Fabrication of lotus-type porous carbon steel by the continuous zone melting method and its mechanical properties

A lotus-type porous carbon steel with cylindrical pores was fabricated by the continuous zone melting method in a pressurized mixture of hydrogen and helium gases. The porosity increases with increasing partial pressure of the hydrogen gas, while the pore diameter remains almost constant, independent of the pressure. The ultimate tensile strength of the specimen with cylindrical pores parallel to the tensile direction is lower than the estimated value, assuming that the strength is decreased in proportion to the decrease of the cross-sectional area of the specimen, while the yield strength is higher than the estimated value. The compressive yield strength is also higher than the estimated value. The increase in yield strength is considered to be due to precipitation strengthening. The tensile strength is increased by quenching and tempering, while the elongation decreases. Such mechanical properties are discussed in terms of the microstructural analysis.     

Characterization of localized states in thin PrBa2Cu3O7−x tunnel barriers

Characteristic power-law dependence of junction conductance on temperature was confirmed at low temperatures fora,b-axis oriented Au/PrBa₂Cu₃O_7−x /YBa₂Cu₃O_7−y junctions with a PrBa₂Cu₃O_7−x layer thinner than 30 nm, indicating that current transport via a small number of localized states was predominant. The radius and the density of the localized states were estimated to be 1.1 nm and 5.0x10¹⁹ eV⁻¹ cm⁻³, respectively. Transport measurement at 1.7 K in a magnetic field of up to 6 T revealed no indication of on-site Coulomb repulsion of electrons in the localized states. These results support the possibility of resonant tunneling of Cooper pairs in superconductor-insulator-superconductor junctions with a thin PrBa₂Cu₃O_7−x tunnel barrier.     

Simulation of Strength Distribution in Ground Ceramics by Incorporating Residual Stress Effect

Strength of ground ceramics may be affected by residual stress as well as surface flaws induced by grinding. Strength prediction for ground ceramics is convenient for mechanical design of ceramic components. In this article, a numerical procedure based on fracture mechanics was proposed to estimate strength distribution of ground ceramics by considering grinding-induced residual stress. Bending strength and residual stress of ground ceramics were measured for three grinding-conditions. By comparison of simulated results with experimental ones, it was revealed that strength characteristics in experiments were well simulated by using the proposed procedure.     

Right atrial contractile performance in patients with myocardial infarction

To evaluate right atrial (RA) contractile performance in patients with myocardial infarction, we validated a cineangiographic method of RA volume measurement, and investigated RA volume change in 'normal' individuals and patients with a previous myocardial infarction. Sixteen silicone rubber RA casts made from human cadavers were filmed in the postero-anterior and left lateral projections. The cast volumes calculated following Simpson's rule were in good agreement with those measured by water replacement (r = 0.992, P < 0.01). At cardiac catheterization, biplane RA cineangiography was performed in 19 'normal' individuals (N group), in 14 patients with a previous antero-septal infarction (AMI group) and in seven patients with a previous inferior infarction (IMI group). The RA volume-time curve was constructed at 20-40 ms intervals for one cardiac cycle. RA volume at the beginning of the atrial contraction (RAVd), which was defined as the 'preload' of the RA, tended to be larger in both the AMI and IMI groups compared with 'normal' individuals. The RA ejection volume was significantly larger in both the AMI (18.4 +/- 2.1 ml.m-2, P < 0.01) and IMI groups (19.4 +/- 2.8, P < 0.01) than in the N group (14.5 +/- 1.9), even for a comparable level of RAVd (range from 26 to 36 ml.m-2) (18.6 +/- 2.1, P < 0.01, 18.2 +/- 2.0, P < 0.01, 14.7 +/- 1.9, respectively). These results suggest that RA contraction increases in patients with myocardial infarction by increasing both the 'preload' and 'contractility' of the RA.     

Feedback control of decoupled bending and torsional vibrations of flexible beams

In this article, we consider a flexible beam with a rigid body, of which the bending vibration and the torsional vibration are decoupled. Therefore we need two control motors to suppress the vibrations. Each set of dynamic equations is treated in the form of an appropriate Hilbert space. A stabilizing feedback control law of each rotation motor will be established on the basis of modal analysis. A set of experiments has been carried out, and the results demonstrate the effectiveness of the dynamic model and the proposed control law. © 1994 John Wiley & Sons, Inc.     

High-efficiency finishing process for metal mold by large-area electron beam irradiation

A new finishing process for metal molds by large-area electron beam (EB) irradiation is proposed in this study. In the large-area EB irradiation equipment used here, an EB with high-energy density is irradiated without focusing the beam, and so the EB with a maximum diameter of 60 mm can be used for melting or evaporating metal surface instantly. Experimental results show that the surface roughness decreases from 6 μmRz to less than 1 μmRz in just a few minutes under proper machining conditions. The corrosion resistance of metal mold surface also could be greatly improved by large-area EB irradiation. Furthermore, the surface roughness of tilting surface close to 90° could be well improved. Therefore, large-area EB irradiation method has a possibility to become a high-efficiency finishing process for metal molds.     

Forensic toxicological application of TOXI-LAB screening for biological specimens in autopsy cases and emergency cares

Using the TOXI-LAB drug detection system, emergency toxicological screening was performed in autopsy cases and emergency cares. In 280 autopsy cases (male 182 cases 65%, female 98 cases 35%), drug positive cases were 28 cases of male (15%) and 24 cases of female (24%). The age groups which showed higher rate of drug positive cases were 10s-40s in male (approximately 20%) and 20s in female (67%). In the 238 cases of emergency care (male 129 cases 54%, female 104 cases 44%, unknown 5 cases 2%), drugs were positive in 29 cases of male (22%) and 32 cases of female (30%). The age groups which showed relatively higher rate of drug positive cases were 40s in male (64%), 20s (71%) and 30s (89%) in female. Forty-four different kinds of drugs were detected in TOXI-LAB positive cases, in which the psychotropic drugs and the sedative-hypnotic drugs amounted to approximately 70%. Methamphetamine and amphetamine, which were the main abused drugs showing a socially important problem, were detected in total 15 cases. TOXI-LAB was based on thin-layer chromatography (TLC); however, from the extraction to development, coloration and detection have been accelerated (about 50 min) and simplified. In order to perform the forensic toxicological practice in Japan, it becomes more useful that TOXI-LAB is used in autopsy cases and emergency cares, if the drugs, which have caused poisoning cares in Japan, are added to TOXI-LAB. The present study describes the advantage and problem of TOXI-LAB drug detection system through demonstrating the practical cases of autopsy cases and emergency cares.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

Correlates and prognosis in relation to intellectual dysfunction in a community-residing elderly population

To estimate the risk factors for intellectual dysfunction and examine its prognosis in a community-residing (non-institutionalized) elderly population, a randomly selected sample of 1,473 elderly people aged 65 years and over living in S city, Osaka Prefecture, was studied in October 1992, and data were obtained from 1,383, a response rate of 93.9%. A cohort of 1,383 was followed for 42 months and follow-up was completed for 1,300 (94.0%). The main results were as follows: 1) The prevalence of intellectual dysfunction did not differ significantly between sexes, and there was an increasing prevalence of intellectual dysfunction with age in both sexes. The prevalence of severe intellectual dysfunction was found to increase highly at age 85 and over. 2) By univariate analysis, odds ratios for age older than 75 years, low Activities of Daily Living (ADL), urinary and fecal incontinence, and no participation in social activities were significantly higher than 1 in any level of mild, moderate, and severe intellectual dysfunction. In the multivariate analysis using logistic regression, age older than 75 years and urinary and fecal incontinence showed significant higher odds ratios than 1 for severe intellectual dysfunction, and low ADL and treatment for hypertension also showed significant higher odds ratios than 1 for moderate intellectual dysfunction. 3) From analysis using the Kaplan-Meier method, the cumulative survival rates decreased with a decline in intellectual functioning in both age groups of 65-74 and 75 years and older. 4) Application of the Cox proportional hazards model resulted in adjusted hazard ratio for severe intellectual dysfunction of 1.79 (95% confidence interval, 1.02-3.12), controlling for other factors such as sex, age, general health status, incontinence and social activities.