铁道沿线边坡滑坡灾害监测系统设计

本文设计了基于ZigBee技术的铁道沿线边坡滑坡灾害监测系统.系统利用相位式激光测距传感器对边坡滑坡体地表位移量进行采集,通过ZigBee网络将采集信息发送到协调器,协调器通过串口与4G通信模块相连,依靠4G网络将信息远程传输至地面监控中心.通过实验室测试证明,该系统测量精度高、运行稳定,具有较高的应用价值.     

Influence of FeO/SiO2 and CaO/SiO2 Ratios in Iron‐Saturated ZnO‐Rich Fayalite Slags on the Corrosion of MgO

The corrosion behavior of MgO in iron‐saturated ZnO‐rich fayalite (ZFS) slags having various FeO/SiO₂ ratio and CaO/SiO₂ ratio was investigated using MgO crucible tests for 12 h at 1200°C. The FeO/SiO₂ and CaO/SiO₂ ratios in the ZFS slags were varied from 1.0 to 2.2, and from 0.04 to 0.32, respectively. In all of the tests, it was observed that MgO dissolves into ZFS slags and that (Zn,Fe,Mg)₂SiO₄ olivine and (Zn,Fe,Mg)O solid solution are formed at the crucible/slag interface. The MgO dissolution decreased with the FeO/SiO₂ ratio up to a value of 1.7 and then slightly increased, whereas it continuously increased with the CaO/SiO₂ ratio. There is no obvious relationship between the amount of olivine and the FeO/SiO₂ ratio or CaO/SiO₂ ratio. In comparison, the formation of (Zn,Fe,Mg)O solid solution is enhanced by increasing the FeO/SiO₂ ratio or CaO/SiO₂ ratio in ZFS slags. The results suggest that MgO corrosion is the lowest for FeO/SiO₂ and CaO/SiO₂ ratios around 1.7 and 0, respectively.     

透镜孔径限制对其傅里叶变换公式导出的影响——兼论公式使用条件

本文討论了薄透镜孔径对透镜傅里叶变换公式导出带来的困难,较全面地分析了使用该公式应滿足的条件。     

Optimization of Mineralogy and Microstructure of Solidified Basic Oxygen Furnace Slag Through SiO2 Addition or Atmosphere Control During Hot-Stage Slag Treatment

Metallurgical and Materials Transactions B - Valorization of basic oxygen furnace (BOF) slag is of significant importance for mitigation of the steel production’s environmental impact. The...     

氧化石墨烯膜间距对电渗析空气除湿特性影响的分子动力学研究

电渗析空气除湿技术利用高压电场为气体分子荷电,通过多孔氧化石墨烯膜实现水分子和其他带电分子,如氧气分子的分离。双层膜间距将影响到气体分子的传输特性和热力学性质,本文采用分子动力学研究了带电后的水分子和氧气分子在不同膜间距下通过膜的扩散及吸附现象。结果表明：膜层间距主要影响层间氢键形成方式,继而影响多孔氧化石墨烯膜与气体分子间吸附能,存在最佳层间距离1.25 nm,水分子渗透效果最佳,气体选择性达到最高,为1.14,较无电场时扩大了3倍。     

石蜡与石蜡/膨胀石墨熔化性能的实验研究

为改善相变储能过程中石蜡(PA)的熔化性能,向PA中添加少量膨胀石墨(EG)制备了4种配比的石蜡/膨胀石墨复合相变材料(PA-EG)。通过热物性分析筛选出合适配比的PA-EG,并对其和PA在水平管壳式相变储能单元中的熔化过程进行了实验研究。根据相变材料的温度场变化以及加权法计算得到的熔化分数变化,对比分析了添加EG前后PA的熔化性能,并探究了加热温度对相变材料熔化性能的影响。结果表明,PA-EG3的热导率比PA高了7倍,且两者的相变温度和潜热相差不大。PA-EG3熔化过程中的自然对流效应弱于PA,但是较高的热导率能够显著改善相变储能单元中下部的熔化,使得其整体熔化速度快于PA。当加热温度为80℃时,PA-EG3的熔化过程比PA缩短了78.16%。此外,降低加热温度会使PA和PA-EG3的完全熔化时间都显著增加,但相同条件下PA-EG3的增加幅度更小。     

20t复吹转炉冶炼不锈钢碳铬氧化动力学

运用冶金反应动力学基本理论,结合具体工业试验条件,分析得到20t复吹转炉冶炼不锈钢低碳范围的脱碳速度式。用Runge-Kutta法通过计算机求解,得出的数值解与实验值基本一致。     

Effect of Al2O3 Addition on Mineralogical Modification and Crystallization Kinetics of a High Basicity BOF Steel Slag

Metallurgical and Materials Transactions B - Basic oxygen furnace (BOF) steel slag is a main byproduct that is produced during the converter steelmaking process. The volume instability and fast...