Adaptive viewpoints for co-browsing on heterogeneous devices

Co-browsing is an activity in which a group of users navigate their way through of a set of Web pages together for a shared purpose. Effective co-browsing among users with different device capabilities requires a shared understanding of those Web pages. This paper demonstrates the concept of shared viewpoints (SVPs), and personal viewpoints (PVPs), for co-browsing, before detailing a framework for implementing these concepts. Finally, the effectiveness of the framework is presented through a perceptual experiment.     

InP D-HBT ICs for 40-Gb/s and higher bitrate lightwave transceivers

The combination of device speed (f/sub T/, f/sub max/ > 150 GHz) and breakdown voltage (V/sub bceo/ > 8 V) makes the double heterojunction bipolar InP-based transistor (D-HBT) an attractive technology to implement the most demanding analog functions of 40-Gb/s transceivers. This is illustrated by the performance of a number of analog circuits realized in an InP D-HBT technology with an 1.2- or 1.6-/spl mu/m-wide emitter finger: a low phase noise push-push voltage-controlled oscillator with -7-dBm output power at 146 GHz, a 40-GHz bandwidth and low-jitter 40-Gb/s limiting amplifier, a lumped 40-Gb/s limiting driver amplifier with 4.5-V/sub pp/ differential output swing, a distributed 40-Gb/s driver amplifier with 6-V/sub pp/ differential output swing, and a number of distributed preamplifiers with up to 1.3-THz gain-bandwidth product.     

New encapsulation development for fine pitch IC devices

The continuous reduction of chip size driven by the market demand has a significant impact on circuit design and assembly process of IC packages. Shrinking chip size and increasing I/O counts require finer bond pad pitch and bond pad size for circuitry layout. As a result, serious wire deflection during transfer molding process could make adjacent wires short, and this issue becomes more critical as a smaller wire diameter has to be applied for the finer pitch wire bonded IC devices.This paper presents a new encapsulation process development for 50 μm fine pitch plastic ball grid array package. Since reduced wire diameter decreases the bending strength of bonded wires significantly, wire deflection during molding process becomes quite serious and critical. Experiments on conventional transfer molding were conducted to evaluate wire span threshold with 23.0 μm diameter gold wire. The results show that the wire span threshold is about 4.1 mm, which is much shorter than the wire span threshold of over 5.0 mm for wire with 25.4 μm diameter. Finite element analysis shows there is a significant difference in the wire deflection between 23.0 μm gold wire and 25.4 μm gold wire diameter under the same action of mold flow. A novel encapsulation method is introduced using non-sweep solution. The wire span could be extended to over 5.0 mm with wire sweep less than 1%. Reliability tests conducted showed that all the units passed 1000 temperature cycles (−55 to 125 °C) with JEDEC moisture sensitivity level 2a (60 °C/60% relative humidity for 120 h) and 3 times reflow (peak temperature at 220–225 °C). It is believed that this solution could efficiently overcome the risk of wire short issues and improve the yield of ultra fine pitch wire bonds in high-volume production.     

The sleeping dragon: Wind energy in the Asia-Pacific region

The Asia-Pacific region is one of the fastest growing regional economies in the world today. The region is home to over half of the global population and is one of the most important markets for multinational corporations to penetrate. The wind power sector is no exception. Wind resources remain untapped and the demand for electricity continues to grow as a result of expanding and modernizing economies. Godfrey Chua, Emerging Energy Research USA reports on the current status and development of the wind industry in the region.     

The glass fibre-polymer interface: II—Work of fracture and shear stresses

Pull-out experiments have been carried out on single production fibres under carefully controlled conditions. Four parameters were determined. The interfacial yield stresses, of about 9–14 MPa, were very much smaller than the shear strengths of the bulk polymers in the case of an epoxy, whether post-cured or not, and a non-post-cured polyester. Values for the work of fracture of the interface varied from 140 to 300 Jm^?2, and again were less than those of the polymer. Interface failure sometimes took place in the epoxy rather than at the fibre surface, whereas with the polyester it always took place at the fibre surface. After interface failure, pull-out was governed by friction, with maximum shear stresses of 7–10 MPa for polyester, and 21–34 MPa for epoxy, the higher values being obtained for the post-cured resins. Average frictional shear stresses were sometimes less than a half of the maximum shear stress, indicating that the fibre Poisson's shrinkage was playing an important role in the pull-out process. A silicone release agent reduced the frictional shear stresses to 2·5 MPa, with both resins.     

A new method for seed oil body purification and examination of oil body integrity following germination

Plant seeds store triacylglycerols as energy sources for germination and postgerminative growth of seedlings. The triacylglycerols are preserved in small, discrete, intracellular organelles called oil bodies. A new method was developed to purify seed oil bodies. The method included extraction, flotation by centrifugation, detergent washing, ionic elution, treatment with a chaotropic agent, and integrity testing by use of hexane. These processes subsequently removed non-specifically associated or trapped proteins within the oil bodies. Oil bodies purified by this method maintained their integrity and displayed electrostatic repulsion and steric hindrance on their surface. Compared with the previous procedure, this method allowed higher purification of oil bodies, as demonstrated by SDS-PAGE using five species of oilseeds. Oil bodies purified from sesame were further analyzed by two-dimensional gel electrophoresis and revealed two potential oleosin isoforms. The integrity of oil bodies in germinating sesame seedlings was examined by hexane extraction. Our results indicated that consumption of triacylglycerols reduced gradually the total amount of oil bodies in seedlings, whereas no alteration was observed in the integrity of remaining oil bodies. This observation implies that oil bodies in germinating seeds are not degraded simultaneously. It is suggested that glyoxisomes, with the assistance of mitochondria, fuse and digest oil bodies one at a time, while the remaining oil bodies are preserved intact during the whole period of germination.     

Gastrointestinal autonomic nerve tumour presenting as small bowel volvulus: a rare disease with a rare presentation

A 78-year-old Chinese woman presented with recurrent postprandial abdominal pain. Computerised tomography revealed a small bowel tumour causing volvulus of a segment of the small bowel. Laparotomy confirmed an extraluminal ileal tumour with partial volvulus of the involved small bowel segment. Small bowel resection was done. Histological and ultrastructural studies confirmed a gastrointestinal autonomic nerve tumour. We review the medical literature on this rare tumour.