques, but also presents a taxonomy of diversification algorithms with respect to the types of search queries.     

A Jitter Injection Signal Generation and Extraction System for Embedded Test of High-Speed Data I/O

An instrument for on-chip measurement of transceiver transmission capability is described that is fully realizable in CMOS technology and embeddable within an SoC. The instrument can be used to inject and extract the timing and voltage information associated with signals in high-speed transceiver circuits that are commonly found in data communication applications. At the core of this work is the use of ΣΔ amplitude- and phase-encoding techniques to generate both the voltage and timing (phase) references, or strobes used for high-speed sampling. The same technique is also used for generating the test stimulant for the device-under-test.     

Copper substituted nickel ferrite nanoparticles anchored onto the graphene sheets as electrode materials for supercapacitors fabrication

Nickel ferrites with high theoretical capacitance value as compared to the other metal oxides have been applied as electrode material for energy storage devices i.e. batteries and supercapacitors. High tendency towards aggregation and less specific surface area make the metal oxides poor candidate for electrochemical applications. Therefore, the improvements in the electrochemical properties of nickel ferrites (NiFe₂O₄) are required. Here, we report the synthesis of graphene nano-sheets decorated with spherical copper substituted nickel ferrite nanoparticles for supercapacitors electrode fabrication. The copper substituted and unsubstituted NiFe₂O₄ nanoparticles were prepared via wet chemical co-precipitation route. Reduced graphene oxide (rGO) was prepared via well-known Hummer's method. After structural characterization of both ferrite (Ni_1-xCu_xFe₂O₄) nanoparticles and rGO, the ferrite particles were decorated onto the graphene sheets to obtain Ni_1-xCu_xFe₂O₄@rGO nanocomposites. The confirmation of preparation of these nanocomposites was confirmed by scanning electron microscopy (SEM). The electrochemical measurements of nanoparticles and their nanocomposites (Ni_0.9Cu_0.1Fe₂O₄@rGO) confirmed that the nanocomposites due to highly conductive nature and relatively high surface area showed better capacitive behavior as compared to bare nanoparticles. This enhanced electrochemical energy storage properties of nanocomposites were attributed to the graphene and also supported by electrical (I-V) measurements. The cyclic stability experiments results showed ~65% capacitance retention after 1000 cycles. However this retention was enhanced from 65% to 75% for the copper substituted nanoparticles (Ni_0.9Cu_0.1Fe₂O₄) and 65–85% for graphene based composites. All this data suggest that these nanoparticles and their composites can be utilized for supercapacitors electrodes fabrication.     

Mechanisms of molecular and structural interactions between lentil and quinoa proteins in aqueous solutions induced by pH recycling

There has been a growing interest in plant proteins due to their beneficial health effects, low cost and variety of applications in food industries. The low solubility of lentil proteins (LPs) is one of the significant factors that limit their use in food applications. Quinoa proteins (QPs), which have high water solubility, were combined with LPs at pH 12 to generate LP-QP complexes to generate pH-based soluble protein compounds. The LP-QP complexes demonstrated a large surface charge with an increase solubilisation of the protein complexes by more than 85%, together with resistance to protein aggregation. The combination of LPs to QPs led to a significant increase (P < 0.05) in unique tertiary and secondary protein structures as determined by the protein–protein interaction (PPI) technique involving pH recycling. Interactions between LPs and QPs affected the surface morphology of the protein complexes formed. Electrostatic interactions, hydrophobic forces and hydrogen bonding were indicated to play key roles in the PPIs. The capacity of pH cycling to illustrate the above protein interactions shows that this is a robust approach for assessing the emulsion and foaming properties of food proteins.     

Physicochemical properties of liquid natural rubber bearing fluoro groups for hydrophobic surfaces

The modification of liquid natural rubber (LNR) has attracted interests among chemists as it brings improvements to several of its properties and widens its application to various fields. LNR can be modified into fluorinated LNR (F-LNR) which is of interest to industries due to its remarkable properties, including low surface energies, high thermal stabilities, together with its significant hydrophobic characters. In this work, a new route to prepare fluorinated rubber was presented. Hydroxylated LNR (OH-LNR) was initially synthesized in good yield via oxidation in the presence of tungsten complex catalyst and acetic acid with hydrogen peroxide as an oxidant. The optimum hydroxyl content of 57.0% was obtained within 6 h reaction time at 90 °C. In the second step, the esterification of OH-LNR using pentadecafluorooctanoyl chloride (PDFOC) under mild conditions was conducted, leading to LNR bearing fluoro groups in the side chain of LNR (F-LNR). ATR-FTIR spectroscopy was used to elucidate the structure and determine any changes in the functional groups that may have been induced during the reaction. ¹H NMR spectroscopy was employed to reveal that a high fluorine content of 48.6% was obtained using 3:1 molar ratio of OH-LNR:PDFOC for 8 h at 50 °C. The microstructure of F-LNR was further analyzed using ¹⁹F NMR and ¹³C NMR spectroscopies, and the results confirmed the presence of fluorine in LNR. Thermogravimetric analyses also indicated that the modification improved thermal stability of the LNR. Contact angle measurements were also conducted to verify the hydrophobicity of the fluorinated rubber and the results obtained showed that F-LNR exhibited higher hydrophobicity than LNR.     

Exploiting the Plackett–Burman design to examine the formulation effect on curing characteristics of oil palm ash-filled acrylonitrile butadiene rubber compounds

The present paper is focused on exploiting Plackett–Burman design to examine the formulation effect of various chemical components content on the curing characteristics of oil palm ash (OPA)-filled acrylonitrile butadiene rubber (NBR) compound. The filled-NBR compound was prepared by conventional laboratory-sized two roll mill and cured using sulfuric system. Six independent variables such as content of zinc oxide, stearic acid, N-isopropyl-N′-phenyl-p-phenylenediamine, N-cyclohexyl-2-benzothiazole sulfenamide (CBS), sulfur, and even OPA filler were carried out to screen their significant effect on the curing characteristics of NBR compound. The scorch time, optimal cure time, minimum torque, and maximum torque were selected as a response. Results showed that the scorch time and the optimal cure time were significantly affected by CBS, whereas the minimum torque and maximum torque were significantly affected by OPA and sulfur, respectively, within the studied range. Among the chemical components under study, zinc oxide and stearic acid had the least effect on the curing properties of NBR compound. Analysis of variances for all factorial models demonstrated that the model was significant with P value <0.05 while the regularity (R ²) of all models was greater than 0.9. Lastly, the optimal chemical concentrations were predicted to acquire the optimal condition of the curing system for filled-NBR compound.     

A Novel Sprague-Dawley Rat Model Presents Improved NASH/NAFLD Symptoms with PEG Coated Vitexin Liposomes

Chronic liver disease (CLD) is a global threat to the human population, with manifestations resulting from alcohol-related liver disease (ALD) and non-alcohol fatty liver disease (NAFLD). NAFLD, if not treated, may progress to non-alcoholic steatohepatitis (NASH). Furthermore, inflammation leads to liver fibrosis, cirrhosis, and hepatocellular carcinoma. Vitexin, a natural flavonoid, has been recently reported for inhibiting NAFLD. It is a lipogenesis inhibitor and activates lipolysis and fatty acid oxidation. In addition, owing to its antioxidant properties, it appeared as a hepatoprotective candidate. However, it exhibits low bioavailability and low efficacy due to its hydrophobic nature. A novel rat model for liver cirrhosis was developed by CCL4/Urethane co-administration. Vitexin encapsulated liposomes were synthesized by the ‘thin-film hydration’ method. Polyethylene glycol (PEG) was coated on liposomes to enhance stability and stealth effect. The diseased rats were then treated with vitexin and PEGylated vitexin liposomes, administered intravenously and orally. Results ascertained the liposomal encapsulation of vitexin and subsequent PEG coating to be a substantial strategy for treating liver cirrhosis through oral drug delivery.