Optimization of drilling parameters on surface roughness in drilling of AISI 1045 using response surface methodology and genetic algorithm

Modeling and optimization of cutting parameters are one of the most important elements in machining processes. The present study focused on the influence machining parameters on the surface roughness obtained in drilling of AISI 1045. The matrices of test conditions consisted of cutting speed, feed rate, and cutting environment. A mathematical prediction model of the surface roughness was developed using response surface methodology (RSM). The effects of drilling parameters on the surface roughness were evaluated and optimum machining conditions for minimizing the surface roughness were determined using RSM and genetic algorithm. As a result, the predicted and measured values were quite close, which indicates that the developed model can be effectively used to predict the surface roughness. The given model could be utilized to select the level of drilling parameters. A noticeable saving in machining time and product cost can be obtained by using this model.     

Modeling and optimization of burr height in drilling of Al-7075 using Taguchi method and response surface methodology

This investigation presents the use of Taguchi and response surface methodologies for minimizing the burr height and the surface roughness in drilling Al-7075. The Taguchi method, a powerful tool to design optimization for quality, is used to find optimal cutting parameters. Response surface methodology is useful for modeling and analyzing engineering problems. The purpose of this paper was to investigate the influence of cutting parameters, such as cutting speed and feed rate, and point angle on burr height and surface roughness produced when drilling Al-7075. A plan of experiments, based on L₂₇ Taguchi design method, was performed drilling with cutting parameters in Al-7075. All tests were run without coolant at cutting speeds of 4, 12, and 20 m/min and feed rates of 0.1, 0.2, and 0.3 mm/rev and point angle of 90^°, 118°, and 135°. The orthogonal array, signal-to-noise ratio, and analysis of variance (ANOVA) were employed to investigate the optimal drilling parameters of Al-7075. From the analysis of means and ANOVA, the optimal combination levels and the significant drilling parameters on burr height and surface roughness were obtained. The optimization results showed that the combination of low cutting speed, low feed rate, and high point angle is necessary to minimize burr height. The best results of the surface roughness were obtained at lower cutting speed and feed rates while at higher point angle. The predicted values and measured values are quite close to each other; therefore, this result indicates that the developed models can be effectively used to predict the burr height and the surface roughness on drilling of Al-7075.     

Hardness and Wear Behaviours of Al Matrix Composites and Hybrid Composites Reinforced with B4C and SiC

Powder Metallurgy and Metal Ceramics - The conversion into the desired shape of the metal powders using Powder Metallurgy (PM) method enables economically mass productions. This case allows...