利用纤维床生物反应器发酵生产链霉素

利用纤维床生物反应器(FBB)发酵生产链霉素,对发酵培养基氮源进行了优化,并与传统搅拌发酵进行了比较。结果表明,以可溶性有机氮源大豆蛋白胨作为发酵培养基氮源,并添加一定量蔗糖,可以完全替代黄豆粉,在1 LFBB中发酵96 h时链霉素效价达到5 567 U·mL~(-1)。在整个发酵过程中,所有菌体都被固定在纤维床反应器上,而发酵液保持澄清,这不仅有利于从无菌体的发酵液中进行产物的提取和纯化,也可以重复利用菌体生产次级代谢产物,从而缩短发酵周期,进一步提高链霉素在发酵过程中的体积生产率。     

A first-principles investigation on mechanical and metallic properties of titanium carbides under pressure

The titanium carbides are potential candidates to achieve both high hardness and refractory property. We carried out a structural search for titanium carbides at three pressures of 0 GPa, 30 GPa and 50 GPa. A phase diagram of the Ti-C system at 0 K was obtained by elucidating formation enthalpies as a function of compositions, and their mechanical and metallic properties of titanium carbides were investigated systematically. We also discussed the relation of titanium concentration to the both mechanical and metallic properties of titanium carbides. It has been found that the average valence electron density and tractility improved at higher concentrations of titanium, while the degree of covalent bonding directionality decreased. To this effect, the hardness of titanium carbide decreases as the content of titanium increases. Our results indicated that the titanium content significantly affected the metallic properties of the Ti-C system.     

PTT直接酯化反应动力学研究

研究了不同温度下PTT(聚对苯二甲酸丙二醇酯)直接酯化反应动力学。建立了零级和一级反应动力学模型。用实验数据进行的检验表明,一级动力学模型更为接近该反应过程。     

大蒜活性成分阿霍烯的研究概况

阿霍烯作为源自于大蒜的一种活性成分，较之蒜素更加稳定且不具有令人难以接受的蒜辣蒜臭气味，具有抗血栓形成，诱导肿瘤细胞调亡及抗菌消炎等特别的生理功效，是一种天然高效的活性成分。本文综述了近年来有关阿霍烯的生理功效，结构组成及形成机制等的研究概况。     

一种适用于有限长度混合相位未知脉冲的最小平方反褶积新方法

普通的最小平方反褶积只有在子波为最小相位脉冲和反射序列为白噪声的假设下才是成立的,而对于混合相位未知脉冲来说,这种最小平方反褶积就不再适用了。本文提出一种适合于有限长度混合相位未知脉冲的最小平方反褶积方法。运用此法只需预先估计一个混合相位子波的长度。合成数据的试验结果表明,该方法有较好的效果,且对预先估计出的子波长度不敏感。文中还证明混合相位未知脉冲最小平方反褶积等效于一种有间隙的平滑误差滤波器的作用,而这种有间隙的平滑误差滤波又可分解为一个前向多步预测误差滤波与一个后向多步预测误差滤波之和。可以预计这种新的反滤积方法将在地震数据处理中得到有效的应用。     

Ti-45Al-10Nb合金的高温氧化行为

研究了Ti—45A1—10Nb(原子分数，％)合金在800-960℃在氧气和空气中的氧化行为．结果表明，该合金具有较好的高温抗氧化性能，其氧化增重速率与铁基耐热不锈钢相似或略优．与Ti—50A1合金相反，Ti-45A1-10Nb合金在空气中的氧化增重速率明显低于在纯氧中的氧化增重速率．X射线衍射与能谱分析表明，Ti-45Al一10Nb合金在氧气中的氧化产物主要有TiO2和Al2O3，但在空气中的氧化产物中有TiN相．这是降低氧化速率的主要原因，同时，合金元素Nb稳定了氧化层中的TiN相，因而提高了合金在空气中的抗氧化性能．     

MMSE-optimal approximation of continuous-phase modulated signal as superposition of linearly modulated pulses

The optimal linear modulation approximation of any M-ary continuous-phase modulated (CPM) signal under the minimum mean-square error (MMSE) criterion is presented in this paper. With the introduction of the MMSE signal component, an M-ary CPM signal is exactly represented as the superposition of a finite number of MMSE incremental pulses, resulting in the novel switched linear modulation CPM signal models. Then, the MMSE incremental pulse is further decomposed into a finite number of MMSE pulse-amplitude modulated (PAM) pulses, so that an M-ary CPM signal is alternatively expressed as the superposition of a finite number of MMSE PAM components, similar to the Laurent representation. Advantageously, these MMSE PAM components are mutually independent for any modulation index. The optimal CPM signal approximation using lower order MMSE incremental pulses, or alternatively, using a small number of MMSE PAM pulses, is also made possible, since the approximation error is minimized in the MMSE sense. Finally, examples of the MMSE-optimal CPM signal approximation and its comparison with the Laurent approximation approach are given using raised-cosine frequency-pulse CPM schemes.     

却勒1油藏储层地质特征及伤害因素试验研究

却勒1油藏是分流河道沉积并由构造控制的层状边水油藏，储层特征决定了其在开发过程中存在一定的潜在伤害因素。通过对实际岩心分析测试和敏感性伤害评价实验，并结合储层地质特征分析研究，明确了却勒1油藏储层的碎屑颗粒成分、填隙物、结构、物性和非均质性特征；敏感性伤害评价实验研究结果表明：液相侵入导致水锁、自吸水膨胀是第一位潜在伤害因素；液相侵入形成的水敏、盐敏、酸敏、碱敏是第二位潜在的伤害因素；由压力突增而形成的速敏、压敏是笫三位的潜在伤害因素。     

Study of Desorption Agent for LADS Process

This article refers to the procedure for selection, evaluation and development of the LADS-D desorption agent associated with the LADS-A adsorbent used in the non-hydroprocessing adsorptive desulfurization (LADS) process for FCC naphtha developed by LPEC Refining Research Institute. The LADS-D desorption agent can effectively remove the sulfides adsorbed on the LADS-A adsorbent. The saturated LADS-A adsorbent can be instantly regenerated by the LADS-D desorption agent to recover its adsorption activity. The LADS-D desorption agent can not only effectively remove all impurities adsorbed on the adsorbent, but also has strong ability to dissolve the impurities to keep a stable desorption efficiency of adsorbent to be basically commensurate with fresh adsorbent after extended use.     

多陀螺自动化测试系统研究

针对动力调谐挠性陀螺大批量生产中存在的性能调试和参数标定工作量大的问题，我们专门研制了一套多陀螺自动化测试系统，该系统主要包括多陀螺真空恒温安装基准体、测控台、计算机程控自动化数据采集和仪器等部分，本文着重介绍该系统的组成原理，设计特点和研制成果。