Two-laboratory collaborative study on identification of mycobacteria: molecular versus phenotypic methods

Previous studies have indicated that the conventional tests used for the identification of mycobacteria may (i) frequently result in erroneous identification and (ii) underestimate the diversity within the genus Mycobacterium. To address this issue in a more systematic fashion, a study comparing phenotypic and molecular methods for the identification of mycobacteria was initiated. Focus was given to isolates which were difficult to identify to species level and which yielded inconclusive results by conventional tests performed under day-to-day routine laboratory conditions. Traditional methods included growth rate, colonial morphology, pigmentation, biochemical profiles, and gas-liquid chromatography of short-chain fatty acids. Molecular identification was done by PCR-mediated partial sequence analysis of the gene encoding the 16S rRNA. A total of 34 isolates was included in this study; 13 of the isolates corresponded to established species, and 21 isolates corresponded to previously uncharacterized taxa. For five isolates, phenotypic and molecular analyses gave identical results. For five isolates, minor discrepancies were present; four isolates remained unidentified after biochemical testing. For 20 isolates, major discrepancies between traditional and molecular typing methods were observed. Retrospective analysis of the data revealed that the discrepant results were without exception due to erroneous biochemical test results or interpretations. In particular, phenotypic identification schemes were compromised with regard to the recognition of previously undescribed taxa. We conclude that molecular typing by 16S rRNA sequence determination is not only more rapid (12 to 36 h versus 4 to 8 weeks) but also more accurate than traditional typing.     

Bag the sags

This article describes the vulnerability of variable speed drives (VSD) to voltage sags on a theoretical basis. Then, three embedded mitigation methods are addressed in theory which protect textile processes against voltage sags, and practical measurements with a sag generator are shown. The use of embedded solutions such as kinetic buffering and boost convertor or an active front end will increase the voltage sag immunity of the process. Finally, two processes in the textile industry are described, and a brief cost-benefit analysis of the solutions is made. Experiments with a sag generator show that the voltage sag behaviour can be well described by theoretical models.     

Uniform flux heat transfer in concentric laminar flow of two immiscible liquids

The energy equation was solved exactly for fully developed steady laminar flow in a circular pipe of two immncible Newton liquids with a concentric cylindrical interface between them, assuming invariant physical properties of the liquids, uniform heat flux at the wall and fully developed temperature profiles. It is shown that, even if the viscosity of the annular liquid is orders of magnitude smaller than that of the core liquid, the improvement in heat transfer to the core liquid by infection of the annular liquid cannot exceed a factor of 1 8     

Prof. Dr.-Ing. Dr. h. c. Franz Kollmann Zum 65. Geburtstag

Ohne Zusammenfassung     

Sexual differentiation of play behavior in the ferret.

Three experiments examined the endocrine mechanisms responsible for sex differences in prepubertal play behavior of ferrets. In Exp I, 6 gonadally intact adolescent males exhibited higher levels of "stand-over" behavior than 6 females did in tests between 63 and 123 days of age with gonadally intact female partners of the same age. In Exp II, with 69 Ss, those Ss exposed to androgen or to ovarian steroids over Days 5–20 of postnatal life subsequently exhibited significantly higher levels of stand-over behavior in tests with females than did control females gonadectomized on Day 5 and not given steroids. None of the Ss in Exp II exhibited levels of stand-over behavior comparable to those of the gonadally intact males in Exp I. In Exp III, with 36 Ss, males gonadectomized and implanted subcutaneously with testosterone capsules on Day 70 and tested with females at 84–96 days of age exhibited levels of stand-over behavior comparable to those observed in Exp I in gonadally intact males of the same age (Weeks 12–24). Males gonadectomized on Day 70 and given no hormone at testing exhibited significantly lower levels of this behavior. Significantly lower levels were also exhibited by males gonadectomized on Day 35 and females gonadectomized on Day 70, regardless of whether they were tested with testosterone present after Day 70. Sex differences in the expression of prepubertal play behavior of ferrets apparently result from differential exposure of males and females to androgen over an extended postnatal period. (25 ref) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Surface orientation from a projected grid

Two simple methods are given for obtaining the surface shape using a projected grid. After the camera is calibrated to the 3-D workspace, the only input date needed for the computation of surface normals are grid intersect points in a single 2-D image. The first method performs nonlinear computations based on the distortion of the lengths of the grid edges and does not require a full calibration matrix. The second method requires that a full parallel projection model of the imaging is available, which enables it to compute 3-D normals using simple linear computations. The linear method performed better overall in the experiments, but both methods produced normals within 4-8° of known 3-D directions. These methods appear to be superior to methods based on shape-from-shading because the results are comparable, yet the equipment setup is simpler and the processing is not very sensitive to object reflectance