High-performance self-aligned SiGeC HBT with selectively grown Si/sub 1-x-y/Ge/sub x/C/sub y/ base by UHV/CVD

Si/sub 1-x-y/Ge/sub x/C/sub y/ selective epitaxial growth (SEG) was performed by cold-wall, ultrahigh-vacuum chemical vapor deposition, and the effects of incorporating C on the crystallinity of Si/sub 1-x-y/Ge/sub x/C/sub y/ layers and the performance of a self-aligned SiGeC heterojunction bipolar transistor (HBT) were evaluated. A Si/sub 1-x-y/Ge/sub x/C/sub y/ layer with good crystallinity was obtained by optimizing the growth conditions. Device performance was significantly improved by incorporating C, as a result of applying Si/sub 1-x-y/Ge/sub x/C/sub y/ SEG to form the base of a self-aligned HBT. Fluctuations in device performance were suppressed by alleviating the lattice strain. Furthermore, since the B out diffusion could be suppressed by incorporating C, the cutoff frequency was able to be increased with almost the same base resistance. A maximum oscillation frequency of 174 GHz and an emitter coupled logic gate-delay time of 5.65 ps were obtained at a C content of 0.4%, which shows promise for future ultrahigh-speed communication systems.     

Photoinduced Formation of Small Gold Particles in Silica Gels

AuCl⁻₄ ions in sol-gel-derived silica gels (Au/silica gels) were photoreduced by ultraviolet light irradiation at room temperature. In the presence of ethylene glycol in the silica gels, small Au particles were effectively formed by the irradiation. When the storage temperature of the gels was increased in the dark after the irradiation, the surface plas-mon resonance absorption peak of the Au particles was shifted to longer wavelengths, indicating that the Au particles became large. At a storage temperature below 9°C, Au particles could not be observed in the silica gels. The apparent activation energy of Au particle formation was estimated to be 17. 3 kcal·tmol⁻¹.     

Static-state feedback control of discrete-event systems underpartial observation

Studies static-state feedback control of discrete-event systems under partial observation. The authors present a necessary and sufficient condition for the existence of a static-state feedback controller. A static controller is a special case of a dynamic controller studied by Kumar et al. The authors' condition, however, has computational advantage in contrast to those obtained by Kumar et al. The authors also present a necessary and sufficient condition under which the modular feedback synthesis is possible     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

Phase diagrams calculated for Fe-rich Fe-Si-Co and Fe-Si-Al ordering alloy systems

Theoretical analysis based on the calculation of phase diagrams was employed for Fe-Si-Co and Fe-Si-Al ordering systems to clarify the necessity for the occurrence of phase separation in Fe-base ternary ordering systems. The free energy of Fe-base ternary ordering alloys where B2 and D0₃ ordered structures are formed is evaluated statistically using a pairwise interaction approximation up to second nearest neighbours, taking into account not only the atomic interaction but also the magnetic interaction, based on the Bragg-Williams-Gorsky model. The calculated phase diagrams are consistent with the experimentally obtained ones. The phase diagram calculation in this work is useful to predict the equilibrium states of the ternary ordering systems. The phase separation in ordering alloys is caused by the contribution of excess free energies due to ordering. The influences of ferromagnetism on the two-phase regions are also demonstrated.