Oxidation of doped europium in BaMgAl10O17 by annealing studied by x‐ray‐absorption fine‐structure measurements

Abstract— We studied the influence of annealing in air on doped europium in BaMgAl₁₀O₁₇ by performing x‐ray absorption fine‐structure measurements. We determined the oxidation of doped divalent europium by annealing in air at over 500°C. The interatomic distance between the europium and the surrounding oxygen atoms was compressed by oxidation. It also appears that the oxidation process of europium is determined by the diffusion of oxygen into BaMgAl₁₀O₁₇.     

Magnet Safety Assessment for ITER

The ITER magnet system consists of structurally linked sets of toroidal (TF) and poloidal (PF) field coils, central solenoid (CS), and various support structures. The coils are superconducting, force flow Helium cooled with a Kapton-Glass-Epoxy multilayer insulation system. The stored magnetic energy is about 100GJ in the TF system and 20GJ in the PF-CS. Coils and structure are maintained at 4 K by enclosing them in a vacuum cryostat. The cryostat, comprising an outer envelope to the magnets, forms most of the second radioactivity confinement barrier. The inner primary barrier is formed by the vacuum vessel, its ports and their extensions. To keep the machine size within acceptable bounds, it is essential that the magnets are in close proximity to both of the nuclear confinement barriers. The objective of the magnet design is that, although local damage to one of the barriers may occur in very exceptional circumstances, large scale magnet structural or thermal failure leading to simultaneous breaching of both barriers is not credible. Magnet accidents fall into three categories: thermal (which includes arcing arising from insulation failure and local overheating due to discharge failure in the event of a superconductor quench), structural (which includes component mechanical failure arising from material inadequacies, design errors and exceptional force patterns arising from coil shorts or control failures), and fluid (Helium release due to cooling line failure). After a preliminary survey to select initial faults conceivable within the present design, these faults are systematically analyzed to provide an assessment of the damage potential. The results of this damage assessment together with an assessment of the reliability of the monitoring and protective systems, shows that the magnets can operate with the required safety condition.     

A 300-MHz 25-/spl mu/A/Mb-leakage on-chip SRAM module featuring process-variation immunity and low-leakage-active mode for mobile-phone application processor

An on-chip 1-Mb SRAM suitable for embedding in the application processor used in mobile cellular phones was developed. This SRAM supports three operating modes - high-speed active mode, low-leakage low-speed active mode, and standby mode - and uses a subdivisional power-line control (SPC) scheme. The combination of three operating modes and the SPC scheme realizes low-power operation under actual usage conditions. It operates at 300 MHz, with leakage of 25 /spl mu/A/Mb in standby mode, and 50 /spl mu/A/Mb at the low-leakage active mode. This SRAM also uses a self-bias write scheme that decreases of minimum operating voltage by about 100 mV.     

A flow simulation for the epoxy casting process using a 3D finite‐element method

A three‐dimensional flow simulation for epoxy casting has been developed. A control‐volume‐based finite‐element method is employed, containing a conservative upwind formulation for the advection terms and equal order interpolations for all variables. This simulation predicts the non‐isothermal and reactive flow behavior under the gravity. The viscosity and reaction‐rate parameters were estimated by using a dynamic rheometer and a differential scanning calorimeter. The predicted flow front advancement and temperature profiles in the calculation domain similar to the mold cavity were in close agreement with the corresponding experimental results. The variation of epoxy surface configuration with flow rate also showed the same tendency between the prediction and the experiment. This simulation seems to be applicable not only to the epoxy casting, but also to other molding processes of various thermoset resins. POLYM. ENG. SCI. 45:364–374, 2005. © 2005 Society of Plastics Engineers.     

Hydrothermal corrosion of magnesiapartially-stabilized zirconia

Changes in the phase compositions and microstructures of magnesia-partially-stabilized zirconia (Mg-PSZ) were studied in water at 80–300 °C, 1 m HCl solutions at 80–140 °C and 1 m CH₃COOH-CH₃COONa buffer solutions at pH 3 and 80–140 °C for 10–40 days. The tetragonal to monoclinic phase transformation and the degradation of the fracture strength occurred in water above 200 °C. On the other hand, although no noticeable tetragonal to monoclinic phase transformation proceeded in 1 m HCl solutions and 1 m CH₃COOH-CH₃-COONa buffer solutions at pH 3 below 140 °C, the fracture strength of Mg-PSZ greatly degraded. The dissolution of Mg²⁺ ion was observed in water above 200 °C and in 1 m HCl solutions above 80 °C.     

Amyloid beta-protein deposition in the leptomeninges and cerebral cortex

To further investigate the process of amyloid beta-protein (Abeta) deposition, we determined, using sensitive enzyme immunoassays, the levels of Abeta40 and Abeta42 (Abetas) in the soluble and insoluble fractions of the leptomeninges (containing arachnoid mater and leptomeningeal vessels) and cerebral cortices from elderly control subjects showing various stages of Abeta deposition and from patients affected by Alzheimer's disease (AD). In both locations, insoluble Abeta levels were higher by orders of magnitude than soluble Abeta levels. Soluble Abeta levels in cortices were much lower than those in leptomeninges. In insoluble Abeta in the cortex, Abeta42 was by far the predominant species, and Abeta42 in AD cortices was characterized by the highest degree of modifications in the amino terminus. In contrast, this Abeta42 predominance was not observed in insoluble Abeta in the leptomeninges, which were found to be able to accumulate Abetas to an extent similar to that in the cortex, on a weight basis. The levels of insoluble Abeta in the leptomeninges or cortex generally correlated with the degree of cerebral amyloid angiopathy or the abundance of senile plaque, respectively. However, the presence of plaque-free cortical samples showing significant levels of insoluble Abeta42 suggests that biochemically detectable Abeta accumulation precedes immunocytochemically detectable Abeta deposition in the cortex.     

Exchangeability of actin in cardiac myocytes and fibroblasts as determined by fluorescence photobleaching recovery

OBJECTIVE: To assess whether hypertension is a risk factor for hysterectomy performed for benign diseases. METHODS: Self-report questionnaires were collected from 77% of 2301 Danish women aged 30, 40, 50, or 60 years selected at random in 1982 for a prevalence study. Information about cardiovascular diseases, hypertension, use of medicine, weight and dieting history, life-styles, psychologic factors, gynecologic history (including history of hysterectomy), and social background were recorded. Weight, height, and blood pressure were measured. In an incidence study, the cohort was followed during 1982-1990 via central registers to assess the incidence of hysterectomy. Logistic and Cox regressions were used to analyze data. RESULTS: In the prevalence study, history of hypertension partly explained the relation between hysterectomy and cardiovascular diseases. In the incidence study, history of hypertension and use of diuretics were significant risk factors for hysterectomy. After confounder control, use of diuretics was explained by weight-related variables, and hypertension was a risk factor for hysterectomy in educated women (adjusted relative risk [RR] 2.88, 95% confidence interval [CI] 1.07, 7.76) and in women with weight fluctuations (adjusted RR 3.31, 95% CI 1.35, 8.14). Weight cycling and lack of education remained significant risk factors for hysterectomy in women with and without hypertension, respectively. CONCLUSION: History of hypertension, weight cycling, and lack of education are closely related risk factors for premenopausal hysterectomy. These three risk factors contribute to women undergoing hysterectomy having an increased risk for cardiovascular diseases. We proposed that hypertension might be a plausible biological cause of menorrhagia and an indication for hysterectomy.     

Two geometrical isomers of linoleic acid: Improved total syntheses

The total syntheses of 9(Z),12(E)- and 9(E),12(Z)-octadecadienoic acids have been carried out. A useful intermediate in both syntheses, 8-bromo-octanoic acid, recently has become available from commercial sources. This compound has been used to expedite the preparation of these isomers. The remaining carbon atoms were derived from propargyl alcohol along with either 1-heptyne or acetylene and 1-bromopentane. Because the overall yield for each sequence was roughly 15% and there were no extraordinary reaction conditions in any of the synthetic steps, the compounds could be prepared readily in multiple gram quantities. The syntheses of the two compounds were supported by data from a variety of spectroscopic techniques.