A new monitoring system for piping systems in fossil fired power plants

A CEC-funded project has been performed to tackle the problem of producing an advanced Life Monitoring System (LMS) which would calculate the creep and fatigue damage experienced by high temperature pipework components. Four areas were identified where existing Life Monitoring System technology could be improved:

1. 1. the inclusion of creep relaxation

2. 2. the inclusion of external loads on components

3. 3. a more accurate method of calculating thermal stresses due to temperature transients

4. 4. the inclusion of high cycle fatigue terms.

The creep relaxation problem was solved using stress reduction factors in an analytical in-elastic stress calculation. The stress reduction factors were produced for a number of common geometries and materials by means of non-linear finite element analysis. External loads were catered for by producing influence coefficients from in-elastic analysis of the particular piping system and using them to calculate bending moments at critical positions on the pipework from load and displacement measurements made at the convenient points at the pipework. The thermal stress problem was solved by producing a completely new solution based on Green's Function and Fast Fourier transforms. This allowed the thermal stress in a complex component to be calculated from simple non-intrusive thermocouple measurements made on the outside of the component. The high-cycle fatigue problem was dealt with precalculating the fatigue damage associated with standard transients and adding this damage to cumulative total when a transient occurred.

The site testing provided good practical experience and showed up problems which would not otherwise have been detected.     

Simulation of magnetic component models in electric circuitsincluding dynamic thermal effects

It is essential in the simulation of power electronics applications to model magnetic components accurately. In addition to modeling the nonlinear hysteresis behavior, eddy currents and winding losses must be included to provide a realistic model. In practice the losses in magnetic components give rise to significant temperature increases which can lead to major changes in the component behavior. In this paper a model of magnetic components is presented which integrates a nonlinear model of hysteresis, electro-magnetic windings and thermal behavior in a single model for use in circuit simulation of power electronics systems. Measurements and simulations are presented which demonstrate the accuracy of the approach for the electrical, magnetic and thermal domains across a variety of operating conditions, including static thermal conditions and dynamic self heating     

Efficient Spreadsheet Algorithm for First-Order Reliability Method

A new spreadsheet-cell-object-oriented algorithm for the first-order reliability method is proposed and illustrated for cases with correlated nonnormals and explicit and implicit performance functions. The new approach differs from the writers earlier algorithm by obviating the need for computations of equivalent normal means and equivalent normal standard deviations. It obtains the solution faster and is more efficient, robust, and succinct. Other advantages include ease of initialization prior to constrained optimization, ease of randomization of initial values for checking robustness, and fewer required optimization constraints during spreadsheet-automated search for the design point. Two cases with implicit performance functions, namely an asymmetrically loaded beam on Winkler medium and a strut with complex supports are analyzed using the new approach and discussed. Comparisons are also made between the proposed approach and that based on Rosenblatt transformation.     

Computer support for strategic organizational decision-making

While information systems continue to be promoted within organizations as tools to support strategic decision-making, there is growing concern over the ability of such systems to model the social and political complexity of the situations to which they are being applied. This paper examines the nature of organizational decision-making and the use of computer-based systems to support this activity. The debate queries the extent to which such artifacts should be allowed to become enmeshed and embedded within the strategic decision-making activities of organizations which operate within increasingly complex environments.     

Stem cells in prostatic epithelia

The normal prostate is, structurally and functionally, a highly complex glandular tissue in which populations of epithelial and stromal cells interact, one with the other, and are under a constant state of proliferation, differentiation, elimination and selective secondary replenishment so that functional integrity of the tissue is maintained. The ability of normal prostatic tissue to maintain its structure and function is dependent upon retention of cells, generally regarded as 'stem cells', which are able to respond by proliferation and selective differentiation within a wide range of phenotypic alternatives. With respect to cells in the epithelial compartment, replenishment is possible at several levels from within distinct pathways of normal cellular differentiation. It is now appreciated that fully differentiated prostatic epithelial cells retain a far greater degree of phenotypic 'plasticity' than was earlier apparent from morphological examination of the intact tissue. This inherent plasticity, coupled with the ability of the intact tissue to respond to diverse environmental (particularly humoral) stimuli by regenerating a wide and divergent spectrum of functional prostatic epithelial phenotypes is its strength--but also its weakness. Disturbance and distortion of the homeostatic regulatory mechanisms, whether physical or humoral, which control the normal sequence of epithelial proliferation, differentiation and elimination exposes these cells, particularly multipotent 'stem cells', to an increased probability of genetic change, thus resulting in either transient, or permanent, neoplastic transformation.     

Experimental fetal tracheal ligation reverses the structural and physiological effects of pulmonary hypoplasia in congenital diaphragmatic hernia

Infants with congenital diaphragmatic hernia (DH) and profound pulmonary hypoplasia are currently unsalvageable. The authors previously demonstrated that tracheal ligation (TL) accelerates fetal lung growth and reverses the pulmonary hypoplasia of fetal nephrectomy. The purpose of this study was to determine if the pulmonary hypoplasia of experimental DH could be similarly reversed and, if so, whether the resulting lungs would show better function than those of their DH counterparts. Eighteen fetal lambs were divided into three experimental groups of six animals each. In group 1, DH was created at 90 days' gestation. In group 2, DH was created at 90 days' gestation and TL performed during the same operation. Group 3 consisted of sham-operated controls. These animals were delivered near full-term, and their lungs analyzed by standard morphometric techniques. Ten additional fetal lambs were divided into two experimental groups of five animals each. In group 4, DH was created at 90 days' gestation. In group 5, DH was created at 90 days' gestation and TL performed 20 days later, at 110 days' gestation. These animals were pressure-ventilated via tracheostomy over a 2-hour period in which PaO2, PaCO2, and compliance were measured. Intratracheal pressure (ITP) was measured at the time of delivery in all groups. Upon retrieval, DH animals had abdominal viscera in the chest and small lungs; in contrast, DH/TL animals had the herniated viscera reduced from the chest by enlarged lungs. DH/TL lungs showed markedly increased growth, with significant increases in lung volume:body weight ratio (LV:BW; P = .0001), alveolar surface area (ALV.SA; P = .0001), and alveolar number (ALV#) (P = .0001) when compared with those of the DH or control group. This growth was associated with a normal maturation pattern based on histological appearance, normal airspace fraction, and normal alveolar numerical density. ITP in the DH/TL group was increased when compared with that of DH and control animals (P = .0001). Total lung DNA and protein were both elevated in the DH/TL animals (P = .0001). However, the DNA:protein ratio remained normal, suggesting lung growth had occurred through cell proliferation, not by hypertrophy. When ventilated over a range of settings, DH/TL lungs were more compliant (P = .0001) and achieved higher PaO2s (P < .003) and lower PaCO2s (P = .0001) than their DH counterparts. From these data, the authors conclude: (1) Experimental fetal DH produces hypoplastic lungs that are not capable of adequate gas exchange with conventional ventilation.(ABSTRACT TRUNCATED AT 400 WORDS)     

Genetic control of immunity to Heligmosomoides polygyrus: presentation of promiscuous antigens to parasite-specific T cell hybridomas

The role of MHC class II in the presentation of Heligmosomoides polygyrus antigens has been investigated, using a number of T cell hybridomas produced in A and E positive and negative mice. By using fixed and irradiated antigen presenting cells (APC), further evidence has emerged, to support earlier data, that there can be differential processing requirements during the presentation of H. polygyrus antigens by A and E molecules. In concordance with these earlier observations, this work provides further evidence than individual T cells can respond to antigen when presented by more than one MHC molecule. Previously, this evidence has been restricted to individual MHC molecules of the same haplotype, but these data show that H. polygyrus produces antigens which can be presented by both syngeneic and allogeneic MHC molecules. These antigens do not appear to be synonymous with the previously described H. polygyrus superantigen, as presentation is restricted to specific MHC haplotypes. It is proposed that H. polygyrus may produce these antigenic molecules as part of its strategy to manipulate the host immune system.     

Remote sensing of species mixtures in conifer plantations using LiDAR height and intensity data

In even-aged, single species conifer plantations LiDAR height data can be modelled to provide accurate estimates of tree height and volume. However, it is apparent that growth models developed for single species stands are not directly transferable to a more general situation of mixed species plantations. This paper evaluates the ability of small footprint, dual-return, pulsed airborne LiDAR data to estimate the proportion of the productive species when mixed with a nurse crop in closed canopy plantations. A study area located in Galloway Forest District in Scotland is used as an example of Lodgepole pine and Sitka spruce mixed plantation; this area contains good examples of a wide range of pure and mixed species plantation types. Three species groups are studied: areas of pure Sitka spruce, areas of pure Lodgepole pine and areas where the two species have been planted together. Two approaches are assessed for detection of plantation mixtures: the first uses LiDAR intensity data to separate spruce and pine species and the second uses LiDAR-derived canopy density measures, coefficient of variation, skewness, percent of ground returns (which provides a measure of canopy openness) and the mean canopy height, which enables areas with height variations to be identified. From analysis of LiDAR data extracted from 54 study plots using logistic regression, the coefficient of variation and LiDAR intensity data provide the most useful predictors of the proportion of spruce in a pine/spruce mixture with coefficients of determination (R²) of 0.914 and 0.930 respectively. The method could be developed as a mapping tool, which in combination with existing inventory data should help to improve timber volume forecasting for mixed species even-aged plantations.     

Foundations'' impact on policy making: results from a pilot study

Thirty-two consecutive patients with haematological disorders, in need of a permanent central venous catheter (CVC) were randomly allocated to have their CVC bandages (Tegaderm) changed once (OAW, n = 20) or twice (TAW, n = 19) a week. The two randomization arms were balanced in respect of age, sex, and underlying disease. The exit site of the CVC was inspected daily through the transparent bandage and erythema was noted. If severe erythema occurred, daily wet gauze dressings were applied. Samples for bacterial cultures were taken from the exit site of the CVC at every change of bandages. There was no difference in complications leading to removal of the CVC between the two groups (7/20 OAW vs. 7/19 TAW) or in CVC survival-time (P = 0.4). However, the OAW group had more positive CVC tip cultures (OAW 11/14 vs. TAW 2/9; P < 0.05) and a tendency to: (i) more extra dressings (P = 0.08); (ii) more cultures from the exit skin site showing high numbers of colony forming units (P = 0.07); (iii) shorter time to first exit site infection (P = 0.09); and (iv) more Gram-positive septicaemias (P = 0.08). Both clinical and bacteriological data in this study indicate that changing transparent polyurethane CVC bandages twice a week is superior to once a week.