Power swing analysis in a future metropolitan electric power system on a contingent trip of cryogenic high-power cables

A cryogenic power cable is expected to be capable of carrying bulk power as a main transmission line in a future metropolitan electric power system. It is important to establish a strategy of how to sustain power supply when such a highly densified power supply route trips from the network due to contingency. It is proposed here that the bulk power transmitted by the cryogenic cable could be distributed into the parallel conventional transmission lines by suitable circuit breaker operations in the system. In this process, power-flow routes are forced to be changed with a remarkable modification in the system configuration. In this paper, the power swings associated with the large power-flow change following contingent faults are analyzed by means of a transient network analyzer. It is found that the proposed system modification could be realized without any harmful power swing if the parameters in generators as well as in control devices have conventional magnitudes. It is shown also by simulations that the margin to occurrence in an unstable power swing is left sufficient even if the parameters deviate somewhat from the present magnitudes.     

EXPANSION AND STRESS RELAXATION OF EXPRESSED CAKE

Expansion and stress relaxation of expressed cake are discussed.

The expansion process of expressed cake after release of load is very similar to consolidation of solidndashliquid mixtures, although a liquid flow in the expansion process is opposite in direction to that in consolidalion. This process can be analyzed well by use of the Terzaghi Voigt combined model. It is shown that the rate of primary deformation in expansion is much smaller than that in consolidation under the same change in compressive pressure. It is also found that the ratio of secondary deformation to total deformation in expansion is much larger than that in consolidation.

Stress relaxation of expressed cake, which is observed when expression is stopped before attaining an equilibrium compression state of a material, can be explained by use of a consolidation and expansion theory. In the relaxation process, local expansion appears near the drainage surface while local consolndash idation appears near the center of the cake. The equilibrium cake stress is uniquely determined by the average consolidation ratio when the expression is interrupted.     

Numerical analyses of high‐beta spherical tokamaks with varied elongation

The effect of plasma elongation on the second‐stable spherical tokamak (ST) was numerically studied using the experimentally measured pressure and current profiles of ultrahigh‐beta STs. The maximum beta of ST over 50% was obtained in the TS‐3 ST/CT experiment by applying an external toroidal field to an FRC. It was found that the marginal beta for the ballooning instability increased with the plasma elongation κ of ST. The elongated STs with κ > 2 have the magnetic shear (S)–pressure gradient (α) profiles located in the second‐stable regime for the ballooning mode and the stability margin increased with κ. The close relation between the absolute minimum‐B profile and the second stability was documented. The effect of elongation on maximum beta was observed to saturate when κ exceed 3, indicating that the optimized elongation for high‐beta STs is located around 2 < κ < 3. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 155(4): 1–6, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20132     

D.s.c. investigation of the states of water in poly(vinyl alcohol-co-itaconic acid) membranes

The state of water in water-swollen poly(vinyl alcohol-co-itaconic acid) membranes, having various water contents from 0.31 to 0.83, was investigated by d.s.c. measurements and compared with those in water-swollen poly(vinyl alcohol) membranes. The amount of freezing water in the membranes was estimated by use of a relationship between the phase transition temperature and the enthalpy of the crystallization of supercooled water. The melting temperature of the water in the membranes immersed in urea and NaCl 0–2 mol l^?1 aqueous solutions was also determined by d.s.c. analysis. The present study proposes a method for estimating the solubilities of urea and NaCl in both of the freezing and the non-freezing water using the melting point depression of the freezing water in the membranes immersed in the solute solution.     

The influence of catalyst-supporting methods on electrochemical activity and the resultant stability of air electrodes activated with iron phthalocyanine

To improve the performance of air electrodes, the dependence of iron phthalocyanine (FePc) catalytic effects on preparation methods was examined. The methods used were mixture (Electrode 1), impregnation (Electrode 2) and direct synthesis (Electrode 3). Electrodes 2 and 3 showed higher potentials during cathodic polarization up to 10 mA cm^–2 than Electrode 1. The rate of chemical destruction of H₂O₂ decreased in the order Electrode 3 > Electrode 2 > Electrode 1. Electrode 3 showed the smallest potential drop for a discharge at 10 mA cm^–2, 0.09 V after 50 h. However, the potential of Electrode 2 decreased with discharge, becoming 0.09 V lower than that of Electrode 3 after a 50 h discharge at 10mA cm^–2. Once the potential drop occurred, the potential was not recovered by resting or by drying the electrode. The potential drop may be caused by deactivation of FePc. One possible reason for such deactivation is the presence of H₂SO₄, which remained on the electrode after impregnation of the FePc-H₂SO₄ solution.     

A Fast and Accurate Method of Redesigning Analog Subcircuits for Technology Scaling

In this paper, we present an efficient approach for technology scaling of MOS analog circuits by using circuit optimization techniques. Our new method is based on matching equivalent circuit parameters between a previously designed circuit and the circuit undergoing redesign. This method has been applied to a MOS operational amplifier. We were able to produce a redesigned circuit with almost the same performance in under 4 h, making this method 5 times more efficient than conventional methods.     

Microstructures of Annealed TiNiSn-Based Alloy Ribbons

The thermoelectric half-Heusler compounds Ti _x NiSn_0.998Sb_0.002 (x = 1.0 to 1.2) and Ti _y Zr_0.25Hf_0.25NiSn_0.998Sb_0.002 (y = 0.5 to 0.65) with nonstoichiometric nominal compositions were prepared by spin-casting and subsequent annealing at 1073 K for 24 h. The dimensionless figure of merit ZT at room temperature was maximized at x = 1.1 and y = 0.6 in Ti-rich compounds through an increase in absolute Seebeck coefficients despite a decrease in electrical conductivities. ZT reached 0.07 at x = 1.1 and 0.14 at y = 0.6. In powder x-ray diffraction analysis, minor phases of β-Sn, TiNi, Ti₂Sn, and Ti₅Sn₃ were observed in addition to a major phase of half-Heusler. The quantity of the minor phases was minimized at x = 1.1 and y = 0.55, where the absolute Seebeck coefficients are maximized. In transmission electron microscopic (TEM) analysis of Ti_0.55Zr_0.25Hf_0.25NiSn_0.998Sb_0.002, crystal grains of the half-Heusler phase, from several hundred nanometers to several micrometers in size, were observed. TEM energy-dispersive spectroscopy measurements indicated that fluctuations of Ti, Zr, and Hf compositions within the Ti-site in the half-Heusler phase may occur. Thermoelectric properties were improved at x = 1.1 and y = 0.6 rather than at the stoichiometric compositions of x = 1.0 and y = 0.5 due to minimization of the precipitate quantities.     

1-V 100-MHz embedded SRAM techniques for battery-operatedMTCMOS/SIMOX ASICs

Multithreshold-voltage CMOS (MTCMOS) has a great advantage of lowering physical threshold voltages without increasing the power dissipation due to large subthreshold leakage currents. This paper presents the embedded SRAM techniques for high-speed low-power MTCMOS/SIMOX application-specified integrated circuits (ASICs) that are operated with a single battery cell of around 1 V. In order to increase SRAM operating frequency, a pseudo-two stage pipeline architecture is proposed. The address decoder using a pass-transistor-type NAND gate and a segmented power switch presents a short clocked wordline selection time. The large bitline delay in read operations is greatly shortened with a new memory cell using extra low-V_th nMOSs. The small readout signal from memory cells is detected with a high-speed MTCMOS sense amplifier, in which a pMOS bitline selector is merged. The wasted power dissipation in writing data is reduced to zero with a self-timed writing action. A 8 K-words×16-bits SRAM test chip, fabricated with a 0.35-μm MTCMOS/SIMOX process (shortened effective channel length of 0.17 μm is available), has demonstrated a 100-MHz operation under the worst power-supply condition of 1 V. At a typical 1.2 V, the power dissipation during the standby time is 0.2-μW and that of a 100-MHz operation with a checkerboard test pattern is 14 mW for single fan-in loads     

Structure and viscoelastic properties of segmented polyurethane blends

Structure and viscoelastic properties of segmented polyurethanurea (SPU) blends were investigated. The glass transition temperature (T_g) of poly(tetramethylene glycohol) (PTMG) in a soft-segment block of the component SPU increased with decreasing molecular weight of PTMG. The blend samples showed two T_gs of PTMG in the temperature dispersions of the loss modulus (E″) and loss tangent (tan δ). The value of E′ in the leathery region for the blend specimens was trongly affected by the morphology. The blends were considered to have a morphology where PTMG differing in molecular weight was localized. © 1996 John Wiley & Sons, Inc.