Transmittance and cathodoluminescence of AlN ceramics sintered with Ca3Al2O6 as sintering additive

Aluminum nitride ceramics were prepared by sintering with 0–4.8 mass% of Ca₃Al₂O₆ (C₃A) as a sintering additive. The transmittance in the range of 260–550 nm increased with increasing amount of C₃A. The cathodoluminescence intensity attributed to oxygen-induced defects decreased with increasing amount of C₃A. From the results, the increase of the transmittance in the range of 260–550 nm was considered to be related to the decrease of the oxygen-induced defect density.     

Superconductivity in the tetragonal phase of La1.9Bi0.1CuO4+δ annealed under high oxygen pressure

We have investigated the relation between the crystal structure and superconductivity in La_1.9Bi_0.1CuO_4+δ , in which the phase separation observed in La₂CuO_4+δ is suppressed. A phase diagram in theT?δ plane is given for La_1.9Bi_0.1CuO_4+δ with excess oxygen. For very smallδ values, the crystal structure is orthorhombic, and an orthorhombic-tetragonal phase transition occurs markedly atδ ～ 0.03 in the measured temperature range between 13 and 293 K. Superconductivity is observed in the range of 0.04<δ<0.11. This is clear evidence thathigh-T _c superconductivity also appears in the tetragonal phase.     

Separation of di- and tripeptides with solvent extraction and an emulsion liquid membrane

The extraction equilibria of various di- and tripeptides with di-2-ethylhexylphosphoric acid (D2EHPA) were studied at low pH values. The complex extracted to organic phase consisted of one molecule of peptide and two molecules of D2EHPA dimer. The extraction constants of the peptides correlated well with the distribution coefficients of peptides between 1-octanol and water, which is a measure of hydrophobicity. The permeation rates of peptides through an emulsion liquid membrane were examined by using D2EHPA as a carrier, Span 80 as an emulsifier and kerosene as a diluent. The rates varied considerably with peptide type, depending upon the hydrophobicity.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

Pulsed KrF excimer laser annealing of silicon solar cell

The pulsed KrF excimer laser annealing of silicon films for solar cell with EBEP-CVD and LP-CVD was studied theoretically and experimentally. Three-dimensional thermal diffusion equation for microcrystalline and amorphous silicon was solved by using the finite difference methods. The results of our heat-flow simulation of laser re-crystallization in a laser irradiation with 50 ns pulse duration almost agree with the experimental results in re-crystallization depth of 0.7 μm for microcrystalline silicon (EBEP-CVD) and 0.4 μm for amorphous silicon (LP-CVD) in a single pulse excimer laser annealing.     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

A reconfigurable VLSI-based double-lens tracking camera

Watching and tracking an object while seeing a much wider view is one of advantages of the eye system. We proposed and developed a tracking camera system that mimics the eyes by using double-lens modules. In the system, a wide view is captured through the wide-lens module, while the target in it is tracked and magnified through the telescopic lens module. Electronic circuits for tracking control are implemented onto the reconfigurable VLSI or FPGA in order to embed the parallelism in the tracking algorithm into the hardware. A successfully developed FPGA-based prototype performs high-speed tracking at the video-rate. This work was present in part at the 12th International Symposium on Artificial Life and Robotics, Oita, Japan, January 25–27, 2007     

Augmentation by phthalimides of phorbol ester-induced expression of tumor necrosis factor alpha message

N(alpha)-Phthalimidoglutarimide (thalidomide), 2-(2,6-diisopropylphenyl)-1H-isoindole-1,3-dione (PP-33) and its 4,5,6,7-tetrafluoro derivative (FPP-33) augmented 12-O-tetradecanoylphorbol 13-acetate-induced production by human leukemia HL-60 cells of both tumor necrosis factor alpha (TNF-alpha) mRNA and secreted TNF-alpha protein. Intracellular TNF-alpha protein production was increased to a lesser extent.     

Extracellular matrix of opacified anterior capsule after endocapsular cataract surgery

BACKGROUND: We determined the types and distribution of glycosaminoglycans (GAGs) and collagens, in anterior capsular opacification after endocapsular phacoemulsification and aspiration (ECPEA) and intraocular lens implantation. METHODS: Opacified anterior capsules were removed from human eyes after ECPEA. Immunohistochemical staining was performed to determine GAGs with monoclonal antibodies to chondroitin, chondroitin-4-sulfate (C4S), chondroitin-6-sulfate (C6S), dermatan sulfate (DS), and keratan sulfate (KS); collagens with monoclonal antibodies to types I, II, and III collagens; and cellular characteristics with monoclonal antibodies to vimentin, desmin, alpha-smooth muscle actin, and cytokeratin. Decorin mRNA and type I collagen mRNA were detected by in situ hybridization. RESULTS: In the capsules, the C6S, DS, KS, and types I and III collagens were similar to the chemical components found at the adhesion site of the anterior and posterior capsules after extracapsular cataract extraction, and cellular components contained vimentin, desmin, alpha-smooth muscle actin, cytokeratin, decorin mRNA, and type I collagen mRNA. CONCLUSIONS: The GAGs and collagens in opacified anterior capsule after ECPEA were similar to those found during wound healing, although KS is present in normal anterior segment tissue during development and only in the cornea postnatally. These chemical components may be produced by myofibroblast-like cells presumably transformed from lens epithelial cells.