An investigation of the drivers,barriers, and incentives for environmental management systems in the Malaysian food and beverage industry

Clean Technologies and Environmental Policy - Food production and consumption is one of the major causes of global environmental degradation. One way to address environmental impacts in the food...     

Novel approaches to purifying bacteriocin: A review

ABSTRACT

Bacteriocin is a proteinaceous biomolecule produced by bacteria (both Gram-positive and Gram-negative) that exhibits antimicrobial activity against closely related species, and food-borne pathogens. It has recently gained importance and attracted the attention of several researchers looking to produce it from various substrates and bacterial strains. This ushers in a new era of food preservation where the use of bacteriocin in food products will be an alternative to chemical preservatives, and heat treatment which are understood to cause unwanted side effects, and reduce sensory and nutritional quality. However, this new market depends on the success of novel downstream separation schemes from various types of crude feedstocks which are both effective and economic. This review focuses on the downstream separation of bacteriocin from various sources using both conventional and novel techniques. Finally, recommendations for future interesting areas of research that need to be pursued are highlighted.     

Uncertainties in the determination of pyrrolizidine alkaloid levels in naturally contaminated honeys and comparison of results obtained by different analytical approaches

The contamination of honey with hepatotoxic pyrrolizidine alkaloids (PAs) is a well-known hazard for food safety. While management strategies and controls of the honey industry aim to reduce the PA levels, uncertainties remain with regard to the safety of regionally produced and marketed honey. In addition, a previous study showed large differences of results obtained after various periods of storage and apparent differences between the analytical results of different laboratories. Therefore, this study aimed at examining these uncertainties by monitoring the impact of storage on the PA and PA N-oxide (PANO) content of two freshly harvested honeys and on possible demixing effects caused by pollen settling. Additionally, three analytical approaches – target analysis with matrix-matched calibration or standard addition and a sum parameter method – were applied for a comparative analysis of 20 honeys harvested in summer 2016. All samples originated from Schleswig-Holstein in Northern Germany where the PA plant Jacobaea vulgaris is currently observed on a massive scale. The results of the time series analyses showed that PANO levels markedly decreased within a few weeks and practically reached the LOD 16 weeks after harvest. Tertiary PAs, by contrast, remained stable and did not increase as a consequence of PANO decrease. The experiments on a putative demixing, which may result in a heterogeneous distribution of PAs/PANOs, revealed that there was no such effect during storage of up to 12 weeks. A comparison of the PA/PANO levels obtained by different analytical approaches showed that in some cases the sum parameter method yielded much higher levels than the target approaches, whereas in other cases, the target analysis with standard addition found higher levels than the other two methods. In summary, the results of this study highlight uncertainties regarding the validity and comparability of analytical results and consequently regarding health risk assessment.     

Supramolecular complexes: Determination of stability constants on the basis of various experimental methods

Stability constants and formation enthalpies of supramolecular complexes of crown ethers and their cyclic and acyclic analogues are determined on the basis of experimental data obtained by different physicochemical methods in the terms of a general approach developed and implemented in the ChemEqui software package. The established regularities of variation of stability of complexes are discussed as dependent on the ligand structure, nature of the cation, solvent, and anion. The applicability of the suggested method of determining complexation selectivity is shown for multicomponent equilibria in solutions.

     

Analysis of a two-dimensional symmetric problem on extension of an Al-polyimide-Cu layered structure with a model crack

To increase the efficiency of designing systems intended for monitoring surface cracks in aluminum structures during their working life, we have analyzed a two-dimensional symmetric problem on uniaxial extension of an Al-polyimide-Cu layered structure with ideal adhesion between layers and a model crack in the aluminum base. The problem has been first solved for a sample with the crack modeled by a zero-thickness notch using the ANSYS engineering simulation program package. It is shown that this setting of the problem can lead to inadequate results as manifested, in particular, by significantly overstated mechanical stresses in aluminum in the region of crack emergence on the surface. In order to eliminate this difficulty, we propose to use the structure with a model defect in the form of a notch of nonzero thickness in the initial unstressed state of the structure. Recommendations for selecting the thickness of a notch used in the model structure are given.

     

GC–MS Characterization of Volatile Compounds in Habanero Pepper (Capsicum chinense Jacq.) by Optimization of Headspace Solid-Phase Microextraction Conditions

Food Analytical Methods - The habanero pepper (Capsicum chinense Jacq.) is very aromatic and is the hottest pepper in the world. In this study, a headspace solid-phase microextraction/gas...