METEOR: a constraint-based FIR filter design program

It is proposed to specify a filter only in terms of upper and lower limits on the response, find the shortest filter length which allows these constraints to be met, and then find a filter of that order which is farthest from the upper and lower constraint boundaries in a minimax sense. The simplex algorithm for linear programming is used to find a best linear-phase FIR filter of minimum length, as well as to find the minimum feasible length itself. The simplex algorithm, while much slower than exchange algorithms, also allows the incorporation of more general kinds of constraints, such as concavity constraints (which can be used to achieve very flat magnitude characteristics). Examples are given to illustrate how the proposed and common approaches differ, and how the proposed approach can be used to design filters with flat passbands, filters which meet point constraints, minimum phase filters, and bandpass filters with controlled transition band behavior     

Laboratory and field tests with the synthetic sex pheromone of threeMatsucoccus 1 pine bast scales

Matsunone, (2E,4E)-4.6,10,12-tetramethyl-2,4-tridecadien-7-one, is the primary sex pheromone ofMatsucoccus resinosae, M. thunbergianae, andM. matsumurae. The synthetic compound was tested in the laboratory and in field tests with all three species, and significantly more males responded to synthetic matsuone than to controls. The attraction of synthetic matsuone to males in field tests was not significantly different from that of virgin females at the same matsuone release rate. An analog of matsuone previously shown to be biologically active was also tested in the laboratory withM. resinosae andM. thunbergianae, and field tested withM. resinosae. The active analog required a dose approximately 100 times greater than matsuone to yield maximum laboratory bioassay response, and in field tests, attraction was not significantly different from controls at doses at which matsuone was significantly attractive.Homoptera: Coccoidea: Margarodidae.Deceased.     

Fatty acid composition of polar lipids in goats' milk

Silicic acid column chromatography was used to separate the polar lipids of goats' milk into glycolipid, phosphatidylethanolamine, phosphatidylserine plus phosphatidylinositol, phosphatidylcholine, and sphingomyelin fractions. Each fraction was purified by column chromatography and its fatty acid profile determined by gas liquid chromatography and mass spectrometry. The glycerophospholipids each contained 18∶1 as the predominant fatty acid (∼45%). The sphingolipids contained a high percentage of long-chain saturated fatty acids (C₂₂ to C₂₄>45%); the glycolipid fraction also contained ca. 2% 2-hydroxy fatty acids. The data represent a comprehensive cross-sectional study of the major polar lipids found in goats' milks.     

Oxidation Of Iron And Manganese By Ozone

The oxidation of iron and manganese by ozone was studied in the laboratory. Model waters both with and without organic matter were used. Results showed iron to be very rapidly oxidized to an insoluble form in the absence of organic matter. However, in the presence of organic matter the iron was protected from oxidation by ozone and precipitation. The degree to which this occurred depended on the nature of the organic matter and the chemical environment at the time of mixing the iron stock and the dissolved organic matter.

Experiments with manganese allowed the determination of second order rate constants for the reaction of ozone with manganese at various pH values. The oxidation of manganese in the presence of organic matter occurred in competition with oxidation of the organic matter. As a result, high ozone doses were required to achieve the same degree of removal of manganese. An increase in bicarbonate alkalinity from 50 mg/L to 200 mg/L did not result in an acceleration of the manganese oxidation in the absence of organic matter. However, in the presence of organic matter, higher levels of bicarbonate created conditions that resulted in more complete oxidation of the manganese following total consumption of the dosed ozone.     

Gender Differences in Mouse and Cursor Movements

Computer cursor and mouse activities such as moving, pointing, selecting, and dragging are essential parts of everyday interactions. Yet it is unknown how men and women differ in the way they move computer cursors. This study examines gender differences in movements of computer cursors. In one experiment, the authors measured trajectories of computer cursors every 20 ms in a simple choice-reaching task and tested the extent to which movement features related to controlling and targeting diverge between male and female participants. Results showed significant gender differences in cursor motions. Female participants deviated from the straight path toward the target location to a larger degree than did male participants, and female participants showed more backward motions (deviating backward from the target location) than did male participants. Implications for sources of these gender differences, user interface and input device design, and musculoskeletal disorders in women are also discussed.     

A criterion for plane strain,fully plastic,quasi-steady crack growth

Plane strain fracture by hole growth in ordinary-sized parts of low-to-medium strength steels is essentially rigid-plastic, and may be approximated as non-hardening. Quasi-steady crack growth for such materials is predicted for crack-tip fields approximated by a pair of slip lines, such as unequally grooved specimens in tension and deep singly-face-cracked specimens under combined bending and tension. The crack growth increment a is given in terms of material parameters, far-field geometry, and loadings and their increments.For the rigid-plastic, non-hardening approximation, stress and strain increment fields for growing cracks are identical to those for stationary cracks. For fields with a pair of symmetric slip-lines, the flanks of the decohering zone turn out to be rigid, and the decohering zone does not affect the crack-tip opening angle (CTOA), which then depends only on the micromechanisms of hole nucleation, growth and linkage by flow localization or fine cracking. These mechanisms are in turn approximately controlled by the near-field plasticity parameters: the angle of the slip plane _s, and the normal stress and displacement increment across the slip plane _s and u_s. Note the three-parameter characterization of the near-tip fields, in contrast to the one- or two-parameter characterization in elastic or nonlinear elastic fracture mechanics.A sliding off and shear-cracking model for a growing crack, based on a hole growth equation, gives an approximate CTOA in terms of _s, _s, and material parameters. When hole nucleation strain is negligible, the estimated CTOA exhibits an inverse exponential dependence on _s and a higher order parabolic dependence on _s. For a given material, a series of fully plastic crack growth experiments is suggested to determine the approximate material parameters needed to characterize the dependence of CTOA on _s and _s, or from kinematics, of the shear strain behind the slip plane, _f, on _s.     

Test Accommodations for Postsecondary Students: The Quandary Resulting From the ADA's Disability Definition.

Legal wrangling precipitated by the Americans With Disabilities Act (ADA) has resulted in courts adopting a narrow view of disability. This narrow categorical disability definition is in conflict with current mental health and educational practice that presumes an inclusive view of disability. Test accommodations for licensing exams based on learning impairments provide an example of the conflict generated by legal versus mental health views of disability. Mental health practitioners often support test accommodation requests for students who do not meet the ADA's strict threshold for disability determination. Mental health practitioners must understand the ADA definition of disability, and test organizations need to examine goals and alter standard practice in a manner that is fair and equitable independent of learning impairments. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Multiobjective and multi-physics topology optimization using an updated smart normal constraint bi-directional evolutionary structural optimization method

To date the design of structures using topology optimization methods has mainly focused on single-objective problems. Since real-world design problems typically involve several different objectives, most of which counteract each other, it is desirable to present the designer with a set of Pareto optimal solutions that capture the trade-off between these objectives, known as a smart Pareto set. Thus far only the weighted sums and global criterion methods have been incorporated into topology optimization problems. Such methods are unable to produce evenly distributed smart Pareto sets. However, recently the smart normal constraint method has been shown to be capable of directly generating smart Pareto sets. Therefore, in the present work, an updated smart Normal Constraint Method is combined with a Bi-directional Evolutionary Structural Optimization (SNC-BESO) algorithm to produce smart Pareto sets for multiobjective topology optimization problems. Two examples are presented, showing that the Pareto solutions found by the SNC-BESO method make up a smart Pareto set. The first example, taken from the literature, shows the benefits of the SNC-BESO method. The second example is an industrial design problem for a micro fluidic mixer. Thus, the problem is multi-physics as well as multiobjective, highlighting the applicability of such methods to real-world problems. The results indicate that the method is capable of producing smart Pareto sets to industrial problems in an effective and efficient manner.