Parallel path consistency

Filtering algorithms are well accepted as a means of speeding up the solution of the consistent labeling problem (CLP). Despite the fact that path consistency does a better job of filtering than arc consistency, AC is still the preferred technique because it has a much lower time complexity. We are implementing parallel path consistency algorithms on multiprocessors and comparing their performance to the best sequential and parallel arc consistency algorithms.^(1,2) (See also work by Kerethoet al. ⁽³⁾ and Kasif⁽⁴⁾) Preliminary work has shown linear performance increases for parallelized path consistency and also shown that in many cases performance is significantly better than the theoretical worst case. These two results lead us to believe that parallel path consistency may be a superior filtering technique. Finally, we have implemented path consistency as an outer product computation and have obtained good results (e.g., linear speedup on a 64K-node Connection Machine 2).     

重馏分油加氢脱氮反应动力学模型的研究

简要地介绍了一些典型的模型氮化物的ＨＤＮ反应规律。根据胜利ＶＧＯ在３７２２Ｂ催化剂上的大量ＨＤＮ实验数据，提出了如下的ＨＤＮ基本反应动力学方程：ｄＣＮｄｔ＝－ｋ１＋Ｋ＊ＣＮＣＮＰＨ２为了扩大上式的应用范围，详细分析了各种因素（如原料油种类和馏程及Ｈ２Ｓ等）对ＨＤＮ的影响，并开发了相应的经验关联式，从而得到了一个较完整的馏分油ＨＤＮ反应动力学模型。验证实验表明，该模型是成功的。     

A new boundary-layer wind tunnel at the Danish Maritime Institute

The paper describes a new boundary-layer wind tunnel at the Danish Maritime Institute in Lyngby. The wind tunnel is of the open-circuit type and is integrated into a building raised for the purpose. The design was constrained by the need to provide a simulation of the atmospheric boundary layer (without thermal stratification) and alternatively a uniform flow without excessive turbulence.The wind tunnel has a working section of principal dimensions: length 20.8 m, width 2.6 m and height 1.8 m (adjustable from 1.8 to 2.3 m). The maximum wind speed in the working section when empty is about 26 m s^?1.Data acquisition, analysis and instrumentation in relation to the new wind tunnel are discussed and, finally, an example of a simulated natural wind is presented.     

2 cm long monolithic multisection laser for active modelocking at 2.2 GHz

A 2 cm long three-contact multisection laser has been fabricated for modelocking at very low repetition rates. Active modelocking yields 8.0-12.3 ps pulses at 2.2, 4.3 and 6.5 GHz corresponding to the fundamental, first, and second harmonics of the cavity resonance frequency. This device demonstrates the feasibility of fabricating monolithic pulse sources operating at rates as low as the OC-48 Sonet transmission rate (2.488 Gbit/s).<>     

Use of exercise technetium-99m sestamibi SPECT imaging to detect residual ischemia and for risk stratification after acute myocardial infarction

The clinical presentation, electrocardiographic findings, and technetium-99m sestamibi single-photon emission computed tomography (SPECT) imaging results of 134 consecutive patients who underwent nuclear exercise testing within 14 days of an acute myocardial infarction (AMI) were correlated with cardiac events over a 15 +/- 10-month follow-up. Whereas only 23 patients (17%) had chest pain and 31 (23%) had ischemic ST-segment depression during exercise, 94 (70%) had ischemia on SPECT (p < 0.001). On follow-up, 13 patients experienced a cardiac event: 7 were rehospitalized for unstable angina, 3 had recurrent AMI, and 3 died of cardiac causes. Ischemia on the sestamibi images identified 11 of these patients (85%), whereas chest pain identified only 3 (23%, p = 0.006), and electrocardiographic ischemia identified only 4 (31%, p = 0.017). The presence of either ischemia as seen on SPECT or defects in multiple vascular territories identified 12 patients (92%) with an event, including all who had cardiac death. By Cox regression analysis of clinical, stress, and image parameters, the number of ischemic defects on SPECT was the only significant correlate of a future event (chi-square = 4.62, p = 0.03), and patients with > or = 3 reversible sestamibi defects had an event rate of 38%. The extent of ischemia as seen on nuclear imaging remained a strong correlate (p = 0.008) of an event in the 54 patients (40%) who had received thrombolytic therapy. Thus, exercise technetium-99m sestamibi SPECT after AMI frequently reveals residual ischemia, and is better than clinical data, symptoms, and stress electrocardiographic data in identifying patients who will have a subsequent cardiac event.     

A nonlinear operator-based speech feature analysis method withapplication to vocal fold pathology assessment

Traditional speech processing methods for laryngeal pathology assessment assume linear speech production with measures derived from an estimated glottal flow waveform. They normally require the speaker to achieve complete glottal closure, which for many vocal fold pathologies cannot be accomplished. To address this issue, a nonlinear signal processing approach is proposed which does not require direct glottal flow waveform estimation. This technique is motivated by earlier studies of airflow characterization for human speech production. The proposed nonlinear approach employs a differential Teager energy operator and the energy separation algorithm to obtain formant AM and FM modulations from filtered speech recordings. A new speech measure is proposed based on parameterization of the autocorrelation envelope of the AM response. This approach is shown to achieve impressive detection performance for a set of muscular tension dysphonias. Unlike flow characterization using numerical solutions of Navier-Stokes equations, this method is extremely computationally attractive, requiring only a small time window of speech samples. The new noninvasive method shows that a fast, effective digital speech processing technique can be developed for vocal fold pathology assessment without the need for direct glottal flow estimation or complete glottal closure by the speaker. The proposed method also confirms that alternative nonlinear methods can begin to address the limitations of previous linear approaches for speech pathology assessment     

Ligands with affinity to specific sequences of DNA base pairs. X. Synthesis and binding of netropsin analogs, containing a chelating copper ion peptide, with DNA

An analogue of netropsin has been synthesized consisting of two N-propylpyrrolcarboxamide units linked covalently to a copper-chelating tripeptide Gly-Gly-L-His by means of two and three glycine residues. Binding to DNA and synthetic polynucleotides of netropsin analogue containing three glycine residues between Gly-Gly-L-His tripeptide and the N-end of netropsin analogue (His-Nt) has been studied. It is shown that this netropsin analogue chelates a copper ion with 1:1 stoichiometry, similar to a free Gly-Gly-L-His peptide. It is found that this netropsin analogue occupies 3 to 4 base pairs upon binding to poly(dA).poly(dT) and poly[d(AT)].poly[d(AT)] polymers, irrespective of whether it binds in Cu(2+)-ligated or unligated forms. Binding constants and binding site sizes have been calculated for netropsin analogue complexes with DNA, poly(dA).poly(dT) and poly[d(AT)].poly[d(AT)] polymers at the [Cu2+]/[His-Nt] ratio equal to 0 and 1.0. In the three-component system including His-Nt and Cu(2+)-His-Nt, cooperative effects are recognized which can be explained by heterodimer generation on interaction of His-Nt and Cu(2+)-His-Nt at adjacent binding sites.