Thermal response in thermal energy storage material around heat transfer tubes: effect of additives on heat transfer rates

The effects of carbon-fiber chips and carbon brushes as additives on the thermal conductivity enhancement of phase change materials (PCMs) using in latent heat thermal energy storage are investigated experimentally and numerically by considering the wall effect of the additives. The carbon-fiber chips are effective for improving the heat transfer rate in PCMs. However, the thermal resistance near the heat transfer surface is higher than that for the carbon brushes. As a result, the overall heat transfer rate for the fiber chips is lower than that for the carbon brushes. Consequently, the carbon brushes are superior to the fiber chips for the thermal conductivity enhancement under the present experimental conditions. The carbon brushes are moreover applied to the packed beds of particles to overcome their low thermal conductivity in chemical heat pump/storage. The carbon brushes essentially improve the heat transfer characteristics in the packed beds, though the thermal resistance is observed because the particles obstruct contact between the fibers and the heat transfer surfaces.     

Non-linear current–voltage characteristics related to native defects in SrTiO3 and ZnO bicrystals

SrTiO₃ and ZnO bicrystals with various types of boundaries were fabricated in order to examine their current–voltage characteristics across single grain boundaries. Their grain boundary structures were also investigated by high-resolution transmission electron microscopy. In Nb-doped SrTiO₃, electron transport behaviors depend on the type of boundaries. Random type boundaries exhibit highly non-linear current–voltage characteristics, while low angle boundaries show a slight non-linearity. On the contrary, undoped ZnO does not exhibit non-linear current–voltage characteristics in any type of boundaries including random ones. It is suggested that the differences observed in current–voltage properties between the two systems are mainly due to the difference in the accumulation behavior of acceptor-like native defects at grain boundaries. A clear non-linearity is obtained by means of Co-doping even for the highly coherent Σ1 boundary in a ZnO bicrystal. This is considered to result from the production of acceptor-like native defects by Co-doping.     

Nosocomial diarrhoea in the elderly due to enterotoxigenic Clostridium perfringens

Zinc is an important trace element for immune function. Here, we show that zinc addition in a serum- and lipopolysaccharide-free cell culture system leads to significantly enhanced levels of interleukin 1 beta (IL-1 beta) and tumour necrosis factor alpha (TNF-alpha) and to expression of the corresponding mRNA in human peripheral blood mononuclear cells (PBMC). Structurally related divalent cations like cobalt, nickel, and mercury also partially increase monokine secretion but to a much lower and thus insignificant extent. They fail to induce mRNA of TNF-alpha after 3 h of culture. Therefore, monokine induction is a zinc-specific effect influenced by the physicochemical properties of the ion. Confirmation of the unique significance of zinc for immune function provides a better understanding of the mechanisms of specific zinc-mediated immune modulation.     

Micro-computerized tomographic observation of the spinning apparatus in Bombyx mori silkworms

Silkworms and spiders have evolved complex spinning apparatus thought to use highly controlled conditions to optimize protein folding and crystallization to provide a tough fiber. Accordingly, the structure and function of the natural spinning apparatus has been studied with great attention as an interesting piece of biological engineering with potential for mimicry in an industrial process. However it is still not well understood. Here we used Micro-Computerized Tomographic equipment (mCT) to visualize the three-dimensional structure of the spinning apparatus in Bombyx mori silkworms. Multidirectional tomograms obtained by X-ray radioscopy provided valuable information on the detailed arrangement of each muscle of the silk press. It is suggested that the duct in the silk press part plays a part as an extrusion die whose cross-sectional area can be controlled by muscles to optimize applied stresses in the partially gelled silk within its lumen.     

Accelerator Analysis of Tributyltin Adsorbed onto the Surface of a Tributyltin Resistant Marine Pseudoalteromonas sp. Cell

Tributyltin (TBT) released into seawater from ship hulls is a stable marine pollutant and obviously remains in marine environments. We isolated a TBT resistant marine Pseudoalteromonas sp. TBT1 from sediment of a ship’s ballast water. The isolate (10^{9.3 ± 0.2} colony-forming units mL⁻¹) adsorbed TBT in proportion to the concentrations of TBTCl externally added up to 3 mM, where the number of TBT adsorbed by a single cell was estimated to be 10^8.2. The value was reduced to about one-fifth when the lysozyme-treated cells were used. The surface of ethanol treated cells became rough, but the capacity of TBT adsorption was the same as that for native cells. These results indicate that the function of the cell surface, rather than that structure, plays an important role to the adsorption of TBT. The adsorption state of TBT seems to be multi-layer when the number of more than 10^6.8 TBT molecules is adsorbed by a single cell.     

Accelerated neutrophil apoptosis in mice lacking A1-a, a subtype of the bcl-2-related A1 gene

To elucidate the role of A1, a new member of the Bcl-2 family of apoptosis regulators active in hematopoietic cell apoptosis, we established mice lacking A1-a, a subtype of the A1 gene in mice (A1-a-/- mice). Spontaneous apoptosis of peripheral blood neutrophils of A1-a-/- mice was enhanced compared with that of either wild-type mice or heterozygous mutants (A1-a+/- mice). Neutrophil apoptosis inhibition induced by lipopolysaccharide treatment in vitro or transendothelial migration in vivo observed in wild-type mice was abolished in both A1-a-/- and A1-a+/- animals. On the other hand, the extent of tumor necrosis factor alpha-induced acceleration of neutrophil apoptosis did not differ among A1-a-/-, A1-a+/-, and wild-type mice. The descending order of A1 mRNA expression was wild-type, A1-a+/-, and A1-a-/-. Taken together, these results suggest that A1 is involved in inhibition of certain types of neutrophil apoptosis.     

Polyacrylonitrile/Nylon 6 Blends: Preparation and Characterization

Summary: Polyacrylonitrile (PAN) particles with micro‐size ranges (0.15–2 μm) were prepared by emulsion and dispersion polymerizationa and in supercritical carbon dioxide media. The PAN particles were blended with Nylon 6 (PA6) at 220 °C by using a miniature mixer; it was found that melt‐mixing was possible for PAN‐rich compositions as high as 70 wt.‐%. Blends were characterized by scanning electron microscopy, IR, viscosity measurements, differential scanning calorimetry, and dynamic mechanical thermal analysis (DMTA). The size and shape of original PAN particles were retained in PAN/PA6 blends. The useful range to blend PAN particles size was less than 1 μm in terms of shape retention of the PAN particles in blends. Blends with 40 wt.‐% PAN content were found to be melt‐processable. The elastic modulus was higher for PAN/PA6 blends than pure PA6.

SEM photograph of PAN‐SC/PA6 blend with a 40/60 weight ratio.     

Differential scanning calorimetric studies on the glass transition temperature of polyhydroxystyrene derivatives containing sorbed water

Poly(4-acetoxystyrene) (PAS) and poly(4-acetoxy-3-methoxystyrene) (PAMS), poly(4-hydroxystyrene) (PHS) and poly(4-hydroxy-3-methoxystyrene) (PHMS) have been prepared. The effects of hydrogen bonding on the glass transition temperatures (T_g) of these polymers have been studied by differential scanning calorimetry. The T_g′s of partially hydrolyzed PAS and PAMS increased with the degree of hydrolysis. Partially hydrolyzed PAS and PAMS are estimated to be random copolymers, judging from the correspondence between the calculated and observed T_g′s of these polymers. The effect of water on the glass transition was also studied, and it was clarified how water adsorbed on the polymers acts as a hydrogen-bond breaker. The ‘critical water content’ is calculated from the decrease of T_g by water absorption, and the relation between hydrogen bonding and T_g is discussed.     

Polymerization of methyl methacrylate by tri-n-butylborane in the presence of amino acid esters

The polymerization of methyl methacrylate by tri-n-butylborane in the presence of amino acid esters was investigated. The binary systems of tri-n-butylborane and amino esters were found to be more effective for initiating the polymerization than tri-n-butylborane alone. Co-catalytic effects of amino acid esters were in the order: tyrosinate > glutamate > aspartate ? phenyl alaninate > serinate > glycinate. The rate of polymerization in a mixture of dimethylsulphoxide and toluene was proportional to the square root of the concentration of the initiator system, to the monomer concentration, and to the concentration of dimethylsulphoxide in the solvent. The overall energy of activation was estimated to be 4.6 kcal/mol for the tri-n-butylborane/methyl tyrosinate system. Copolymerization curves gave a typical free-radical character.