Continuous hydrolysis of olive oil by lipase in microporous hydrophobic membrane bioreactor

Continuous hydrolysis of olive oil byCandida cylindracea’s lipase was studied in a microporous hydrophobic membrane bioreactor. Olive oil and buffer solution, fed continuously through two compartments partitioned by membrane, caused reaction at the interface of lipase-adsorbed membrane and buffer solution. Fatty acid was obtained in a single phase without being mixed with components of other phases. At all mean residence times, countercurrent flow mode was superior to cocurrent one. The lipase was adsorbed onto the membrane, and its adsorption was suggested to be partially specific from the experiments with enzymes having various levels of purity. The percent hydrolysis depended hyperbolically on the interfacial enzyme concentration. The hydrolysis seemed to be limited by diffusion of fat or fatty acid through the micropores of the membrane at higher interfacial enzyme concentrations. The lipase was stabilized significantly by glycerol added to the buffer solution. Satisfactory performance of the membrane bioreactor was obtained in a longterm continuous operation which lasted for 24 days by feeding buffer-glycerol (18.0%) solution over the adsorbed lipase. The operational half-life of the adsorbed enzyme was 15 days at 40 C.     

Superconductivity in SrTa2S5

A strontium tantalum sulfide, SrTa₂S₅, has a hexagonal structure with lattice constants of a =3.32 and c=24.1 Å. With decreasing temperature the electrical resistivity decreases monotonically and exhibits an abrupt superconducting transition at 3.16 K (midpoint). The diamagnetic susceptibility is observed below T_c. The magnetic susceptibility is nearly independent of temperature above T_c and shows Pauli paramagnetism.     

Effects of Annealing on Dielectric Loss and Microstructure of Aluminum Nitride Ceramics

The effect of annealing on tan δ and microstructures of aluminum nitride (AlN) ceramics were explored. Yttria was added as a sintering additive to AlN powders, and the powders were pressureless-sintered at 1900°C for 2 h in a nitrogen flow atmosphere. In succession to sintering, AlN samples were annealed at 720, 970 and 1210°C for 2 and 4 h. Very low tan δ values between 2.6 and 6.0 × 10⁻⁴ at 28 GHz were obtained when the AlN samples were annealed for 4 h at all the annealing temperatures.     

In-situ monitoring of the stabilization with hydrogen of free radicals thermally induced from coal using high pressure e.s.r., d.t.a. and p.d.a. equipment

High temperature, high pressure e.s.r. measurements of the hydrogenation reaction of Taiheiyo coal in the presence of catalysts were carried out to understand the stabilization of thermally and/or catalytically induced free radicals. A decrease in free radical concentration with increasing temperature was observed for ZnCl₂ and SnCl₂ · 2H₂O catalysts at 10MPa under hydrogen gas. High pressure modified single-cell d.t.a. and p.d.a. equipment augmented the uniquely designed high temperature, high pressure e.s.r. cell. The hydrogenation reaction was monitored under the same experimental conditions as for e.s.r. From the results of the combination of high temperature, high pressure e.s.r. with high pressure d.t.a. and p.d.a., it was established that H₂ molecules can react efficiently with free radicals from coal molecules created by the presence of ZnCl₂ and SnCl₂ · 2H₂O catalysts.     

Development of a liquid tin microjet target for an efficient laser-produced plasma extreme ultraviolet source

A regenerative tin liquid microjet target was developed for a high average power extreme ultraviolet (EUV) source. The diameter of the target was smaller than 160 microm and good vacuum lower than 0.5 Pa was maintained during the operation. A maximum EUV conversion efficiency of 1.8% at the Nd:yttrium-aluminum-garnet laser intensity of around 2 x 10(11) Wcm(2) with a spot diameter of 175 microm (full width at half maximum) was observed. The angular distribution of the EUV emission remained almost isotropic, whereas suprathermal ions mainly emerged toward the target normal.     

Dielectric Dispersion of Polycrystalline Aluminum Nitride at Microwave Frequencies

Complex permittivity of polycrystalline AlN was measured over the frequency range 100 MHz to 13 GHz using reflection coefficient and cavity resonator methods. Dielectric relaxation peaks of loss tangent were observed in the frequency range 200 MHz to 3 GHz. The maximum value of loss tangent was ∼200 × 10⁻⁴. Relative permittivities decreased by ∼4% with increased frequency at the region of relaxation peaks. It was shown that these dispersion frequencies were inversely proportional to the grain sizes of AlN and independent of purities and processes. Model calculations for elastic vibration of a single-crystal grain of AlN were performed to investigate the origin of the dielectric dispersion due to piezoelectric effect. The calculated results of elastic sphere and 14-faced-polyhedron models showed a good quantitative agreement with the observed dispersion frequencies, which suggested that the dispersion was due to a piezoelectric vibration of a single grain of AlN ceramics at microwave frequencies.     

Voltage Control of Static Var Compensator for a Remote System Interconnected by Long‐Distance AC Cables

The voltage variation in a remote system is large when the system is connected by long‐distance AC cables due to the cable capacitance. In Japan, the longest 54‐km 66‐kV AC submarine cable interconnection between the Kyushu mainland and Goto Islands was commissioned in 2005. It was requested to mitigate the voltage variation caused by switching off and on one circuit of the two circuits in the AC cables when a fault occurs. Since the conventional voltage control methods such as transformer tap changer or shunt capacitor and reactor banks are not sufficient because of their slow response time, a static var compensator (SVC) was installed on the Goto Islands. In such an application, an SVC control method should be developed so as not to override the existing voltage control systems. This paper describes the SVC control method developed for the Goto Islands AC interconnection project, which can be applied to similar situations. The effectiveness of the control method was verified by the results of effective value simulation and of field testing, which was implemented before the SVC was commissioned in 2007. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(3): 19–30, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22337     

Homogeneous Strain Introduction Using Reciprocation Technique in High-Pressure Sliding

Metallurgical and Materials Transactions A - This study examines strain distribution occurring in the high-pressure sliding (HPS) processing for rods of pure Al and an AZ61 alloy. The strain...     

Development of a new heterojunction structure (ACJ -HIT) and its application to polycrystalline silicon solar cells

A new solar cell structure named HIT (Heterojunction with Intrinsic Thin layer) has been developed based on new artificially constructed junction (ACJ) technology. In this structure a non-doped a-Si thin layer was inserted between the p(a-Si)/n(c-Si) heterojunction, improving the output characteristics and achieving a conversion efficiency of 18.1%. This structure was applied to cast polycrystalline silicon solar cells of a practical size. A high conversion efficeincy of 13.6% was obtained with a cell size of 10 cm × 10 cm using various technologies, including hydrogen plasma passivation.