Photoinduced Formation of Small Gold Particles in Silica Gels

AuCl⁻₄ ions in sol-gel-derived silica gels (Au/silica gels) were photoreduced by ultraviolet light irradiation at room temperature. In the presence of ethylene glycol in the silica gels, small Au particles were effectively formed by the irradiation. When the storage temperature of the gels was increased in the dark after the irradiation, the surface plas-mon resonance absorption peak of the Au particles was shifted to longer wavelengths, indicating that the Au particles became large. At a storage temperature below 9°C, Au particles could not be observed in the silica gels. The apparent activation energy of Au particle formation was estimated to be 17. 3 kcal·tmol⁻¹.     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

An on-chip active decoupling circuit to suppress crosstalk in deep-submicron CMOS mixed-signal SoCs

A decoupling circuit using an operational amplifier is proposed to suppress substrate crosstalk in mixed-signal system-on-chip (SoC) devices. It overcomes the parasitic inductance problem of on-chip capacitor decoupling. The effect of the proposed decoupling circuit is not limited by parasitic fine impedance. A 0.13-/spl mu/m CMOS test chip showed that substrate noise at frequencies from 40 MHz to 1 GHz was incrementally suppressed by sequentially activating three of the proposed circuits in parallel. The power dissipation of each circuit was 3.3 mW at a 1.0-V power supply. The test chip measurement showed that the proposed decoupling reduced crosstalk by 31% at 200 MHz, whereas it was reduced by 4.4% with capacitor decoupling. This 7:1 ratio, or 17 dB, corresponds to the gain of the opamp. Design of the opamp and its feedback loop for active decoupling is simple, making the opamp useful for SoC applications.     

Phase diagrams calculated for Fe-rich Fe-Si-Co and Fe-Si-Al ordering alloy systems

Theoretical analysis based on the calculation of phase diagrams was employed for Fe-Si-Co and Fe-Si-Al ordering systems to clarify the necessity for the occurrence of phase separation in Fe-base ternary ordering systems. The free energy of Fe-base ternary ordering alloys where B2 and D0₃ ordered structures are formed is evaluated statistically using a pairwise interaction approximation up to second nearest neighbours, taking into account not only the atomic interaction but also the magnetic interaction, based on the Bragg-Williams-Gorsky model. The calculated phase diagrams are consistent with the experimentally obtained ones. The phase diagram calculation in this work is useful to predict the equilibrium states of the ternary ordering systems. The phase separation in ordering alloys is caused by the contribution of excess free energies due to ordering. The influences of ferromagnetism on the two-phase regions are also demonstrated.     

Measurements of distribution of self-bias potential on an RF-plane electrode in plasma etching devices

The self-bias potential (V_dc) induced on an RF-powdered electrode (153 mm Ø) in a plasma is measured using electrical probes which are buried in, de-insulated from, and RF-connected to the electrode. The configuration of the probes allows to study the distribution of V_dc discretely on the electrode. The potential is homogeneous in the absence of external magnetic field. In the presence of a homogeneous magnetic field parallel to the electrode, it is reduced and a monotonous gradient takes place in its distribution due to the plasma shift induced by E × B drift. When the magnetic field is rotated along the axis of the RF-electrode at a frequency less than 50 Hz, the distribution, which is almost identical to the one in a static field, rotates with the magnetic field. On the coordinate system rotating with the magnetic field, the probes are regarded to be rotating. The potential distribution is obtained as a continuous function of the azimuthal angle. Thus the rotation of the field provides information for the experimental interpolation.     

Heat transfer enhancement by Marangoni convection in the NH3–H2O absorption process

The objectives of this paper are to quantify the effect of Marangini convection on the absorption performance for the ammonia–water absorption process, and to visualize Marangoni convection that is induced by adding a heat transfer additive, n-octanol. A real-time single-wavelength holographic interferometer is used for the visualization using a He–Ne gas laser. The interface temperature is always the highest due to the absorption heat release near the interface. It was found that the thermal boundary layer (TBL) increased faster than the diffusion boundary layer (DBL), and the DBL thickness increased by adding the heat transfer additive. At 5 s after absorption started, the DBL thickness for 5 mass% NH₃ without and with the heat transfer additive was 3.0 and 4.5 mm, respectively. Marangoni convection was observed near the interface only in the cases with heat transfer additive. The Marangoni convection was very strong just after the absorption started and it weakened as time elapsed. It was concluded that the absorption performance could be improved by increasing the absorption driving potential (x_vb−x_vi) and by increasing the heat transfer additive concentration. The absorption heat transfer was enhanced as high as 3.0–4.6 times by adding the heat transfer additive that generated Marangoni convection.     

Functional activation of cerebral blood flow abolished by scopolamine is reversed by cognitive enhancers associated with cholinesterase inhibition: a positron emission tomography study in unanesthetized monkeys

The effects of somatosensory stimulation on the regional cerebral blood flow (rCBF) response were studied in unanesthetized monkeys before and after treatment with scopolamine and three cognitive enhancers (physostigmine, E2020 and tacrine) that inhibit cholinesterase, using 15O-labeled water and high-resolution positron emission tomography. Under control conditions, somatosensory stimulation induced a significant increase in the rCBF response in the contralateral somatosensory cortex of monkey brain. Intravenous administration of scopolamine (50 microg/kg) resulted in abolishment of the rCBF response to stimulation. The rCBF response abolished by pretreatment with scopolamine was recovered by administration of physostigmine (1 or 10 microg/kg), E2020 (10 or 100 microg/kg) or tacrine (100 or 1000 microg/kg), in a dose-dependent manner. The effect of E2020 (100 microg/kg) on the rCBF response lasted for >4 hr, whereas the effects of physostigmine and tacrine were of shorter duration. These findings suggest that these compounds reversed the scopolamine-abolished rCBF response to somatosensory stimulation via enhancement of cholinergic neurotransmission, which was mainly induced by cholinesterase inhibition.