Conversion of acrylonitrile-based precursors to carbon fibres

The progress of stabilization of two compositions of acrylic fibres with various orientations has been followed by a variety of techniques. The thermooxidative treatments for stabilization have been carried out in a continuous process and also in a batch process under free shrinkage, constant length and constant tension conditions. The morphological model of acrylic fibres consists of an alternating sequence of laterally ordered and laterally disordered regions along the fibre direction. This structure is consistent with the observations based on small-angle X-ray scattering of copper- impregnated precursor fibres and thermomechanical response, thermal stress development, calorimetry, wide- and small-angle X-ray scattering and sonic modu-lus measured at different extents of stabilization. Lateral as well as orientational order in these fibres can be increased markedly through a high-temperature deformation process prior to stabilization. An increase in perfection and extent of order is observed in the early stages of stabilization. There is also a simultaneous decrease in the orientation of the disordered phase at this stage and the extent of this decrease depends on the axial constraints imposed on the fibre. Little difference in the rate of stabilization is observed as measured by density or oxygen uptake for fibres with different extents of orientation, lateral order or restraint. Fibres containing itaconic add, a stabilization catalyst did show an increased rate of stabilization. Inferences have been drawn regarding additional research pertaining to achieving high order in precursor fibres, minimizing orientational relaxation during oxidative stabilization, and the techniques for monitoring the extents of the stabilization treatment and the changes in relevant morphological parameters.     

Age and gender differences in cardiac reactivity and subjective emotion responses to emotional autobiographical memories.

This research reports age and gender differences in cardiac reactivity and subjective responses to the induction of autobiographical memories related to anger, fear, sadness, and happiness. Heart rate (HR) and subjective state were assessed at baseline and after the induction of each emotion in 113 individuals (61 men, 52 women; 66% European American, 34% African American) ranging in age from 15 to 88 years (M = 50.0; SD = 20.2). Cardiac reactivity was lower in older individuals; however, for anger and fear, these age effects were significantly more pronounced for the women than the men. There were no gender differences in subjective responses, however, suggesting that the lower cardiac reactivity found among older people is dependent on gender and the specific emotion assessed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Hiding biometric data

With the wide spread utilization of biometric identification systems, establishing the authenticity of biometric data itself has emerged as an important research issue. The fact that biometric data is not replaceable and is not secret, combined with the existence of several types of attacks that are possible in a biometric system, make the issue of security/integrity of biometric data extremely critical. We introduce two applications of an amplitude modulation-based watermarking method, in which we hide a user's biometric data in a variety of images. This method has the ability to increase the security of both the hidden biometric data (e.g., eigen-face coefficients) and host images (e.g., fingerprints). Image adaptive data embedding methods used in our scheme lead to low visibility of the embedded signal. Feature analysis of host images guarantees high verification accuracy on watermarked (e.g., fingerprint) images.     

Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

A single-chip 12.7 Mchips/s digital IF BPSK direct sequencespread-spectrum transceiver in 1.2 μm CMOS

This paper describes a fully integrated digital-spread spectrum transceiver chip fabricated through MOSIS in 1.2 μm CMOS. It includes a baseband spread spectrum transmitter and a coherent intermediate frequency (IF) receiver consisting of a Costas loop, an acquisition loop for the pseudo-noise (PN) sequence, and a clock recovery loop with a 406.4 MHz onchip numerically controlled oscillator (NCO). The transceiver is capable of operating at a maximum IF sampling rate of 50.8 MS/s and a maximum chip rate of 12.7 R Mchips/s (Mcps) with selectable data rates of 100, 200, 400, and 800 kbps. At the maximum operating speed of 50.8 R MS/s, it dissipates 1.1 W. In an additive white Gaussian noise channel the IF receiver achieves a receiver output SNR within 1 dB of theory and can acquire code with a wide range of input SNR from -17 dB to over 30 dB. The transceiver chip has been interfaced to an RF up/down converter to demonstrate a wireless voice/data/video link operating in the 902-928 MHz band     

Termination of pregnancy at 9-13 weeks' amenorrhoea with mifepristone and misoprostol

The effectiveness of a combined regimen of mifepristone and vaginal misoprostol for termination of pregnancies of 9-13 weeks of gestation was investigated in 120 UK abortion patients (median age, 22.1 years; median duration of amenorrhea, 10.3 weeks). Each woman received a single oral dose of 200 mg of mifepristone 36-48 hours before admission, at which time 800 mcg of misoprostol was administered vaginally. Where indicated, a further two doses of 400 mcg of misoprostol (vaginal or oral) were provided every 3 hours. All 120 women aborted on the day of prostaglandin administration; however, 6 women (5%) required exploratory curettage after the procedure for retained placenta. The median prostaglandin dose was 1200 mcg (range, 800-1600 mcg). The median time from misoprostol administration to abortion was 4.33 hours (range, 1.3-16.0 hours). 60 women (50%) required oral analgesics and 26 (22%) received parenteral analgesia. Diarrhea occurred in 38 women (32%). The median duration of bleeding after abortion was 12.5 days (range, 3-43 days). In questionnaires administered to 73 women, only 3 (4%) expressed dissatisfaction with medical abortion, because of pain or prolonged bleeding. The relatively high dose of misoprostol used in this study and the vaginal route of administration are presumed to account for the 95% success rate. Extension of medical abortion to later gestation times would decrease the need for surgery and expand women's choice of methods of pregnancy termination.     

A Review of Dynamic Fracture Studies in Functionally Graded Materials

Abstract:  This article presents a review of dynamic fracture studies on functionally graded materials. A brief literature review on the fracture mechanics of graded materials is presented first. This is followed by a discussion on the higher-order asymptotic analysis of the transient elastic field surrounding the tip of a dynamically growing crack in a functionally graded material. A comprehensive experimental study of dynamic crack growth in model functionally graded material using the optical method of reflection photoelasticity and high-speed photography is then presented. The results are analysed to establish a generalised relationship between the crack velocity and the dynamic mode-I stress intensity factor (SIF). This relationship is found to be unique and is distinctly different from that previously established for the matrix material (polyester). Finally, an innovative experimental procedure is used to demonstrate the necessity of employing a fully transient stress-field representation in the analysis of optical data for an accurate prediction of the dynamic SIF history.