Increasing Volumetric CO2 Uptake of Hypercrosslinked Polymers through Composite Formation

To overcome the drawbacks of solid microporous materials for CO₂ capture, this proof‐of‐concept study demonstrates a low‐cost and rapid method for producing composites consisting of hypercrosslinked polymers (HCP) with a polyethyleneimine (PEI) binder. The resulting materials capture CO₂ through physical and chemical absorption simultaneously. Compared with HCP, the composites exhibit higher CO₂ uptake, higher volumetric density, and improved tolerance to water which is attributed to the PEI binder.     

木材对均衡室内湿度的作用

木材表面可以使一天过程中室内湿度的波动减小,木镶板使室内湿度更长时间保持稳定,可减少人工通风的需求量,节约能源,提高空气质量. 室内湿度的短期波动来自于房间日常使用时产生的湿度,长期波动来自于降雨和季节变化带来的长期影响.对比房间表面覆盖着一种不吸收水汽的材料时,木质室内装饰材料对水分的吸收降低了湿度每日波动的峰值,提高了可感知的室内空气质量,从而降低对人工通风和能源的需求.     

Technical and economic analysis of solvent-based lithium-ion electrode drying with water and NMP

Processing lithium-ion battery (LIB) electrode dispersions with water as the solvent during primary drying offers many advantages over N-methylpyrrolidone (NMP). An in-depth analysis of the comparative drying costs of LIB electrodes is discussed for both NMP- and water-based dispersion processing in terms of battery pack $/kWh. Electrode coating manufacturing and capital equipment cost savings are compared for water vs. conventional NMP organic solvent processing. A major finding of this work is that the total electrode manufacturing costs, whether water- or NMP-based, contribute about 8–9% of the total pack cost. However, it was found that up to a 2?×?reduction in electrode processing (drying and solvent recovery) cost can be expected along with a $3–6?M savings in associated plant capital equipment (for a plant producing 100,000 10-kWh Plug-in Hybrid Electric Vehicle (PHEV) batteries) using water as the electrode solvent. This paper shows a different perspective in that the most important benefits of aqueous electrode processing actually revolve around capital equipment savings and environmental stewardship and not processing cost savings.     

Development of a simple microsystems membrane probe card

Presented here are details of the development of a novel membrane integrated circuit (IC) probe card structure based on microsystems technology. The device design allows probing of both solder bumps and pads. A self-limiting sensor was integrated to prolong device lifetime. Comparison with and discussion of the use of modelling is made. Possible enhancements to the probing structure are discussed to improve alignment and measurements. Also shown is data using our microsystems probe card to access a simple IC device. Our device has a contact resistance of less than 0.5 Ω for a force of 0.004 N. A method to implement our probing structure for commercial application and the potential developments which can be made to improve its ease of use are then discussed.     

Finite element analysis of electromagnetic scattering from a cavity

A finite element method (FEM) is implemented to compute the radar cross section of a two-dimensional (2D) cavity embedded in an infinite ground plane. The method is based on the variational formulation which uses the Fourier transform to couple the fields outside the cavity and those inside the cavity; hence, the scattering problem can be reduced to a bounded domain. The convergence of the discrete finite element problem is analyzed. Numerical results are presented and compared with those obtained by the standard finite element-Green function method and by the 2D integral equation method.     

Viral dynamics of primary viremia and antiretroviral therapy in simian immunodeficiency virus infection

Mathematical modeling of viral replication dynamics, based on sequential measurements of levels of virion-associated RNA in plasma during antiretroviral treatment, has led to fundamental new insights into human immunodeficiency virus type 1 pathogenesis. We took advantage of the simian immunodeficiency virus (SIV)-infected macaque model to perform detailed measurements and mathematical modeling during primary infection and during treatment of established infection with the antiretroviral drug (R)-9-(2-phosphonylmethoxypropyl)adenine (PMPA). The calculated clearance half-life for productively infected cells during resolution of the peak viremia of primary infection was on the order of 1 day, with slightly shorter clearance half-lives calculated during PMPA treatment. Viral reproduction rates upon discontinuation of PMPA treatment after 2 weeks were approximately twofold greater than those obtained just prior to initiation of treatment in the same animals, likely reflecting accumulation of susceptible target cells during treatment. The basic reproductive ratio (R0) for the spread of SIV infection in vivo, which represents the number of productively infected cells derived from each productively infected cell at the beginning of infection, was also estimated. This parameter quantifies the extent to which antiviral therapy or vaccination must limit the initial spread of virus to prevent establishment of chronic disseminated infection. The results thus provide an important guide for efforts to develop vaccines against SIV and, by extension, human immunodeficiency virus.     

Resumption of mitosis during post-thaw culture: a key parameter in selecting the right embryos for transfer

A new oxidative pathway for the degradation of caffeine(1,3,7-Trimethylxanthine, I) by a mixed culture consisting of strains belonging to the genera Klebsiella and Rhodococcus is presented. The mixed culture does not initiate degradation by N-demethylation either complete or partial, but instead carries out oxidation at the C-8 position resulting in the formation of 1,3,7-trimethyluric acid (TMU, II) which further gets degraded to 3,6,8-trimethylallantoin (TMA, III). Both TMU and TMA are hitherto not shown to be formed in the microbial system. Further degradation of TMA (III) by caffeine grown cells yields dimethylurea (VII) as one of the metabolites. Oxygen uptake studies indicated that caffeine(I) grown cells oxidized TMU(II), TMA (III), glyoxalic acid (VI), dimethylurea(VII), and monomethylurea(V), but not monomethyl and dimethyluric acids. The mixed culture does not accept theophylline(1,3-dimethylxanthine), theobromine(3,7-dimethylxanthine), and paraxanthine(1,7-dimethylxanthine) as the carbon source.     

Foetal alcohol syndrome in Saskatchewan: unchanged incidence in a 20-year period

Ethers and thioethers of monosaccharides have been synthesised which show potent toxicity to mouse (LD50 > or = 4 g.kg-1 O.W. and 0.2 to 1.5 g.kg-1 I.P.W.). A study of calcium antagonist activity for the full series of compounds indicated that the activity was similar for both O- and S- ethers and maximum activities were observed for monoacetoneglucose ethers possessing carbon chain close to 8 carbons.     

Regional lipid peroxidation and protein oxidation in rat brain after hyperbaric oxygen exposure

Reactive oxygen species may participate in development of neurological toxicity resulting from hyperbaric oxygen exposure. To explore the possibility that increased reactive O2 metabolite generation may result in oxidative modification of lipids and proteins, rats were exposed to five atmospheres (gauge pressure) of O2 until development of an electroencephalographic seizure. Lipid peroxidation (as thiobarbituric acid-reactive substances) and protein oxidation (as 2,4-dinitrophenyl-hydrazones) were measured in five brain regions. Oxidized and reduced glutathione were also determined because of their role in regulating lipid peroxidation. Lipid peroxidation was confined to the frontal cortex and hippocampus, while protein oxidation (in both cytoplasmic and membranous fractions) and increased oxidized glutathione was evident throughout the brain. These results support a role for formation of reactive O2 metabolites from hyperbaric O2 exposure and suggest that protein oxidation, especially in soluble proteins, may be one of the most sensitive measures.