Long-term follow-up (8 to 17 years) after thromboexclusion operation for thoracic aortic aneurysms

Forty-eight Russell's viper bite patients (40 males, 8 females), age ranging from 16-76 years were studied. Out of 48 patients, 14 were found to have a prolonged whole blood clotting time test (WBCT) (i.e. incoagulable blood) (Group 1); 23 had a normal WBCT (i.e. clotted blood) (Group II); and 11 patients had a normal WBCT on admission which changed to non-clotting during the clinical course (Group III). Four patients from group I developed hypotension and 2 expired. The serum cortisol concentration (mean +/- SEM) on admission among groups I and II were 639 +/- 45.6 and 424 +/- 33.2 nmol/l respectively. The blood cortisol level in 35 subjects (controls) were 370.7 +/- 17.7 nmol/l (mean +/- SEM). There was a significant rise of blood cortisol in patients with incoagulable blood when compared to controls at the time of admission to the hospital (p < 0.05); but there was no significant difference among those patients with clotted blood. A much higher mean serum cortisol level was observed in 4 patients with hypotension as compared to 10 patients without shock. These patients with hypotension according to our study shown to have a favorable response to steroid therapy and eventually recovered. Whether higher doses of steroid in addition to antiserum confer extra benefit in suppressing nonspecific venom effects on the pituitary and/or adrenal is not known.     

Melatonin inhibits naloxone-induced luteinizing hormone release in ovariectomized estrogen-primed rats

The present study aimed to examine the effect of melatonin on naloxone-induced luteinizing hormone (LH) secretion in ovariectomized estrogen-primed rats. A single intracerebroventricular (i.c.v.) injection of naloxone (mu opioid receptor blocker, 15 micrograms) or an intravenous (i.v.) injection of LH-releasing hormone (LHRH, 50 ng/kg) elicited a transient and significant increase in the serum LH concentration within 10 min. While an i.c.v. injection of 100 ng melatonin by itself did not change the basal LH release, it almost completely inhibited the naloxone-induced LH release. Melatonin (10 ng) also significantly reduced the effect of naloxone. However, an i.c.v. injection of 100 ng melatonin did not affect the LHRH-induced LH release. In separate experiments, the effect of melatonin on naloxone-induced pulsatile LH secretion was studied in estrogen-treated rats. A continuous i.v. infusion of naloxone (20 mg/kg/h) induced LH pulses in rats treated i.c.v. with saline. An i.c.v. administration of 100 ng melatonin, which by itself did not affect basal LH secretion, significantly reduced the frequency, but not the amplitude, of LH pulses induced by the naloxone infusion. These results show that melatonin has a suprapituitary site of action to inhibit naloxone-induced LH release, and suggest that melatonin has an effect in inhibiting the activity of the hypothalamic LHRH pulse generator, either directly or indirectly, in female rats.     

Flow aggregated, traffic driven label mapping in label-switchingnetworks

Label-switching technology enables high performance and flexible layer-3 packet forwarding based on the fixed-length label information that is mapped to the layer-3 packet stream. A label-switching router (LSR) forwards layer-3 packets based on their layer-3 address information or their label information that is mapped to the layer-3 address information. Two label-mapping policies have been proposed. One is traffic driven mapping, where the label is mapped for a layer-3 packet stream of each host-pair according to the actual packet arrival. The other is topology driven mapping, where the label is mapped in advance for a layer-3 packet stream toward the same destination network, regardless of actual packet arrival to the LSR. This paper evaluates the required number of labels under each of these two label-mapping policies using real backbone traffic traces. The evaluation shows that both label-mapping policies require a large number of labels. In order to reduce the required number of labels, we propose a label-mapping policy that is a combination of the two label-mapping policies above. This is traffic-driven label mapping for the packet stream toward the same destination network. The evaluation shows that the proposed label-mapping policy requires only about one-tenth as many labels as the traffic-driven label mapping for the host-pair packet stream and the topology-driven label mapping for the destination-network packet stream     

Crystallographic, Thermoelectric, and Mechanical Properties of Polycrystalline Ba8Al x Si46−x Clathrates

The Al content dependence of crystallographic, thermoelectric, and mechanical properties is reported for polycrystalline Ba₈Al _x Si_46?x (nominal x = 15 to 17) clathrates prepared by combining arc melting and spark plasma sintering methods. The elastic constants and the coefficient of thermal expansion (CTE), which are also important properties for designing thermoelectric devices, are presented. Powder x-ray diffraction, scanning electron microscopy, and energy-dispersive x-ray spectroscopy (EDX) indicate that the type I clathrate is the major phase of the samples but impurity phases (mainly BaAl₂Si₂, Si, and Al) are included in the samples with high Al contents. The actual Al content x determined by EDX ranges from approximately 14 to 15. The absolute value of the Seebeck coefficient increases and the electrical conductivity decreases as the Al content increases. The changes in Seebeck coefficient and electrical conductivity are explained in terms of the dependence of the carrier concentration on the Al content. The elastic constants and the CTE of the samples depend weakly on the Al content. Some of the properties are compared with reported data of single crystals of Ba₈Al₁₆Ge₃₀, Ba₈Ga₁₆Ge₃₀, Sr₈Ga₁₆Ge₃₀, silicon, and germanium as standard references. The effective mass, Hall carrier mobility, and lattice thermal conductivity, which govern the transport properties, are determined to be ~ 2.4m ₀, ~ 7 cm² V^?1 s^?1, and ~ 1.3 W m^?1 K^?1, respectively, for actual Al content x of about 14.77. The thermoelectric figure of merit ZT is estimated to be about 0.35 at 900 K for actual Al content x of about 14.77.     

船用柴油机NOx等有害排放气体的评价及处理研究--燃料喷射系统对乳化燃料在船用柴油机上使用的影响及脱硝装置的适用性

对原试验用柴油机的燃料喷射系统进行了改造。改造后的燃料喷射系统不仅可降低 NOx 的排放 ,而且使高加水率乳化燃料的使用成为可能。但另一方面 ,在低负荷时 ,使用乳化燃料不但不能获得预期的降低 NOx 排放效果 ,反而使其它有害排放增加。所以 ,也对降低 NOx 排放方法之一的脱硝装置进行了探讨 ,对其在船用柴油机上的适用性进行了试验 ,并获得了较好的效果     

Psychological Stress Exacerbates Inflammation of the Ileum via the Corticotropin-Releasing Hormone-Mast Cell Axis in a Mouse Model of Eosinophilic Enteritis

The effects of psychological stress on eosinophilic gastrointestinal disorders have not been elucidated. This study investigated the effects of psychological stress in a mouse model of eosinophilic enteritis (EoN). BALB/c mice were treated with ovalbumin (OVA) to create an EoN model and subjected to either water avoidance stress (WAS) or sham stress (SS). Microscopic inflammation, eosinophil and mast cell counts, mRNA expression, and protein levels of type 2 helper T cell (Th2) cytokines in the ileum were compared between groups. We evaluated ex vivo intestinal permeability using an Ussing chamber. A corticotropin-releasing hormone type 1 receptor (CRH-R1) antagonist was administered before WAS, and its effects were analyzed. WAS significantly increased diarrhea occurrence and, eosinophil and mast cell counts, and decreased the villus/crypt ratio compared to those in the SS group. The mRNA expression of CRH, interleukin IL-4, IL-5, IL-13, eotaxin-1, and mast cell tryptase β2 significantly increased, and the protein levels of IL-5, IL-13, and OVA-specific immunoglobulin E (IgE) also significantly increased in the WAS group. Moreover, WAS significantly increased the intestinal permeability. The CRH-R1 antagonist significantly inhibited all changes induced by WAS. Psychological stress exacerbated ileal inflammation via the CRH-mast cell axis in an EoN mouse model.     

Single-chip microcomputer control of the inverter by the magneticflux control PWM method [machine control]

Single-chip microcomputer control of a pulsewidth-modulated (PWM) inverter for motor drive applications is presented. The PWM pattern generation and the system control of the inverter are achieved by software of the 8-bit single-chip microcomputer. The single-chip microcomputer has a low processing speed and small memory capacity, disadvantages that can be overcome by the magnetic flux control PWM method. The PWM pattern is generated every 90 μs. The memory capacity of the PWM look-up table is less than 2 kbytes. Experimental results show that the motor performances are the same as that of the multichip triangular-sinewave PWM inverter     

A self-converging atomized mist spray device using surface acoustic wave

This paper presents an innovative versatile method aiming at rapid fabrication of a master for polydimethylsiloxane (PDMS) molding. This technology is relying on liquid dielectrophoresis electromechanical microfluidic transduction for programmable ultraviolet (UV) glue manipulation. It enables formation of the master in a tailor-made approach, avoiding the need of micromachined structures unlike in conventional methods. The principle is simple: UV glue, while in liquid phase, is actuated onto an array of electrodes patterned on a Si substrate and cured afterward by UV exposure. The silicon chip and the glue microstructures defined atop of it then play the role of a master for PDMS molding. The glue microstructures’ shape is hemispherical which is of high interest for many microfluidic applications. This concept is assessed and validated with two different PDMS chip replica designs, both of them illustrating representative applications in continuous microfluidic: a T-junction design for inflow droplet generation and a “Quake” type valve. Lastly, this protocol has shown to be recyclable since the UV glue microstructures once formed can be easily removed by immersion in an acetone bath, such as the chip is reset and can be reprogrammed afterward to build another glue channels geometry.