Barium titanate‐based nanodielectrics of two chemically recyclable thermosets

In this work was investigated the effect of the addition of barium titanate (BaTiO₃) on electrical properties of two chemically recyclable thermosets, polyhemiaminal (PHA) and polyhexahydro‐s‐triazine (PHT), both fabricated from 4,4′‐oxydianiline (ODA), an ether derivative of aniline and paraformaldehyde. Thermal and mechanical properties as well as chemical recyclability of the two polymers and their nanocomposites/nanodielectrics were also investigated. In addition, a quantitative analysis was conducted of the nanoparticle dispersion in the PHA‐/PHT‐based BaTiO₃‐containing nanocomposites using transmission electron microscopy imaging and the nearest‐neighbor distance index and this index was used to analyze the investigated properties in connection with the proper mechanisms. Regarding the electrical properties for both neat polymers, conductivity values of the order of 10^?8 S m^?1 at 100 Hz were observed and dielectric constant values close to 2.80 for both polymers at 1 kHz. The addition of 0.5 wt% of BaTiO₃ ferroelectric nanoparticles increased by about 44% the dielectric constant (1 kHz) and conductivity (10² Hz) of the PHA‐based nanocomposite. PHA and PHT exhibited glass transition temperature (T_g) values in the range 125–180 °C. An increase of 7 °C in T_g was observed after the incorporation of 0.5 wt% of BaTiO₃ into PHA. Concerning the mechanical properties, values in the range 4.00–4.45 GPa for reduced modulus and 0.30–0.43 GPa for nanohardness for PHA and PHT polymers were observed. Independently of filler content or polymer matrix, both mechanical properties were enhanced after the addition of BaTiO₃. The chemical recycling of PHA/PHT and all nanocomposites in the initial ODA reagent after sulfuric acid treatment was successfully characterized using the NMR and Fourier transform infrared spectroscopic techniques. © 2018 Society of Chemical Industry     

Thoracic electric impedance and fluid balance during aortic surgery

Indices of fluid balance were evaluated during and after aortic surgery in 16 consecutive patients. Thoracic electrical impedance (TI), heart rate (HR), central venous (CVP), pulmonary artery mean (PAMP), pulmonary wedge (PWP) and mean arterial (MAP) pressures as well as fourteen arterial and venous blood gas variables were followed. Consistent with a reduction of TI during the operation, fluid balance was in excess, and it remained elevated on the first postoperative morning. The HR, MAP and PWP remained stable, while CVP and PAMP decreased. Of the determined variables only TI revealed a meaningful correlation to fluid balance (rho = -0.41; p < 0.01). The results indicate that while central venous and pulmonary artery mean pressures gave the impression of a volume deficit, the positive fluid balance was mirrored by thoracic electrical impedance.     

Metronidazole resistant trichomoniasis successfully treated with paromomycin

Thoracic infection by anaerobes are uncommon diseases and often presents difficulty in diagnosis. We report a case of thoracic infection due to Fusobacterium Nucleatum. A 60-year old man presented a lesion infiltrating from the lung to the thoracic wall. Fusobacterium Nucleatum was isolated on pus collected. Treatment by penicillin, metronidazole combined with surgical drainage was highly effective.     

DMD-specific FISH probes are diagnostically useful in the detection of female carriers of DMD gene deletions

The challenge of Duchenne muscular dystrophy (DMD) carrier identification resides in the ability to identify the presence of a mutant gene over the background contributed by the normal allele. Current diagnosis of carrier status when a deletion has been identified in a proband is based on an analysis of a gene dosage. We present a diagnostic strategy that uses fluorescence in situ hybridization (FISH) to detect female carriers with major deletions in the dystrophin gene. We screened a human X-chromosome-derived genomic library with a full-length dystrophin cDNA and isolated 15 dystrophin-specific cosmids that contain DMD gene exons. Six cosmids were further tested as FISH probes in control individuals and subsequently applied on chromosomes from eight males with DMD and known deletions and on samples from three female carriers. As expected, X chromosomes in normal females displayed four signals, two for the DMD-specific probe and two for the X-chromosome centromeric probe. Hybridization on chromosomal spreads from carriers of deletions revealed only one signal from the DMD-specific probe and two from the control centromeric probe. Males carrying deletions showed no DMD-specific signal for the deleted exons tested. Our data indicate that FISH could represent an alternative method for the detection of female carriers with DMD gene deletions.     

Fertilization in vitro. A review over the medical indications and suggestion to unified guidelines for public fertility clinics in Denmark

Medical indications for in vitro fertilization and embryo transfer (IVF-ET) internationally and in Denmark are reviewed. Reports from large international centres document that tubal infertility, unexplained infertility, endometriosis and male infertility are equally good indications for IVF. Traditionally, tubal infertility has been the only medical indication qualifying for IVF treatment within the National Health Service in Denmark. Thus, in this country, couples with unexplained and male infertility and with endometriosis have to pay up to 25,000 D.Kr. per IVF-ET treatment in private fertility clinics. Since there is no scientific basis for this discrimination, it is urged that the present rules are changed, so that couples with unexplained and male infertility and endometriosis are also allowed IVF treatment free of charge in the public fertility clinics.     

Thermodynamic calculations for Nb-containing high-speed steels and white-cast-iron alloys

Thermodynamical equilibria have been calculated for a wide variety of high-speed steel compositions belonging to the multicomponent system Fe-C-W-Mo-V-Cr-Nb as well as for two series of white-cast-iron alloys containing niobium. Some temperature-concentration diagrams for both classes of alloys are presented and calculated quantities (melting and transformation temperatures, amounts and compositions of phases) are compared with experimental data. Good agreement between calculated and experimental information has been obtained, with the exception of the MC phase compositions and transformation temperatures for white-cast-iron alloys with high carbon and chromium contents. These differences can, however, be satisfactorily explained by plausible kinetic effects.     

The Role of Network Topologies in the Optical Core of IP-over-WDM Networks with Static Wavelength Routing

In this paper, we present a performance analysis of network topologies for the optical core of IP-over-WDM networks with static wavelength routing. The performance analysis is focused on regular degree four topologies, and, for comparison purposes, degree three topologies are also considered. It is shown that the increase of the nodal degree from three (degree three topology with smallest diameter) to four (degree four topology with smallest diameter) improves the network performance if a larger number of wavelengths per link is available. However, the influence of wavelength interchange on the nodal degree gain is small. The performance of regular degree four topologies with smallest diameter is also compared with the performance of mesh–torus topologies (which are also degree four topologies), and it is shown that the blocking probability of degree four topologies with smallest diameter is about two orders of magnitude lower than the blocking probability of mesh–torus topologies. It is also presented a performance comparison of WDM-based networks with nodal degrees ranging from two to five and it is shown that the increase of the nodal degree from two to three leads to high nodal degree gains, while de increase of the nodal degree from four to five leads to low nodal degree gains. These results show that degree three and degree four topologies are very attractive for use in the optical core of IP-over-WDM networks.