Calf massager: Intervention for body muscle discomfort during prolonged standing

Many occupations require workers to stand for long periods of time without proper interventions, which causes discomfort in the back and lower limbs. Therefore, this study aims to assess the effectiveness in alleviating body muscle discomfort during prolonged standing through the use of a calf massager. This study was conducted among male workers at a manufacturer with production line workers and the list was obtained from the HR Department and simple random sampling was done by number categorization. A total of 100 respondents (50 respondents for both the control and the experimental groups) participated in this study. The experiment took place in a room with a similar setup for the production line. Each respondent was requested to perform the simulated task for 2 hr. For the experimental group, the calf massager was turned on every 15 min. At every 15‐min interval after turning on the calf massager, respondents from both groups were required to evaluate their discomfort level on a Borg's scale CR‐10 questionnaire. The results showed that the level of body discomfort among respondents in the experimental group reduced (20–30%) compared with that of the control group. Multivariate analysis results revealed that the discomfort rating for the lower back, knees, thighs, calves, and feet was significantly lower (p < .05) among the experimental group compared with the control group. For lower body parts, the lower back region was statistically significant (p < .05) at the 90th, 105th, and 120th min; the thigh region was statistically significant (p < .05) at the 120th min; the knee region was statistically significant (p < .05) at the 105th and 120th min; the calf region was statistically significant (p < .05) at all minute intervals except the 15th and 45th min, while the feet region, was statistically significant at the 105th and 120th min. Therefore, this study indicates that calf massage treatment is capable of reducing body muscle discomfort during prolonged standing and highlights the significance of calf massage.     

因素空间理论下基点分类算法研究

目前，基于因素空间理论的背景基提取算法计算过程复杂，初始化必须依赖各因素极值，基点数量提取冗余等原因，未能在应用中取得很好效果。为此，结合内点判别法和知识可继承、可扩展的思想，提出一种计算简单、初始化独立、基点数量小的改进的背景基提取算法。然后，利用改进的背景基提取算法构造出一种全新的数据分类算法-基点分类算法，基点分类算法以提取每一类样本的背景基为预测模型，再通过新定义的λ-背景基，优化预测模型。数值实验表明:基点分类算法原理简单、构造难度小、分类模型泛化能力强，预测能力准确率高，同时严格的模型限定区域又能为识别新类别提供新方法。     

HEGF中CO井筒流动及扩散规律研究

目前,高能气体压裂广泛的应用于低渗透油气田,可以有效清除近井地带由于钻井、射孔和各种措施造成的污染和堵塞,达到油气井增产、注水井增注的目的。但最近一些低渗透油气田却出现了频繁的CO气体中毒事件,给油田及员工带来巨大的损失。针对这一现象,运用现场数据以及物理模拟和数学模拟方法首次通过对CO气体流动、扩散等的综合研究,建立了CO井筒流动及大气扩散模型。同时,也考察了井筒压力、气油比、风速、气体泄放速率、大气稳定度等主要因素对CO气体扩散的影响。通过现场实例计算,证实模型具有较高的准确性。此项工作的完成为建立监控系统提供基础技术依据,同时对合理、有效的开发油气田以及煤层气的开发将具有重要的实际意义。     

浅析城2井推覆体钻具失效

城2井推覆体构造带主要岩性为海西期花岗岩，岩石硬度高，钻井施工难度相当大，易发生断钻具等复杂情况。就城2井推覆体构造特点，和钻井施工中钻具失效原因分析、发生钻具失效时的井下情况判断、推覆体大井眼打捞落鱼方法、推覆体钻进预防钻具失效的措施等方面予以介绍，对今后在山前推覆体构造带施工有一定的借鉴和指导作用。     

井下乳化/水热催化裂解复合降黏开采稠油技术研究

实验考察了胜利孤东稠油井下催化水热裂解和乳化/催化水热裂解降黏效果。所用催化剂为水溶性铁镍钒体系,Fe3+∶Ni2+∶VO4+=5∶1∶1,100 g稠油与30 g 0.5%催化剂水溶液在240℃反应24小时。原始黏度(50℃)11.0和8.36 Pa.s的两种稠油裂解并静置除水后,黏度降低76.2%和75.6%,室温放置60天后降黏率下降小于3个百分点,气相色谱显示裂解后轻组分明显增加,红外光谱显示稠油组分发生脱羧反应且芳环数减少。讨论了稠油催化水热裂解反应机理。所用化学助剂JN-A在油水中均可溶,耐温达250℃,耐矿化度达50 g/L,其水溶液以30∶100的质量比与稠油混合时形成低黏度的O/W乳状液。当水相含1.0%JN-A和0.5%催化剂时,两种稠油水热裂解后的反应混合物为O/W乳状液,黏度仅为319和309 mPa.s,静置除水后的稠油降黏率增加到86.5%和87.3%,其中的轻组分含量进一步增加。该井下乳化/催化水热裂解复合降黏法成功地用于孤东两口蒸汽吞吐井,稠油井作业后初期采出的原油黏度由~9 Pa.s降低到1 Pa.s左右,随采油时间延长而逐渐升高,约50天后超过4Pa.s。图2表6参5。     

6σ设计水平的评价

在介绍6σ设计概念和目标的基础上，给出设计水平与百万机会缺陷数(DPMO)关系的计算表达式和关系曲线，并开发了计算机模块，能自动计算与不同设计水平对应的DPMO值，也可以根据实际的DPMO值，自动评价达到的设计水平。     

Design of a wideband microstrip antenna and the use of artificial neural networks in parameter calculation

This paper deals with the design of a multi-slot hole-coupled microstrip antenna on a substrate of 2 mm thickness that gives multi-frequency (wideband) characteristics. The Method of Moments (MoM)-based IE3D software was used to simulate the results for return loss, VSWR, the Smith chart, and the radiation patterns. A tunnel-based artificial neural network (ANN) was also developed to calculate the radiation patterns of the antenna. The radiation patterns were measured experimentally at 10.5 GHz and 12 GHz. The experimental results were in good agreement with the simulated results from IE3D and those of the artificial neural network. A new method of using a genetic algorithm (GA) in an artificial neural network is also discussed. This new method was used to calculate the resonant frequency of a single-shorting-post microstrip antenna. The resonant frequency calculated using the genetic-algorithm-coupled artificial neural network was compared with the analytical and experimental results. The results obtained were in very good agreement with the experimental results.     

一种铁氧体移相驱动器专用集成电路

介绍了ＳＡ０１８铁氧体移相驱动器专用集成电路的工作原理，电路设计和实验结果。该电路的内部电路设计有双路激励驱动器，放大器，积分器和双路高速比较器等功能单元。将铁氧体移相器的激励驱动器和相位控制器融于一体，大大减少了铁氧体移相器的外围设计。     

Adsorption of 117mSn(Ⅳ)-EDTMP on hydroxyapatite and collagen

Some organic phosphines labeled with 117mSn(Ⅳ) have been provedpromising for imaging and pain palliation of bone tumor. In this paper, a prelimi-nary investigation on the adsorption characteristics of EDTMP (ethelenediaminete-tramethylene phosphoric acid) labeled with 117mSn(Ⅳ) on HA(hydroxyapatite) andcollagen, and an investigation on the adsorption mechanism of 117mSn(Ⅳ)-EDTMPon HA was presented.``