Isolation of antimicrobial agent from the marine algae Cystoseira hakodatensis

Cystoseira hakodatensis is an unutilised brown algae belonging to family Sargassaceae. A crude methanol extract from the algae showed inhibitory effects on the growths of Bacillus cereus and Bacillus licheniformis. To isolate the major antimicrobial agent, a sequential active‐guided isolation procedure was applied: liquid–liquid extraction, column chromatography and bio‐autography. A marked antimicrobial agent (active α) was isolated in hydrophobic fraction and was determined to phenolics without carbohydrates and proteins by phytochemical test. Regarding the antimicrobial potential, the isolated active α showed better inhibitory effects against B. cereus and B. licheniformis at 2 and 4 times of lower concentrations (62.5 and 31.3 μg mL^?1) in comparison with epigallocatechin gallate. These results showed that C. hakodatensis is a potential source of antimicrobial agent capable of preventing the growth of the two bacteria.     

Volumetric Change and Surface Properties of Temperature-Sensitive Polyvinylalcohol (PVA) Hydrogel

Polyvinylalcohol (PVA) polymer gel is a temperature sensitive polymeric gel, with a critical transition temperature (with H₂O) of 310 K. At higher than 310 K, this temperature sensitive polymer gel shrinks because of discharging water, whereas at lower temperatures, the gel swelled because of absorbing water. The reversibility of the gel's volume change was confirmed by temperature swing. The adsorption behavior of an organic compound onto the PVA polymer gel in water was tested at various temperatures. The amount of adsorbed organic compound increased remarkably at temperatures higher than about 310 K. Then, it was confirmed that the organic compound in PVA polymer gel could be reversibly adsorbed and desorbed by a temperature change between 293 and 323 K. The mechanism of adsorption of the organic compound onto the PVA polymer gel could be explained by hydration and dehydration of polymer gel.     

1-GHz-spaced 16-channel arrayed-waveguide grating for a wavelength reference standard in DWDM network systems

We fabricated a 1-GHz-spaced 16-channel arrayed-waveguide grating (AWG) by using a new AWG configuration where the path of each arrayed waveguide winds backward and forward across a 4-in diameter wafer without crossing any other waveguides. The ultra-narrow (< 1 GHz) and stable transmission bands of this AWG can be used to construct a wavelength reference standard covering the S, C, and L bands in the dense wavelength-division-multiplexing network systems whose frequency deviation is /spl plusmn/160 MHz.     

Binary Adsorption Isotherms of Water and Ethyl Acetate Vapor for Materials Contained in a Box of a Tobacco Product

An experimental study has been carried out on the characteristics of binary adsorption isotherms of water and volatile flavor for typical materials used in a box of a tobacco product or cigarettes. Ethyl acetate chosen as a model for water-soluble volatile flavor. Binary adsorption isotherms for the tobacco, papers, filters, and activated carbons were measured with a flow-type multi-component adsorption system under the canstant conditions of temperature a t 303 K and vapor pressure of water a t 2.5 kPain the vapor pressure range of ethyl acetate from 0 to 4.2 kPa. A linear equation was applied to express the binary adsorption isotherms for the tobacco, papers and filters, while a Dubinin-Astakhov equation was applied for the activated carbons. The binary adsorption was characterized into three groups, depending on the selectivity as well as the mechanism of adsorption; i.e.(l) for tobacco and papers, water was adsorbed much greater rather than ethyl acetate, (2) for filters, ethyl acetate was adsorbed on the surface as great as water, (3) for activated carbons, ethyl acetate was adsorbed much greater onto their micropores rather than water. The results showed that ethyl     

A stacking mechanism for setting bills upright in an automated teller machine

 To deal with circulated bills in various conditions regarding size, shape, and rigidity, we have developed a new bill-stacking cassette that can accept and re-dispense various-sized bills. This cassette stacks the bills upright by using deforming guides and sheet rollers under our newly developed “phase control”. It was experimentally verified by stacking tests that the cassette can handle bills in various conditions; thus, we conclude that the new cassette is practical for stacking circulated bills and re-dispensing them securely. Received: 14 August 2001/Accepted: 11 December 2001     

Controlled undercooling of liquid iron in contact with ZrO2 and MgO substrates under varying oxygen partial pressures

The objective of this study is to determine the conditions under which the inclusions present in liquid steel can act as heterogeneous nucleants for solidification. In order to study the factors that define the undercooling of a given metal/oxide couple, the undercooling of a pure iron sessile droplet in contact with Al₂O₃, ZrO₂, and MgO substrates was measured under controlled oxygen partial pressures by observing droplet recalescence. The results showed that the undercooling of iron, in contact with a particular substrate, did not have a unique value, but was significantly affected by the oxygen content on the gas phase. For oxygen partial pressures between 10⁻²¹ and 10⁻¹⁹, the undercooling of iron on ZrO₂ substrates was stable and around 290 °C. In the same range of oxygen partial pressure, the undercooling of iron on MgO substrates remained below 100 °C due to the low stability of this oxide. At lower oxygen contents, substrate decomposition might be the cause for the observed drop in the undercooling of iron on ZrO₂ substrates to below 100 °C. The undercooling also decreased for increasing oxygen content as verified when the gas was changed from gettered Ar/Ar-H₂ to CO/CO₂ mixtures. The variation in undercooling was related to the wetting of the substrate by the liquid metal, where the deep undercooling observed in the ZrO₂ experiments occurred when the highest contact angle between the liquid metal and the substrate was achieved.     

A delay-encoding-logic array processor for dynamic-programming matching of data sequences

Computationally very expensive dynamic-programming matching of data sequences has been directly implemented in a fully-parallel-architecture VLSI chip. The circuit operates as digital logic in the signal domain, while analog processing is carried out in the time domain based on the delay-encoding-logic scheme. As a result, a high-speed low-power best-match-sequence search has been established with a small chip area. The typical matching time of 80 ns with the power dissipation of 2 mW has been demonstrated with fabricated prototype chips.     

Human papillomavirus investigation of patients with cervical intraepithelial neoplasia 3, some of whom progressed to invasive cancer

Unstable expansion of the CTG repeats in the 3' untranslated region encoding a member of the protein kinase family in the q13.3 band on chromosome 19 is a mutation specific for myotonic dystrophy. To examine the correlation between clinical expression and CTG trinucleotide repeat length, we carried out Southern blot analysis in a family with myotonic dystrophy. In this pedigree, the expanded CTG repeats were transmitted maternally. The mother had three female children. The mother had about 200 CTG repeats, and the number of repeats for each child was about 800, 1500 and 1600 in birth order. The mother and the patient with 800 repeats were unaware of muscle weakness or myotonia. Symptoms were present from age 3 years in the patient with 1500 repeats and from birth in the one with 1600 repeats. Although the mother menstruated regularly, the patients with 800 and 1500 repeats both menstruated irregularly, and the one with 1600 repeats has never menstruated. The age of onset and severity of the disease were correlated with the size of the expanded repeats. Endocrinological studies revealed that the basal levels of the gonadotropins, PRL and E2 were within normal range, and a pituitary response to LHRH was observed. These data suggest that the amenorrhea and menstrual irregularities were caused by a suprahypophyseal dysfunction. When expanded CTG repeats are transmitted maternally, abnormal products resulting from the metabolic disturbance in the affected mother may harm the fetus in utero. A heterozygous fetus, who has more CTG repeats, may be unable to metabolize the pathologic products sufficiently and therefore may become more severely affected. This may explain the exclusive maternal transmission of congenital myotonic dystrophy.     

Development of 170 GHz/500 kW gyrotron

A development of 170GHz/500kW level gyrotron was carried out as R&D work of ITER. The oscillation mode is TE_31,8. In a short pulse experiment, the maximum power of 750kW was achieved at 85kV/40A. The efficiency was 22%. In the depressed collector operation, 500kW/36%/50ms was obtained. The maximum efficiency of 40% was obtained at P_RF=470kW whereas the power decrease by the electron trapping was observed. Pulse extension was done up to 10s at P_RF=170kW with the depressed collector operation. The power was limited by the temperature increase of the output window.     

STEAM DRYING TECHNOLOGIES: JAPANESE R&D

This report reviews some fundamental and practical aspects of steam drying technologies based mainly on studies published in Japan. Steam drying kinetics, and some industrial technologies particularly for drying of foods, textiles and sludges are reviewed with focus on quality of dried material, drying time, dryer selection and energy recovery from steam dryer exhaust. For energy recovery, heat pump technologies are outlined along with characteristics of different types of steam compressors. A new process is proposed for steam drying; it combines a direct-indirect dryer followed by a direct steam dryer for internal moisture removal.