Scattering and absorption by thin metal wires in rectangularwaveguide-FDTD simulation and physical experiments

The high-frequency internal impedance model of a round ohmic conductor is incorporated into the subcell thin-wire formulation of the finite-difference time-domain method to model the microwave properties of metal wires. For magnetic metals, such as steel, an effective conductivity is introduced to account for the increase in ohmic loss due to the high-frequency permeability. Physical experiments with half-wave resonant copper- and steel-wire inclusions, supported by a dielectric slab in a standard S-band rectangular waveguide, support the formulation     

Predicting postlaryngectomy voice outcome in an era of primary tracheoesophageal fistulization: a retrospective evaluation

The aim of this study was to investigate the effect of the absence of elongate spermatids (ES) from the rat seminiferous epithelium on the quantitative secretion and synthesis of the three major Sertoli cell secretory proteins--SGP-1, SGP-2 and CP-2. Seminiferous tubules (ST) were isolated (a) from normal 28-day-old rats, in which the most mature germ cell type is the round spermatid, (b) from normal adult rats at stages IX-XIV of the spermatogenic cycle, i.e. after spermiation, or at stages I-V and VI-VIII, when ES are still attached to the Sertoli cell, and (c) at stages VI-VIII from normal adult rats and from rats treated with methoxyacetic acid (MAA) in order to specifically deplete ES at these stages. Two-dimensional SDS PAGE combined with computerized image analysis was used to analyse 35S-methionine-labelled intracellular and secreted proteins. In the case of SGP-1 and SGP-2, almost all of the protein synthesized by ST was secreted. The total amount of both SGP-1 and CP-2 secreted by unstaged ST from immature rats was significantly lower than that secreted by unstaged ST from adult rats. The total amount of SGP-1 and CP-2 secreted by adult ST at stages IX-XIV of the spermatogenic cycle also declined dramatically compared to ST at earlier stages. The proportion of the total CP-2 synthesized by ST which was secreted also declined in all situations in which ES were absent from the seminiferous epithelium. The synthesis of only SGP-2 was changed by ES depletion from ST at stages VI-VIII, which was almost doubled compared to synthesis of this protein by ST from control rats. Our results suggest strongly that the secretion of SGP-1 and SGP-2 is via the constitutive pathway, and that regulation of these two proteins by ES is at the level of protein synthesis. In contrast, the regulation of CP-2 by ES is predominantly at the level of secretion, suggesting that this protein is secreted via a regulated pathway. Our findings add to the evidence showing that ES play a major role in the regulation of Sertoli cell function.     

Analysis of volatiles evolved during high-temperature treatment of thermally stable polymers. I. Nitrogen-containing acetylene-terminated resin

Cured samples of a nitrogen-containing acetylene-terminated resin, N,N′-(1,3-phenylene-dimethylidene)bis(3-ethynylaniline), have been heated at 10°C/min up to 900°C in a pyroprobe attached to a gas chromatograph/mass spectrometer (GC/MS). Analysis of the volatiles evolved during heating identified both gases and higher boiling compounds. The major higher boiling compounds are benzene, toluene, xylene, aniline, benzonitrile, m-methylaniline, and m-methylbenzonitrile; the gases include ammonia, methane, and traces of carbon dioxide. Correlations between sample temperature and the evolution of each of these compounds have been made. The onset of all volatile formation occurs between 450 and 500°C. The higher boiling volatiles peak, then end by approximately 700°C, while the gases peak then fall off but are still being evolved at 900°C. Average weight loss measurements of 13.6% at 700°C and 15.7% at 900°C agree with previously published thermogravimetric analysis (TGA) data. © 1993 John Wiley & Sons, Inc.     

ATMOSPHERIC DEPOSITION OF CHEMICAL SPECIES TO POLAR SNOW

Particles and gases can deposit from the atmosphere to polar snow by several mechanisms. Dry deposition can be considered to consist of three steps: aerodynamic transport from the free atmosphere to the viscous sublayer near the surface, boundary layer transport across the sublayer, and interactions with the surface. The particle dry deposition mass flux is dominated by the largest particles present in a size distribution. Wet deposition includes in-cloud and below-cloud scavenging, where the former refers to uptake of particles during nucleation of cloudwater as well as scavenging of particles and gases by existing droplets and ice crystals. Of all the wet deposition mechanisms, nucleation scavenging is often the most important mechanism for particles in the polar regions. Finally, incorporation of particles and gases into fog droplets and subsequent settling of the fog to the snow surface can be an important removal process in regions of frequent fog. For Summit, Greenland, the total deposition of MSA, SO₄^2-, Na⁺, K⁺, and Ca²⁺ during May 24-July 13, 1993 was dominated by wet deposition: this mechanism accounted for an average of 62% of the total deposition for these species. Fog and dry deposition accounted for 21% and 17% of the total, respectively. These results suggest that all three mechanisms may need to be considered when estimating total deposition of certain chemical species to polar snow.     

Integrated carbon nanotube field emission differential amplifier: Modeling and measurement of the common-mode rejection ratio

A novel integrated vacuum field emission (VFE) differential amplifier (diff-amp) utilizing carbon nanotube (CNT) emitters has been developed. A dual-mask microfabrication process was employed to achieve a VFE diff-amp by integrating identical CNT VFE transistors with built-in split gates and integrated anodes. The identical pair of triode amplifiers was well-matched in their device characteristics. The measured ac small-signal characteristics of the diff-amp showed a common-mode-rejection ratio (CMRR) of ~ 320 (~ 50 dB). The proposed analytical model of the CMRR was verified to be in good agreement with the experimental data. The successful implementation of the CNT diff-amp demonstrates a new way to achieve temperature and radiation tolerant VFE integrated microelectronics.     

Rat hepatocyte plasma membrane acyl:CoA synthetase activity

The presence of long chain acyl:CoA synthetases in mammalian microsomes and mitochondria has been established previously by Aas (Biochim. Biophys. Acta 231, 32–47 [1971]). The presence of a plasma membrane-associated enzyme was investigated in rat hepatocyte plasma membranes, where an enzyme exhibiting high activity and with a preferred substrate of 18-carbon chain length was discovered. The results are consistent with the presence of a single enzyme. The effect of the degree of unsaturation of the fatty acid substrates was not as pronounced as that arising from the length of the carbon chain. The pattern of substrate preference of the enzyme was ω3 polyenoic fatty acids >ω6 polyenoic acids >ω9 monoenoic acids > saturated acids. This may relate to the similar substrate preference pattern exhibited by the fatty acyl desaturase enzymes. The role played by long chain acyl:CoA synthetase in hepatocyte metabolism is uncertain, but it may relate to the incorporation of polyenoic fatty acids from the circulation into cell membranes and the trapping of other fatty acids within the cell for further metabolism.     

Termites live in a material world: exploration of their ability to differentiate between food sources.

Drywood termites are able to assess wood size using vibratory signals, although the exact mechanism behind this assessment ability is not known. Important vibratory characteristics such as the modal frequencies of a wooden block depend on its geometry and boundary conditions; however, they are also dependent on the material characteristics of the block, such as mass, density and internal damping. We report here on choice experiments that tested the ability of the drywood termite Cryptotermes secundus to assess wooden block size using a solid wooden block paired with a composite block, the latter made of either wood and aluminium or wood and rubber. Each composite block was constructed to match mass or low-frequency vibratory modes (i.e. fundamental frequency) of the solid wooden block. The termites always chose the blocks with more wood; they moved to the solid wooden blocks usually within a day and then tunnelled further into the solid wooden block by the end of the experiment. Termites offered composite blocks of wood and rubber matched for mass were the slowest to show a preference for the solid wooden block and this preference was the least definitive of any treatment, which indicated that mass and/or damping may play a role in food assessment. This result clearly shows that the termites were not fooled by composite blocks matched for mass or frequency, which implies that they probably employ more than a single simple measure in their food assessment strategy. This implies a degree of sophistication in their ability to assess their environment hitherto unknown. The potential importance of alternative features in the vibrational signals is discussed.     

Directly Compressible Acetaminophen Compositions Prepared by Fluidized-Bed Granulation

Polyvinylpyrrolidone (PVP) in aqueous solution was used as a binding agent in a fluidized-bed system to agglomerate acetaminophen powder into directly compressible granules. It was found that a minimal amount of 5% w/w PVP in a concentration of 7.5% w/v or less was needed to produce granules with an acceptable flow and the corresponding tablets having enough hardness without capping. There was a strong correlation between the time for 80% dissolved (T₈₀) and the logarithm of granule volume-surface mean diameter. A directly compressible acetaminophen composition to manufacture tablets having a T₈₀ value less than 30 min can be prepared simply by adding an appropriate amount of disintegrant (crospovidone, sodium starch glycolate, or pregelatinized starch) to the agglomerated granules.