Analysis of XANES for identification of highly dispersed transition metal oxides on supports

XANES of vanadium and niobium oxide on silica or alumina have been analyzed quantitatively by a deconvolution technique. Based on the results for reference compounds, local structures of supported vanadium and niobium species were identified. The composition was estimated from difference spectra for the samples which consisted of two kinds of species.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

A parallel algorithm for time-slot assignment problems in TDMhierarchical switching systems

The paper presents a parallel algorithm for time-slot assignment problems in TDM hierarchical switching systems, based on the neural network model. The TDM systems are operated in repetitive frames composed of several time-slots. A time-slot represents a switching configuration where one packet is transmitted through an I/O line. The goal of the algorithm is to find conflict-free time-slot assignments for given switching demands. The algorithm runs on a maximum of n²×m processors for m-time-slot problems in n×n TDM systems. In small problems up to a 24×24 TDM system, the algorithm can find the optimum solution in a nearly constant time, when it is performed on n²×m processors     

Optimal Digital Controller Design for a Servo Motor Taking Account of Intersample Behavior

A continuous‐time plant with a discretized continuous‐time controller does not yield stability if the sampling rate is lower than some certain level. Thus far, high‐performance electronic control has made use of expensive hardware needed to implement discretized continuous‐time controllers; low‐cost hardware generally does not have a sufficiently high sampling rate. This technical note presents results comparing performance indexes with and without intersample behavior, and provides some answers to the question of how a low‐specification device can control a plant effectively. We consider a machine simulating wafer handling robots, which is an electromechanical system driven by a direct drive motor, at a semiconductor factory. We illustrate the controller design for the robot with and without intersample behavior, and present simulations and experimental results using these controllers. Taking intersample behavior into account proves to be effective in improving control performance and makes it possible to choose a relatively long sampling period. Controller design in terms of the performance index with intersample behavior makes it possible to deal with situations in which a sufficiently short sampling period may not be employed, and freedom of controller design may be widened, especially regarding the choice of the sampling period.     

Effects of Atmospheric Composition on the Molecular Structure of Synthesized Silicon Oxycarbides

The dependence of silicon oxycarbides' chemical composition and molecular structure on their reaction conditions was tested by varying the atmosphere under which pyrolysis was performed. To obtain the silicon oxycarbides, densely cross‐linked silicone resin particles with an averaged diameter of 2 μm were pyrolyzed in various atmospheres of H₂, Ar, and CO₂, in the temperature range 700°C–1100°C. The residual mass of resin after pyrolysis was almost constant at 700°C, although their apparent colors varied distinctly. The sample obtained from the H₂ atmosphere was white, whereas that obtained from the CO₂ atmosphere was dark brown. Fourier‐transform infrared (FT‐IR) spectra of the residues suggested that the Si–O–Si network evolution was accelerated in the CO₂ atmosphere. Beyond 800°C, the chemical compositions of the compounds obtained from a H₂ atmosphere increasingly approached near‐stoichiometric SiO₂–xSiC composition with increasing the pyrolysis temperature. Compounds from a CO₂ atmosphere approached a composition of SiO₂–xC with no free SiC as the pyrolysis temperature increased. In the products from an Ar atmosphere, SiO₂–xSiC–yC compositions were typically obtained. The observed effects of the pyrolysis atmosphere on the resulting chemical compositions were analyzed in terms of thermodynamic calculations. Electron spin resonance (ESR) spectra revealed broad and intense signals from products obtained from either Ar or CO₂. Estimating from the signal intensity, the residual spin concentrations were in the range 10¹⁸–10¹⁹ g^?1. Meanwhile, the spectra from the samples obtained in H₂ showed weak and sharp signals with estimated spin concentrations ranging from 10¹⁶–10¹⁷ g^?1. This signal attenuation may have been due to the hydrogen capping of dangling bond formed during pyrolysis.     

Surgical strategy for patients with pancreaticobiliary maljunction without choledocal dilatation

Theory-driven investigations are necessary for generalization of findings and development of health care policy. Within the environments where nurses practice, however, there often is insufficient time to develop a theory base that supports practice changes or the investigation of their effects. Theories that support such investigations need to incorporate elements associated with both the structure and the process of care delivered as well as the outcomes expected. These same theories also need to specify the focal level of interest for research questions. Incorporating a research template to guide practice investigations facilitates decision making and collection of data.     

The use of indoline dyes in a zinc oxide dye-sensitized solar cell

The effects of the position and the type of carboxyl anchor group in double rhodanine-type indoline dyes on the performance of a zinc oxide dye-sensitized solar cell were examined. The optimum position for the carboxymethyl group was on the inner rhodanine moiety; a carboxymethyl group gave optimum results among carboxymethyl, -ethyl, and -propyl derivatives.     

A parallel improvement algorithm for the bipartite subgraph problem

The authors propose the first parallel improvement algorithm using the maximum neural network model for the bipartite subgraph problem. The goal of this NP-complete problem is to remove the minimum number of edges in a given graph such that the remaining graph is a bipartite graph. A large number of instances have been simulated to verify the proposed algorithm, with the simulation result showing that the algorithm finds a solution within 200 iteration steps and the solution quality is superior to that of the best existing algorithm. The algorithm is extended for the K-partite subgraph problem where no algorithm has been proposed.     

Detection of enzymatically generated hydrogen peroxide by metal-based fluorescent probe

We developed a metal-based fluorescent probe for H(2)O(2) called MBFh1, which has an iron complex as a reaction site for H(2)O(2) and a 3,7-dihydroxyphenoxazine derivative as the fluorescent reporter unit. The iron complex reacts quickly with H(2)O(2) to form oxidants, and then the oxidants convert the closely appended nonfluorescent 3,7-dihydroxyphenoxazine moiety to resorufin in an intramolecular fashion. The quick response to H(2)O(2) allows us to plot the enzymatic evolution of H(2)O(2). A combination of N-acetyl-3,7-dihydroxyphenoxazine and horseradish peroxidase has been frequently used to detect enzymatically generated H(2)O(2), but this method has interference with phenol derivatives. The use of MBFh1 overcomes this drawback.     

Multicentric Castleman''s disease associated with renal amyloidosis and pure red cell aplasia

Researchers have recently proven the ability of computer simulation to predict the behaviour of cerebral aneurysms. Accurately simulating the flow of blood within the aneurysm helps researchers to predict the growth pattern of the aneurysm and the danger of rupturing. As this tool is further developed into a practical diagnostic tool, it is expected to dramatically improve the ability of surgeons to weigh the results of alternate treatment methods. The simulation method used, computational fluid dynamics (CFD), provides much more information than current diagnostic tools, including particularly shear stress levels at various stages of the cardiac cycle, which help to pinpoint areas of aneurysm formation and growth.