Widely tunable bottom-emitting vertical-cavity SOAs

We present bottom-emitting tunable vertical-cavity semiconductor optical amplifiers (VCSOAs) with an effective wavelength tuning range of >20 nm. These devices utilize a high reflectivity micromechanically tunable Bragg mirror as the back reflector. Compared with our first generation tunable VCSOAs, the bottom-emitting devices exhibit a two-fold increase in the effective tuning range as well as a five-fold reduction in the required tuning voltage.     

Stability studies on methyl and ethyl fatty acid esters of sunflowerseed oil

Fatty acid esters, high in linoleic acid, were prepared and stored for long-term engine tests. Storage tests with these esters were undertaken to obtain more information on optimal storage requirements and general stability characteristics. Samples were kept at three temperature levels (20 C, 30 C and fluctuating around 50 C) for a 90-day period and were removed at regular intervals for chemical and physical analysis. The influence of air, temperature, light, TBHQ and contact with mild steel was evaluated by comparing the free fatty acid, peroxide, anisidine, ultraviolet absorption, viscosity and induction periods. A statistical model was used to evaluate the data and to reduce the large number of data points to comparable curves. Storage of esters in contact with air, especially at a temperature above 30 C, resulted in significant increases in peroxide, ultraviolet absorption, free fatty acid, viscosity and anisidine values. Exclusion of air retarded oxidation at all temperature levels. A direct relationship between viscosity increases and oxidation parameters was evident. Exposure to light caused a small increase in the oxidation parameters of esters stored at the highest temperature level. Addition of TBHQ prevented oxidation of samples stored under moderate conditions. Under unfavorable storage conditions the anti-oxidant was no longer effective. Mild steel had very little effect on the oxidation parameters. Only the anisidine values of samples stored at the highest temperature level were slightly increased. Methyl esters performed slightly better than ethyl esters during the storage test. The following practical guidelines for storage of fatty acid ester fuels are: (i) airtight containers should be used; (ii) the storage temperature should be <30 C; (iii) mild steel (rust free) containers may be used, and (iv) TBHQ has a beneficial effect on oxidation stability.     

New lamps for old: the story of electric lighting

Of all the products of electrical technology, none has made a more profound difference to our way of life than the humble light bulb. The author describes the history of the light bulb from the time it was introduced and started to replace gas lamps to the present day. In particular the author discusses the early developments in arc lighting and incandescent filament lamps. The author also discusses the introduction of mercury vapour lamps, fluorescent lamps, and evacuation of the lamps     

High-power 1320-nm wafer-bonded VCSELs with tunnel junctions

A new long-wavelength vertical-cavity surface-emitting laser structure is described that utilizes AlGaAs-GaAs mirrors bonded to AlInGaAs-InP quantum wells with an intracavity buried tunnel junction. This structure offers complete wavelength flexibility in the 1250-1650 nm fiber communication bands and reduces the high free-carrier losses and bonded junction voltage drops in previous devices. The intracavity contacts electrically bypass the bonded junctions to reduce threshold voltage. N-type current spreading layers and undoped AlGaAs mirrors minimize optical losses. This has enabled 134/spl deg/C maximum continuous-wave lasing temperature, 2-mW room-temperature continuous-wave single-mode power, and 1-mW single-mode power at 80/spl deg/C, in various devices in the 1310-1340 nm wavelength range.     

Travelling-wave photodetectors with 172-GHz bandwidth and 76-GHzbandwidth-efficiency product

Results of the first fabrication and measurement of travelling-wave photodetectors are reported. The devices have bandwidths as high as 172 GHz, the highest reported for a p-i-n photodetector, and bandwidth-efficiency products as large as 76 GHz, the largest reported for any photodetector without gain. Comparisons with vertically illuminated and waveguide photodetectors fabricated on the same wafer establish the superior performance of travelling-wave photodetectors. Microwave loss on the travelling-wave photodetector structure is identified as a bandwidth limitation     

Long distance fiber-optic transmission of C-band microwave signals to and from a satellite antenna

We demonstrate here the use of high-speed semiconductor lasers and detectors with low loss optical fiber for the transmission of the 500-MHz C-band microwave signal spectrum to and from a satellite antenna. The optical system has low attenuation and large band, width, so the microwave signals can be transmitted directly at the microwave frequency (4 or 6 GHz) over 20 km of fiber without regeneration or qualization. The optical system introduces ≈ 1 dB or less of degradation for both low spectral density QPSK signals and high spectral density FM video signals present in typical satellite transmission systems. For the video signals, the signal to noise after AM conversion was reduced from 56 to 55 dB. The microwave drive level to the laser must be significantly larger (typically > -10 dBm) than the intensity noise of the laser, yet small enough (typically < 10 dBm) to reduce the intermodulation distortion signals to an acceptable level. The laser bias current must be several times threshold so that the resonance frequency is beyond the frequency band of interest (4-6 GHz in this case). A flat modulation response is then obtained, and the intensity noise and intermodulation levels are low.     

High-speed, polyimide-based semi-insulating planar buried heterostructures

We describe planar buried heterostructure lasers which have low capacitance (lpF), large bandwidth (19GHz), high power (>20mW/facet) and high temperature operation (100°C). These lasers are very suitable for long-distance, highspeed digital and analogue signal transmission.     

A device to measure the cross-sectional area of soft connectivetissues

A device has been designed and fabricated to measure the cross-sectional area of soft connective tissues ex vivo. It consists of two displacement transducers; one sensing tissue thickness and the other sensing width. Outputs are recorded (via an analog to digital interface) using a personal computer. Numerical integration of a thickness versus width plot computes cross-sectional area. This plot also provides a quality check of acquired data. This device has been successfully used in biomechanical studies of rabbit patellar tendons, rat medial collateral ligaments, and dissected specimens of human fascia.