关于岳城水库工程管理的几点作法和思考

近几年,岳城水库工程管理工作有了长足的发展。究其原因,可以归结为以下几点:强化主业意识、学习先进经验和作法、强化工程管理、加大执法力度。为了深化水库管理工作,必须进一步加大改革力度,提高管理人员素质,加快工程管理的自动化、现代化水平。     

我国刑事司法中关于形式主义的反思——关于曹天案的法律思考

针对曹天案在社会中产生的各种观点,打破在单一体系内分析的传统方法,转而从形式主义法律观、行为刑法与行为人刑法、法律评价与社会评价等三个方面对该案揭示出的我国刑事司法中的深层次矛盾进行了反思。     

Effects of CaO and Na<Subscript>2</Subscript>CO<Subscript>3</Subscript> on the reduction of high silicon iron ores

The effects of CaO and Na₂CO₃ on the reduction of high silicon iron ores at 1 250 °C were studied. The experimental results showed that the metallization rate was significantly hindered by the addition of CaO and Na₂CO₃, particularly at the early stage of roasting, compared to the rate without additives. In the absence of additives, iron oxides were quickly reduced to metallic iron, and fayalite was difficult to form. When CaO and Na₂CO₃ were added, the low reducible iron-containing silicate compounds formed and melted, subsequently retarding the metallization process. The inhibition of Na₂CO₃ was more noticeable than that of CaO, and higher Na₂CO₃ doses resulted in stronger inhibition of the increased metallization rate. However, when Na₂CO₃ was added prior to CaO, the liquid phase formed, which facilitated the growth of the metallic phase. To reinforce the separation of the metallic phase and slag, an appropriate amount of liquid phase generated during the reduction is necessary. It was shown that when 10% CaO and 10% Na₂CO₃ were added, a high metallization rate and larger metallic iron particles were obtained, thus further decreasing the required Na₂CO₃ dosage.     

Ultrasonic attenuation model for measuring particle size and inverse calculation of particle size distribution in mineral slurries

1 INTRODUCTIONAcritical requirement for achieving i mprovedgrinding control is on-line particle size analysis .Grinding to a finer size than necessary results inreduced throughput , higher energy costs and in-creased consumption of milliners , grinding mediaand reagent . Too coarse grind results in notenough separation of the valuable minerals fromwaste and reduced recovery of the valuable miner-als .I mproving grinding control is beneficial toi m-proving milling efficiency , stable opera…     

金川镍渣充填胶凝材料力学性能与水化机理

金川矿山利用镍渣开发新型胶凝材料替代水泥以降低充填成本,为了使镍渣胶凝材料更好地应用于矿山充填,需要对其力学性能与水化机理进行研究.首先对试验材料进行物化分析,然后在此基础上进行强度试验,确定激发剂配比、物料比表面积及料浆质量分数,最后利用XRD分析、红外光谱分析、差热分析、能谱分析以及SEM微观结构分析来探究镍渣胶凝...     

纤维增强纳米SiO2复合隔热材料的力学性能研究

采用干法成型工艺制备了纤维增强纳米SiO2复合隔热材料,考察了成型压力和纤维长度对复合材料力学性能的影响。结果表明,成型压力越大,复合材料承受压力载荷的能力越强,纤维表面致密的纳米级颗粒覆层对纤维起到的保护和应力缓冲作用越强,抗折强度越高。增强纤维长度对抗压强度影响不大,纤维越长,抗折强度越高,但当纤维过长时会因分散困难而导致抗折强度下降,故适宜的纤维长度为5mm。此外,采用等效包容体理论建立了纤维增强复合材料细观力学分析模型,并对纤维增强机理进行了深入分析和探讨。     

硬硅钙石-SiO2气凝胶复合纳米孔超级绝热材料在钢结构防火中的应用探讨

将具有中空结构的硬硅钙石二次粒子和具有纳米孔结构的SiO2气凝胶用真空复合技术将其制备成具有良好绝热性能的绝热材料。用此材料包覆钢构件的防火保护方法具有防火涂料无法比拟的优点,是一种理想的钢结构耐火保护方式。介绍了该防火板的生产工艺、防火原理及施工方法,探讨了这种防护方法的特点及推广前景。     

制备工艺条件对SiO2气凝胶微球粒径及其均匀性的影响

为拓展SiO2气凝胶的应用范围,克服SiO2气凝胶微球制备技术中的不足,采用搅拌成球工艺以水玻璃为硅源在单一油相中制备了直径为2～1500μm的SiO2气凝胶微球,并研究了制备工艺条件对其粒径大小及均匀性的影响.研究结果表明,各个工艺条件之间互相关联和影响,成胶时间起着关键作用.当成胶时间适中或较长时,工艺条件中只有搅拌速度对粒径大小影响显著,同时所有工艺条件都对粒径的均匀性无明显影响;而成胶时间较短时,任一工艺条件的改变都会使粒径大小及均匀性发生变化.     

永磁电机的设计及工艺简介

永磁电机是一种节能产品。近年来,国外的永磁电机发展迅速,特别是稀土永磁材料,先后出现了两次重大突破,使永磁电机重量、性能、价格等指标提高到一个新的水平。我国研制永磁电机起步较晚,是一个急待开发的品种,有其广阔的前景。为了引起各有关方面的重视和普及这方面的知识,从本期起特请本文作者综合最新国内外资料对永磁电机的材料、设计、工艺、测量作一系统介绍,供广大读者和有关领导参考。     

树脂厌氧附着膜膨胀床污泥特性研究

采用载体吸附法培养出高活性的生物膜颗粒污泥,并对连续运行期间的污泥浓度、生物膜活性及生物膜厚度等特性进行研究,以了解该工艺高效稳定运行的生物学机制。试验装置采用AAFEB反应器,投加模拟污水,裸载体为树脂（平均粒径0．45～0．60mm）。试验运行了320d,反应器内最大污泥浓度30．14g/L,最高容积负荷46kgCOD／m^3·d,COD去除率80％-95％。