Characterizing physical habitat preferences and thermal refuge occupancy of brook trout (Salvelinus fontinalis) and Atlantic salmon (Salmo salar) at high river temperatures

Anthropogenic influences, including climate change, are increasing river temperatures in northern and temperate regions and threatening the thermal habitats of native salmonids. When river temperatures exceed the tolerance levels of brook trout and Atlantic salmon, individuals exhibit behavioural thermoregulation by seeking out cold‐water refugia – often created by tributaries and groundwater discharge. Thermal infrared (TIR) imagery was used to map cold‐water anomalies along a 53 km reach of the Cains River, New Brunswick. Trout and salmon parr did not use all identified thermal anomalies as refugia during higher river temperature periods (>21°C). Most small‐bodied trout (8–30 cm) were observed in 80% of the thermal anomalies sampled. Large‐bodied trout (>35 cm) required a more specific set of physical habitat conditions for suitable refugia, that is, 100% of observed large trout used 30% of the anomalies sampled and required water depths >65 cm within or adjacent to the anomaly. Densities of trout were significantly higher within anomalies compared with areas of ambient river temperature. Salmon parr were less aligned with thermal anomalies at the observed temperatures, that is, 59% were found in 65% of the sampled anomalies; and densities were not significantly different within/ outside anomalies. Salmon parr appeared to aggregate at 27°C, and after several events over 27°C variability in aggregation behaviour was observed – some fish aggregated at 25°C, others did not. We stipulate this is due to variances of thermal fatigue. Habitat suitability curves were developed for velocity, temperature, depth, substrate, and deep water availability to characterize conditions preferred by fish during high‐temperature events. These findings are useful for managers as our climate warms, and can potentially be used as a tool to help conserve and enhance thermal refugia for brook trout and Atlantic salmon in similar systems.     

Real-time organic aerosol chemical speciation in the indoor environment using extractive electrospray ionization mass spectrometry

Understanding the sources and composition of organic aerosol (OA) in indoor environments requires rapid measurements, since many emissions and processes have short timescales. However, real-time molecular-level OA measurements have not been reported indoors. Here, we present quantitative measurements, at a time resolution of five seconds, of molecular ions corresponding to diverse aerosol-phase species, by applying extractive electrospray ionization mass spectrometry (EESI-MS) to indoor air analysis for the first time, as part of the highly instrumented HOMEChem field study. We demonstrate how the complex spectra of EESI-MS are screened in order to extract chemical information and investigate the possibility of interference from gas-phase semivolatile species. During experiments that simulated the Thanksgiving US holiday meal preparation, EESI-MS quantified multiple species, including fatty acids, carbohydrates, siloxanes, and phthalates. Intercomparisons with Aerosol Mass Spectrometer (AMS) and Scanning Mobility Particle Sizer suggest that EESI-MS quantified a large fraction of OA. Comparisons with FIGAERO-CIMS shows similar signal levels and good correlation, with a range of 100 for the relative sensitivities. Comparisons with SV-TAG for phthalates and with SV-TAG and AMS for total siloxanes also show strong correlation. EESI-MS observations can be used with gas-phase measurements to identify co-emitted gas- and aerosol-phase species, and this is demonstrated using complementary gas-phase PTR-MS observations.     

2.4 GHz continuously variable ferroelectric phase shifters using all-pass networks

Continuously variable ferroelectric (BST on sapphire) phase shifters based on all-pass networks are presented. An all-pass network phase shifter consists of only lumped LC elements, and thus the total size of the phase shifter is kept to less than 2.2 mm /spl times/ 2.6 mm at 2.4 GHz. The tunability (C/sub max//C/sub min/) of a BST interdigital capacitor is over 2.9 with a bias voltage of 140 V. The phase shifter provides more than 121/spl deg/ phase shift with the maximum insertion loss of 1.8 dB and the worst case return loss of 12.5 dB from 2.4 GHz to 2.5 GHz. By cascading two identical phase shifters, more than 255/spl deg/ phase shift is obtained with the maximum insertion loss of 3.75 dB. The loss figure-of-merit of both the single- and double-section phase shifters is over 65/spl deg//dB from 2.4 GHz to 2.5 GHz.     

如何用硅振荡器替代晶体和陶瓷谐振器

对于绝大多数微控制器时钟电路而言，硅振荡器是一种简单且有效的解决方案。与晶体和陶瓷谐振器不同，基于硅材料的定时器具有抗振动、抗撞击和抗电磁干扰的优点。同时，硅振荡器不需要严格匹配的定时元件和线路板走线。     

Cytotoxic effects of topotecan combined with various anticancer agents in human cancer cell lines

BACKGROUND: Topotecan (TPT) is a topoisomerase I poison that exhibits antineoplastic activity. Analysis of the cytotoxic effects of combinations of TPT and other anticancer agents has been limited. PURPOSE: We assessed the cytotoxic effects produced by combinations of TPT and other antineoplastic agents in experiments involving multiple human cancer cell lines of diverse histologic origins. METHODS: The cytotoxic effects of various antimetabolites (fluorouracil, methotrexate, or cytarabine), antimicrotubule agents (vincristine or paclitaxel [Taxol]), DNA alkylating agents (melphalan, bis[chloroethyl]nitrosourea [BCNU], or 4-hydroperoxycyclophosphamide [4HC]), and a DNA-platinating agent (cisplatin), alone and in combination with TPT, were measured in clonogenic (i.e., colony-forming) assays. HCT8 ileocecal adenocarcinoma, A549 non-small-cell lung carcinoma, NCI-H82ras(H) lung cancer, T98G glioblastoma, and MCF-7 breast cancer cell lines were used in these assays. The data were analyzed by the median effect method, primarily under the assumption that drug mechanisms of action were mutually nonexclusive (i.e., completely independent of one another). For each level of cytotoxicity (ranging from 5% to 95%), a drug combination index (CI) was calculated. A CI less than 1 indicated synergy (i.e., the effect of the combination was greater than that expected from the additive effects of the component agents), a CI equal to 1 indicated additivity, and a CI greater than 1 indicated antagonism (the effect of the combination was less than that expected from the additive effects of the component agents). RESULTS: When the mechanisms of drug action were assumed to be mutually nonexclusive, virtually all CIs for combinations of TPT and either antimetabolites or antimicrotubule agents revealed cytotoxic effects that were less than additive. The CIs calculated at low-to-intermediate levels of cytotoxicity for combinations of TPT and the DNA alkylating agents melphalan, BCNU, and 4HC also showed drug effects that were less than additive; in most cases, however, nearly additive or even synergistic effects were observed with these same drug combinations at high levels of cytotoxicity (i.e., at > or = 90% inhibition of colony formation). Results obtained with combinations of TPT and cisplatin varied according to the cell line examined. With A549 cells, less than additive effects were seen at low-to-intermediate levels of cytotoxicity, and more than additive effects were seen at high levels of cytotoxicity. With NCI-H82ras(H) cells, synergy was observed over most of the cytotoxicity range. CONCLUSIONS AND IMPLICATIONS: TPT cytotoxicity appears to be enhanced more by combination with certain DNA-damaging agents than by combination with antimetabolites or antimicrotubule agents. Interactions between TPT and other drugs can vary depending on the cell type examined. Further investigation is required to determine the basis of the observed effects and to determine whether these in vitro findings are predictive of results obtained in vivo.     

Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

Hemodynamic response to in situ latissimus dorsi muscle stimulation: implications in dynamic cardiomyoplasty

Dynamic cardiomyoplasty (DCM) involves the electrical stimulation of a pedicled latissimus dorsi muscle flap wrapped around the falling ventricle as a means of cardiac assist. To further elucidate a potential neurohumoral mechanism for improvement of cardiac output after myoplasty, we evaluated the hemodynamic effects of in situ stimulation of the latissimus dorsi muscle (in the absence of cardiomyoplasty). In seven mongrel dogs, a nerve cuff electrode (Medtronic 6901) was placed around the left thoracodorsal nerve (TDN). This was attached to a pulse generator (Medtronic, Itrel 7420), delivering a 4.0 volt, 0.19 second on, 0.81 second off, 33 Hz, 210 microsecond pulse width, cyclic bursts similar to that used in DCM. Stroke volume index (SVI) and other hemodynamic parameters as well as plasma norepinephrine (NE) levels were measured at five stages: baseline, stimulator on at 0, 2, and 5 minutes, and stimulator off at 30 minutes after. The animals were then subjected to 4 weeks of rapid pacing at 240 beats/min (Medtronic 8329) to induce heart failure, and as the rapid pacing was discontinued, measurements were repeated as above. After rapid pacing, cardiac function was significantly depressed, and NE was elevated (133 +/- 69 versus 500 +/- 353 pg/mL, p < 0.05). In the normal hearts, TDN stimulation increased SVI, heart rate, systemic pressure, and NE levels. In heart failure, however, no significant changes in cardiac function and NE levels were noted. In conclusion, our data indicate that in the normal hearts, afferent impulses from TDN stimulation alone may augment cardiac function by means of a neurohumoral effect that is not seen in severe heart failure. The implications of these findings in DCM are discussed.     

Electrical linewidth test structures fabricated in monocrystallinefilms for reference-material applications

The physical widths of reference features incorporated into electrical linewidth test structures patterned in films of monocrystalline silicon have been determined from Kelvin voltage measurements. The films in which the test structures are patterned are electrically insulated from the bulk-silicon substrate by a layer of silicon dioxide provided by SIMOX (Separation by the IMplantation of OXygen) processing. The motivation is to facilitate the development of linewidth reference materials for critical-dimension (CD) metrology-instrument calibration. The selection of the (110) orientation of the starting silicon and the orientation of the structures' features relative to the crystal lattice enable a lattice-plane-selective etch to generate reference-feature properties of rectangular cross section and atomically planar sidewalls. These properties are highly desirable for CD applications in which feature widths are certified with nanometer-level uncertainty for use by a diverse range of CD instruments. End applications include the development and calibration of new generations of CD instruments directed at controlling processes for manufacturing devices having sub-quarter-micrometer features