Fabrication of lotus-type porous carbon steel by the continuous zone melting method and its mechanical properties

A lotus-type porous carbon steel with cylindrical pores was fabricated by the continuous zone melting method in a pressurized mixture of hydrogen and helium gases. The porosity increases with increasing partial pressure of the hydrogen gas, while the pore diameter remains almost constant, independent of the pressure. The ultimate tensile strength of the specimen with cylindrical pores parallel to the tensile direction is lower than the estimated value, assuming that the strength is decreased in proportion to the decrease of the cross-sectional area of the specimen, while the yield strength is higher than the estimated value. The compressive yield strength is also higher than the estimated value. The increase in yield strength is considered to be due to precipitation strengthening. The tensile strength is increased by quenching and tempering, while the elongation decreases. Such mechanical properties are discussed in terms of the microstructural analysis.     

Simulation of Strength Distribution in Ground Ceramics by Incorporating Residual Stress Effect

Strength of ground ceramics may be affected by residual stress as well as surface flaws induced by grinding. Strength prediction for ground ceramics is convenient for mechanical design of ceramic components. In this article, a numerical procedure based on fracture mechanics was proposed to estimate strength distribution of ground ceramics by considering grinding-induced residual stress. Bending strength and residual stress of ground ceramics were measured for three grinding-conditions. By comparison of simulated results with experimental ones, it was revealed that strength characteristics in experiments were well simulated by using the proposed procedure.     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

The molecular interaction of Fas and FAP-1. A tripeptide blocker of human Fas interaction with FAP-1 promotes Fas-induced apoptosis

Fas (APO-1/CD95), which is a member of the tumor necrosis factor receptor superfamily, is a cell surface receptor that induces apoptosis. A protein tyrosine phosphatase, Fas-associated phosphatase-1 (FAP-1), that was previously identified as a Fas binding protein interacts with the C-terminal 15 amino acids of the regulatory domain of the Fas receptor. To identify the minimal region of the Fas C-terminal necessary for binding to FAP-1, we employed an in vitro inhibition assay of Fas/FAP-1 binding using a series of synthetic peptides as well as a screen of random peptide libraries by the yeast two-hybrid system. The results showed that the C-terminal three amino acids (SLV) of human Fas were necessary and sufficient for its interaction with the third PDZ (GLGF) domain of FAP-1. Furthermore, the direct cytoplasmic microinjection of this tripeptide (Ac-SLV) resulted in the induction of Fas-mediated apoptosis in a colon cancer cell line that expresses both Fas and FAP-1. Since t(S/T)X(V/L/I) motifs in the C termini of several other receptors have been shown to interact with PDZ domain in signal transducing molecules, this may represent a general motif for protein-protein interactions with important biological functions.     

Feedback control of decoupled bending and torsional vibrations of flexible beams

In this article, we consider a flexible beam with a rigid body, of which the bending vibration and the torsional vibration are decoupled. Therefore we need two control motors to suppress the vibrations. Each set of dynamic equations is treated in the form of an appropriate Hilbert space. A stabilizing feedback control law of each rotation motor will be established on the basis of modal analysis. A set of experiments has been carried out, and the results demonstrate the effectiveness of the dynamic model and the proposed control law. © 1994 John Wiley & Sons, Inc.     

High-efficiency finishing process for metal mold by large-area electron beam irradiation

A new finishing process for metal molds by large-area electron beam (EB) irradiation is proposed in this study. In the large-area EB irradiation equipment used here, an EB with high-energy density is irradiated without focusing the beam, and so the EB with a maximum diameter of 60 mm can be used for melting or evaporating metal surface instantly. Experimental results show that the surface roughness decreases from 6 μmRz to less than 1 μmRz in just a few minutes under proper machining conditions. The corrosion resistance of metal mold surface also could be greatly improved by large-area EB irradiation. Furthermore, the surface roughness of tilting surface close to 90° could be well improved. Therefore, large-area EB irradiation method has a possibility to become a high-efficiency finishing process for metal molds.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

Nonlinear influence on PM-AM conversion measurement of groupvelocity dispersion in optical fibres

The authors propose a method for measuring the group velocity dispersion, including the polarity, of optical fibre by using a single wavelength light source. The method is based on the interplay between phase modulation-amplitude modulation (PM-AM) conversion and self-phase modulation (SPM)     

Mutations can cause large changes in the conformation of a denatured protein

Deletion of 13 amino acids from the carboxyl terminus of staphylococcal nuclease (WTSNase delta) results in a denatured, partially unfolded molecule that lacks significant persistent secondary structure but is relatively compact and monomeric under physiological conditions [Shortle & Meeker (1989) Biochemistry 28, 936-944; Flanagan et al. (1992) Proc. Natl. Acad. Sci. U.S.A. 89, 748-752]. Because of these and other properties of the SNase delta polypeptide, it is a useful model system for investigating the conformation of the denatured state of a protein without using extreme temperature or solvent conditions. Moreover, since the modification is a carboxyl-terminal deletion, SNase delta may also resemble a transient state of the polypeptide chain as it emerges from a ribosome prior to its folding. In the present study, we have examined the sizes and conformations of mutated forms of SNase delta, using small-angle X-ray scattering and circular dichroism spectroscopy. Seven mutated forms were studied: four with single substitutions, two with double substitutions, and one triple substitution. When present in the full-length SNase, each of these mutated forms exhibited unusual behavior upon solvent or thermal denaturation. In the case of the truncated form (SNase delta), the small-angle scattering curves of the mutated forms fall into two classes: one resembling the scattering curve of compact native nuclease and the other having features consistent with those expected for an expanded coil-like polymer. In contrast, the scattering curve of WT SNase delta exhibits features intermediate between those observed for globular proteins and random polymers. The amino acid substitutions that gave rise to compact, native-like versions of SNase delta were all of the m--type (m-substitutions are predicted to decrease the size of the denatured state). Those which gave rise to versions of SNase delta that were more extended and coil-like than WT SNase delta were of the m+ type (m+ substitutions are predicted to increase the size of the denatured state). Estimates of the residual secondary structure present in WT SNase delta, as well as both the m+ and m-substituted versions of SNase delta, as determined by CD, suggest that the formation of secondary structure and compaction of the polypeptide chain occur concurrently. Our results show that single amino acid substitutions can radically alter the conformational distribution of a partially condensed polypeptide chain.(ABSTRACT TRUNCATED AT 400 WORDS)     

Fully methylated oriC with negative superhelicity forms an oriC-membrane complex before initiation of chromosome replication

In an in vitro assay, the oriC DNA has been shown to bind to the outer membrane fraction only when it is hemimethylated (G.B. Ogden et al., Cell, 54, 127-135,1988). In this report, however, we demonstrated that a significant amount of the oriC DNA was recovered from the cells just before initiation with the oriC DNA being fully methylated. Formation of this preinitiation oriC-membrane complex and following initiation of chromosome replication were strongly inhibited by novobiocin, a DNA gyrase B subunit inhibitor, which reduced the superhelicity of the reporter plasmid in the cells. On the other hand, both reactions proceeded in the presence of nalidixic acid, a DNA gyrase A subunit inhibitor, which did not have the effect of reducing the superhelicity. These results suggest that the negative superhelicity of the DNA is required for preinitiation oriC-membrane complex formation and following initiation event of replication.