Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

Unexplained physical symptoms: outcome, utilization of medical care and associated factors

BACKGROUND: Measurement of intracardiac hemodynamic parameters has been limited to brief periods in the acute care setting. We developed and evaluated an implantable hemodynamic monitor that is capable of measuring chronic right ventricular oxygen saturation and pulmonary artery pressure. METHODS AND RESULTS: The device consists of an electronic controller placed subcutaneously and two transvenous leads placed in the right ventricle (reflectance oximeter) and pulmonary artery (variable capacitance pressure sensor). Implantation was performed in 10 patients with severe left ventricular dysfunction. Average implant pulmonary artery pressures were systolic, 52 +/- 16 mm Hg; diastolic, 29 +/- 11 mm Hg; and mean, 40 +/- 12 mm Hg. The mean right ventricular oxygen saturation at implant was 51%. Provocative maneuvers, including postural changes, sublingual nitroglycerin, and bicycle exercise, demonstrated expected changes in measured oxygen saturation and pulmonary artery pressures over time. At follow-up of 0.5 to 15.5 months, there were no significant differences between pulmonary artery pressures or oxygen saturation values transmitted from the device and simultaneous measurement with balloon flotation catheters. Four of the pulmonary artery leads dislodged and three demonstrated sensor drift, whereas two of the oxygen saturation sensors failed. Four patients died and four received transplants. Pathological study did not demonstrate injury to the right ventricular outflow tract or pulmonic valve. CONCLUSIONS: Chronic measurement of hemodynamic parameters in the outpatient setting with implantable sensor technology appears to be feasible. The devices are well tolerated without significant untoward effects, and the sensors generally function well over time, providing reliable information. Clinical usefulness remains to be established.     

A broad line n.m.r. study of oriented poly(vinylidene fluoride)

Broadline nuclear magnetic resonance measurements have been carried out for the proton resonance in oriented poly(vinylidene fluoride). The spectra in general show two component lines with distinctly different line widths. The broad component shows a high degree of molecular orientation and can be satisfactorily assigned to the crystalline regions of the polymer. The narrow component corresponds to an oriented non crystalline phase which is sufficiently constrained to allow motion about the chain axis only. An appreciable decrease in the value of the rigid mass fraction was observed in both of the samples over the temperature range examined. Our calculations indicate that this could play an important role in the temperature dependence of the pyroelectric response of this material.     

Uncooled DBR laser directly Modulated at 3.125 gb/s as athermal transmitter for low-cost WDM systems

An uncooled three-section tunable distributed Bragg reflector laser is demonstrated as an athermal transmitter for low-cost uncooled wavelength-division-multiplexing (WDM) systems with tight channel spacing. A /spl plusmn/0.02-nm thermal wavelength drift is achieved under continuous-wave operation up to 70/spl deg/C. Dynamic sidemode suppression ratio of greater than 35 dB is consistently obtained under 3.125-Gb/s direct modulation over a 20/spl deg/C-70/spl deg/C temperature range, with wavelength variation of as low as /spl plusmn/0.2 nm. This indicates that more than an order of magnitude reduction in coarse WDM channel spacing is possible using this source.     

Contamination of facial memory through exposure to misleading composite pictures.

In Exp I, 46 male and 51 female undergraduates witnessed a filmed incident and later described the target. Results show that Ss who observed a composite containing misleading information (either incorrect hair or an added moustache) were significantly more likely to misreport hairstyle and the presence of a moustache than those who did not. In Exp II, 210 17–65 yr old Ss observed a filmed incident and were tested for their recall and recognition of the target either immediately or after delays of 2 or 7 days. Significant bias, consistent with the content of the misleading composite, was present for both cued recall and choice of mug shot in a photo spread. The effect did not increase over delay but was greater when the composite was seen just prior to recall than immediately after the incident. Implications concerning interference with the memory of the witness who produced the composite and for other witnesses exposed to the misleading composite are discussed. (33 ref) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

The Development of Color Categories in Two Languages: A Longitudinal Study.

This study unites investigations into the linguistic relativity of color categories with research on children's category acquisition. Naming, comprehension, and memory for colors were tracked in 2 populations over a 3-year period. Children from a seminomadic equatorial African culture, whose language contains 5 color terms, were compared with a group of English children. Despite differences in visual environment, language, and education, they showed similar patterns of term acquisition. Both groups acquired color vocabulary slowly and with great individual variation. Those knowing no color terms made recognition errors based on perceptual distance, and the influence of naming on memory increased with age. An initial perceptually driven color continuum appears to be progressively organized into sets appropriate to each culture and language. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

A site selection model for high technology manufacturing firms in the United States

This article offers a quantitative model for site selection by high technology manufacturing firms. In the past, site selection studies have usually been qualitative in nature, and very subjective. This is an attempt to introduce a more objective quantitative approach. The site selection factors most important to high technology manufacturing firms were identified, ranked and weighted based on a US Joint Economic Committe survey of such firms. The eight most important factors were: the availability of technical and professional workers, labor costs, tax climate, academic institutions, cost of living, transportation for people, and access to markets. Demographic data on these factors were collected and analyzed for 32 developing high technology areas in the United States. By using the quantitative model, a score was developed for each area, allowing them to be ranked as R & D manufacturing environments. This model should prove a useful tool for both regional planners and high-tech companies seeking to relocate.     

The effects of a monetary alternative on marijuana self-administration

We have used a variety of methods to characterize the genome of the archaeon Methanosarcina thermophila TM-1. Pulsed-field gel analysis indicates a genome size of 2.8 Mb. We have constructed a bacterial artificial chromosome (BAC) library of M. thermophila and have used it to generate physical maps for this organism. The library is made up of 384 clones with an average insert size of 58 kb representing 8.0 genome equivalents. The utility of the library for low-resolution physical mapping was shown by identifying NotI linking clones and using these to order the NotI macrorestriction fragments of M. thermophila into a 2.8 Mb map. Hybridization of nine single copy genes and a 16S rRNA sequence to these macrorestriction fragments forms the basis for the first genetic map in this organism. High-resolution physical maps, consisting of overlapping clones, have been created using HindIII fingerprints of BAC clones. In this way, we identified a minimal path of five clones that span a 270 kb NotI fragment. The ease of manipulating BAC clones makes the BAC system an excellent choice for the construction of low-resolution and high-resolution physical and genetic maps of archaeal genomes. It also provides a substrate for future genome-sequencing efforts.