Suggestions to the article: medical professionalism research characteristics and hotspots

Scientometrics - The article published on 5 July 2021 is well-written and of interest. However, some improvements could be made, such as ten Tables/Figures can be shortened to highlight the focused...     

Analysis and architecture design of variable block-size motion estimation for H.264/AVC

Variable block-size motion estimation (VBSME) has become an important video coding technique, but it increases the difficulty of hardware design. In this paper, we use inter-/intra-level classification and various data flows to analyze the impact of supporting VBSME in different hardware architectures. Furthermore, we propose two hardware architectures that can support traditional fixed block-size motion estimation as well as VBSME with less chip area overhead compared to previous approaches. By broadcasting reference pixel rows and propagating partial sums of absolute differences (SADs), the first design has the fewer reference pixel registers and a shorter critical path. The second design utilizes a two-dimensional distortion array and one adder tree with the reference buffer that can maximize the data reuse between successive searching candidates. The first design is suitable for low resolution or a small search range, and the second design has advantages of supporting a high degree of parallelism and VBSME. Finally, we propose an eight-parallel SAD tree with a shared reference buffer for H.264/AVC integer motion estimation (IME). Its processing ability is eight times of the single SAD tree, but the reference buffer size is only doubled. Moreover, the most critical issue of H.264 IME, which is huge memory bandwidth, is overcome. We are able to save 99.9% off-chip memory bandwidth and 99.22% on-chip memory bandwidth. We demonstrate a 720-p, 30-fps solution at 108 MHz with 330.2k gate count and 208k bits on-chip memory.     

The Synthesis of Sulfated Titanium Oxide Nanotubes

TiO₂ nanotubes can be prepared in gram quantities by treating anatase TiO₂ powder with concentrated NaOH solution. These TiO₂ nanotubes acquired strong acidity after being impregnated with sulfuric acid solution and calcined at 300 °C. The anatase TiO₂ powder used to prepare the nanotube did not catalyze the esterification between cyclohexanol and acetic acid, while sulfated TiO₂ nanotubes were very reactive toward the esterification reaction.     

Experimental determination of NH<Subscript>4</Subscript>NO<Subscript>3</Subscript>-KNO<Subscript>3</Subscript> binary phase diagram

The solid-state phase transitions in ammonium nitrate (AN)-potassium nitrate (KN) system, and the equilibrium AN-KN phase diagram have been determined by using differential scanning calorimetry and high-temperature in situ x-ray diffractometry. Sample preparation was performed in a special “dry room” with very low humidity. A single phase region (AN III) with no phase transitions to 373 K was observed in the composition range 5 to 20% KN; this is critical for use in air bag gas generators. The high-temperature KN phase (KN I) has a wide range of stability from 20 to 100 wt.% KN. There are one eutectic, two eutectoid, three peritectoid, and one congruent transformations in this phase diagram. Two new nonstoichiometric phases were found at lower temperatures in the mid-composition range between the AN and KN terminal solid solutions. Details of the phase equilibria are presented.     

Optimum power-saving method for power MOSFET width of DC/DC converters

An optimum power metal-oxide-semiconductor field effect transistor (MOSFET) width technique is proposed for enhancing the efficiency characteristics of switching DC-DC converters. By implementing a one-cycle buck DC-DC converter, it is demonstrated that the dynamic power MOSFET width controlling technique has a much improved power reduction whether the load current is light or heavy. The maximum efficiency of the buck converter is ~92% with a 3% efficiency improvement for the heavy load condition. The efficiency is further improved by ~16% for the light load condition as a result of the power reduction from the large power MOSFET transistors. Also proposed is a new error-correction loop circuit to enable a better load regulation than that of previous designs. Compared with the adaptive gate driver voltage technique, the optimum power MOSFET width can achieve a significant improvement in power saving. It is also superior to the low-voltage-swing MOSFET gate drive technique for switching DC-DC converters     

Intravaginal Controlled Administration of Flurogestone Acetate: (III) Development of Rate-Control Vaginal Devices

A Rate-Control vaginal device was developed which overcomes the low bioavailability and unpredictable Q - t^1/2 type release and absorption rate profiles of flurogestone acetate delivered by the currently marketed Syncro-Mate pessary.

The in vitro release and vaginal absorption profiles from the Rate-Control vaginal device were run simultaneously, a linear Q - t relationship was obtained with a significant improvement in bioavailability. A mathematical model was developed to correlate the in vitro drug release and the vaginal absorption profiles of flurogestone acetate from the vaginal devices.

The design, development and the simultaneous release and absorption profiles of flurogestone acetate from this new vaginal device were outlined and discussed.     

Babesial antibody dynamics after cattle immunisation with live vaccines, measured with an indirect immunofluorescence test

The efficacy of vaccination of Argentinean cattle against babesiosis and anaplasmosis using live immunogens was tested to detect specific antibodies in samples obtained about 60 days after vaccination. Under these conditions a higher than expected proportion of cattle failed to show antibodies against Babesia bigemina. Therefore, a study was designed to evaluate if this failure was due to insensitivity of the routine test to detect antibodies to B. bigemina or to lack of infectivity of the live vaccine. Four groups (G) of cattle were each inoculated subcutaneously with 10 million Babesia bovis (vaccinal strain R1A), 10 million B. bigemina (vaccinal strain S1A) and 10 million Anaplasma centrale (strain M1). G1 and G2 consisted of ten Angus bulls 20-24 months old and ten Angus bulls 15-18 months old, respectively; G3 and G4 consisted of ten and 16 Holstein 1-month-old male calves, respectively. Blood samples were obtained on days 0, 10, 20, 30, 40, 50 and 60 after vaccination and the sera were analysed with an indirect immunofluorescent (IFA) test to detect antibodies to B. bovis (baseline dilution for a positive result 1:60) and B. bigemina (baseline dilution 1:120). Positive IFA titres were considered as evidence of the infectivity of the Babesia vaccinal strains contained in the vaccine. All Angus bulls were found positive to antibodies against both Babesia species, by day 20 (B. bovis) and day 30 (B. bigemina), whereas 10-25% of Holstein calves were negative throughout. The partial lack of vaccine infectivity in the calves was considered to be a consequence of innate resistance of young calves to Babesia. Antibody titres to B. bovis and B. bigemina declined by day 60 after vaccination. However, all cattle that were positive to B. bovis antibodies on day 50 were still positive to the IFA test 10 days later while 10%, 30% and 12% of cattle of G1, G2 and G3 that were positive to B. bigemina antibodies on day 50 after vaccination were found negative to the IFA test on day 60. In future, samples taken on days 40-50 will be used for detection of B. bigemina antibodies in vaccinated cattle, on day 60 for A. centrale and on either occasion for B. bovis. The reaction to the inoculation of B. bigemina S1A strain appears to lag behind the reaction to B. bovis R1A strain. It is not certain if this is a normal reaction to this B. bigemina strain or the result of interaction with the B. bovis strain.