Compton scattering in a large-aperture positron imaging system

Compton scattering of gamma rays within the image volume has been assessed for a large-aperture positron-emission-tomography imaging system. The Compton scattered attenuation and the Compton scattered background were both modeled and measured for point sources centered in scattering spheres up to 10 cm in diameter. Good agreement was obtained between simulations and measurements. The attenuation problem is independent of the detector system, but its correction is more difficult in a large-aperture system. The scattered coincidence background is large in this system (43% for a 10-cm-diameter scattering sphere), but the background overlap is reduced with 3D imaging.     

Invited article: development of high-field superconducting Ioffe magnetic traps

We describe the design, construction, and performance of three generations of superconducting Ioffe magnetic traps. The first two are low current traps, built from four racetrack shaped quadrupole coils and two solenoid assemblies. Coils are wet wound with multifilament NbTi superconducting wires embedded in epoxy matrices. The magnet bore diameters are 51 and 105 mm with identical trap depths of 1.0 T at their operating currents and at 4.2 K. A third trap uses a high current accelerator-type quadrupole magnet and two low current solenoids. This trap has a bore diameter of 140 mm and tested trap depth of 2.8 T. Both low current traps show signs of excessive training. The high current hybrid trap, on the other hand, exhibits good training behavior and is amenable to quench protection.     

A high-voltage cardiac stimulator for field shocks of a whole heart in a bath

Defibrillators are a critical tool for treating heart disease; however, the mechanisms by which they halt fibrillation are still not fully understood and are the subject of ongoing research. Clinical defibrillators do not provide the precise control of shock timing, duration, and voltage or other features needed for detailed scientific inquiry, and there are few, if any, commercially available units designed for research applications. For this reason, we have developed a high-voltage, programmable, capacitive-discharge stimulator optimized to deliver defibrillation shocks with precise timing and voltage control to an isolated animal heart, either in air or in a bath. This stimulator is capable of delivering voltages of up to 500 V and energies of nearly 100 J with timing accuracy of a few microseconds and with rise and fall times of 5 micros or less and is controlled only by two external timing pulses and a control computer that sets the stimulation parameters via a LABVIEW interface. Most importantly, the stimulator has circuits to protect the high-voltage circuitry and the operator from programming and input-output errors. This device has been tested and used successfully in field shock experiments on rabbit hearts as well as other protocols requiring high voltage.     

Thermal properties of highly birefringent optical fibers and preforms

Temperature cycling of highly birefringent optical fibers and preforms has been used to investigate the thermal properties of bow-tie and elliptically clad structures. The thermal hysteresis of the birefringence is shown to be a direct consequence of the thermal history of the fiber or preform and has been related to volume changes in the stress-producing borosilicate sections. Annealing increases the axial stress as well as the stress anisotropy and hence the birefringence. Increases of up to a factor of 2 in the birefringence on suitable thermal treatment indicate a new method for further improvement of high birefringence fibers. The implications of the results in the design, fabrication, and use of such fibers are discussed.     

Effects of ageing on the biomechanical properties of rat articular cartilage

Previous studies have demonstrated that male Sprague Dawley (SD) rats experience age-related bone loss with the same characteristics as that in ageing men. As articular cartilage, like bone, is a critical component of the health and function of the musculoskeletal system, the authors hypothesized that articular cartilage in the untreated male SD rats could be a suitable model for studying the age-related deterioration of articular cartilage in men. To test this hypothesis, male SD rats were killed at between 6 and 27 months. The right femur of each rat was removed. The effects of ageing on the structural integrity of the distal femoral articular cartilage were studied by biomechanical testing with a creep indentation apparatus. The aggregate modulus, Poisson's ratio, permeability, thickness, and percentage recovery of articular cartilage were determined using finite element/non-linear optimization modelling. No significant differences were observed in these biomechanical properties of the distal femoral articular cartilage as a function of age. Therefore, untreated male SD rats appear to be unsuitable for studying the age-related changes of articular cartilage as they occur in men. However, and more intriguingly, it is also possible that ageing does not affect the biomechanical properties of articular cartilage in the absence of cartilage pathology.     

Numerical simulation of an arbitrarily ended asymmetrical slab waveguide by guided-mode extracted integral equations

The scattering phenomenon from an arbitrary-shaped end of a asymmetrical slab waveguide for the cases of TE and TM guided modes is simulated by means of boundary integral equations that are called guided-mode extracted integral equations. The integral equations that we derive can be solved by the conventional boundary-element method. Numerical results are presented for problems of three-layer asymmetrical waveguides with tilted ends. The reflection coefficient, reflected and scattered powers, and radiation patterns are calculated numerically for the cases of incident TE and TM guided modes.     

Speckle-contrast monitoring of tissue thermal modification

Measurements of the contrast value of time-averaged speckle-modulated images of cartilage tissue are used to study tissue thermal modification in the case of laser-light treatment. This modification is related to thermally induced internal stress relaxation in the matrix of the treated tissue. The specific feature of the evolution of time-averaged speckle contrast with a change in the current temperature of modified collagen tissue is the typical looplike form of the contrast-temperature dependencies associated with irreversible changes in tissue structure and correlated with changes in the tissue diffuse transmittance and the tissue internal stress mentioned by other researchers.     

Angle- and size-dependent characteristics of incoherent Raman and fluorescent scattering by microspheres. 1. General expressions

A dipole model is used to simulate incoherent Raman and fluorescent scattering by microspheres. The use of the addition theorem for spherical harmonics circumvents the need to evaluate double sums in the final formulas, thereby drastically reducing computational effort. Special attention is paid to consideration of backscattering geometry, which is important for lidar applications. The formulas derived for backscattering geometry decrease the computation time for size parameter x approdximately 100 by a factor of 200 compared with the time for calculations performed at other angles.