Superconductivity in the tetragonal phase of La1.9Bi0.1CuO4+δ annealed under high oxygen pressure

We have investigated the relation between the crystal structure and superconductivity in La_1.9Bi_0.1CuO_4+δ , in which the phase separation observed in La₂CuO_4+δ is suppressed. A phase diagram in theT?δ plane is given for La_1.9Bi_0.1CuO_4+δ with excess oxygen. For very smallδ values, the crystal structure is orthorhombic, and an orthorhombic-tetragonal phase transition occurs markedly atδ ～ 0.03 in the measured temperature range between 13 and 293 K. Superconductivity is observed in the range of 0.04<δ<0.11. This is clear evidence thathigh-T _c superconductivity also appears in the tetragonal phase.     

Separation of di- and tripeptides with solvent extraction and an emulsion liquid membrane

The extraction equilibria of various di- and tripeptides with di-2-ethylhexylphosphoric acid (D2EHPA) were studied at low pH values. The complex extracted to organic phase consisted of one molecule of peptide and two molecules of D2EHPA dimer. The extraction constants of the peptides correlated well with the distribution coefficients of peptides between 1-octanol and water, which is a measure of hydrophobicity. The permeation rates of peptides through an emulsion liquid membrane were examined by using D2EHPA as a carrier, Span 80 as an emulsifier and kerosene as a diluent. The rates varied considerably with peptide type, depending upon the hydrophobicity.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

Permeation of Zidovudine and Probenecid from Oily Bases Containing Alcohols Through Rat Skin

Permeation of zidovudine (3'-azido-3'-deoxythymidine, AZT) and probenecid from oily bases containing an alcohol through rat skin was examined. Isopropyl myristate (IPM), as an oily vehicle, showed a penetration enhancing effect for AZT and probenecid. Ethanol, n-propanol, and n-butanol were used as additives in IPM and were examined for their own permeation and the enhancing effect on the permeation of AZT and probenecid. The skin permeation of AZT and probenecid from IPM was enhanced by addition of the alcohol in IPM. The degree of the enhancement was decreased with increasing lipophilicity of the alcohol used. me permeation rate of the drug from those systems was shown to be governed by penetration-enhancing effects of the oily base and alcohol, and the penetration of the alcohol itself through the skin.     

Semiconductor photonic functional devices

Recent advances in semiconductor photonic functional devices based on the nonlinearities of laser diodes (LDs) are reviewed. Because the current research is driven primarily by the needs of optical fiber communications systems, most devices are made of InGaAsP and operate at wavelengths of between 1.3 and 1.55 μm, the wavelength window in which optical fibers have their most favorable properties. Minimum loss is at 1.55 μm, and zero dispersion is at 1.3 μm. AlGaAs devices operating at around 0.85 μm have also been reported. Two types of optical bistability-absorptive and dispersive-are explained, and devices based on them are described. Switching characteristics of bistable devices are discussed. Tunable wavelength converters and filters are also examined. Applications to all-optical communication and to optical switching systems are considered. Directions for future development are indicated     

Head-to-head polymers: 33. Bromination of cis-1,4-polybutadiene to head-to-head poly(vinyl bromide)

Cis-1,4-polybutadiene (PB) in a 0.5% solution of a solvent mixture of dichloromethane and 1,2-dibromoethane or tetrahydrofuran was quantitatively brominated with elemental bromine at 0°C under careful exclusion of oxygen to head-to-head poly(vinyl bromide). Partially brominated PB has a structure of random or block sequences of butadiene units in the polymer depending on the bromination solvent but shows no stereospecificity in the CHBrCHBr-dyads. Partially brominated PB with block structure showed a microphase-separated morphology over a wide range of composition. Microphase separation is less pronounced for the more random structure of butadiene units. I.r and ¹³C n.m.r. spectroscopy of the partially brominated PB was used to follow the progress of the bromination.     

The heat transfer and pressure drop characteristics of finned tube banks in forced convection (effects of fin height on pressure drop characteristics)

In recent years the requirement for the reduction of energy consumption has been increasing to solve the problems of global warming and the shortage of petroleum resources. For example, in the power generation field, as thermal power generation occupied 60% of the power generation demand, considerable improvement of the thermal efficiency is required. This paper describes the pressure drop characteristics of finned tube banks used for heat exchangers in thermal power generation that were clarified by testing serrated finned tube banks with different fin heights for improved heat transfer and conventional spiral finned tube banks with different fin heights, and an equation to predict pressure drop which is necessary for the heat exchanger design is proposed. © 2006 Wiley Periodicals, Inc. Heat Trans Asian Res, 35(3): 179–193, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20112     

Enhancing heat transfer ability of drag reducing surfactant solutions with static mixers and honeycombs

Solutions containing drag reducing additives also show reduced heat transfer which limits their use in district heating and cooling recirculation systems where heat exchange is critical. In this study, static mixers A and B and honeycombs were installed at the entrance to a heat exchanger to break the solution microstructure temporarily and thereby enhancing their heat transfer ability when passing through the heat exchanger. The effectiveness of the destructive devices in enhancing the heat transfer ability of drag reducing cationic and mixed zwitterionic/anionic surfactant solutions was investigated together with the microstructure recovery time and pressure drop penalty paid for the heat transfer enhancement.     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

A reconfigurable VLSI-based double-lens tracking camera

Watching and tracking an object while seeing a much wider view is one of advantages of the eye system. We proposed and developed a tracking camera system that mimics the eyes by using double-lens modules. In the system, a wide view is captured through the wide-lens module, while the target in it is tracked and magnified through the telescopic lens module. Electronic circuits for tracking control are implemented onto the reconfigurable VLSI or FPGA in order to embed the parallelism in the tracking algorithm into the hardware. A successfully developed FPGA-based prototype performs high-speed tracking at the video-rate. This work was present in part at the 12th International Symposium on Artificial Life and Robotics, Oita, Japan, January 25–27, 2007