排序方式: 共有14条查询结果,搜索用时 15 毫秒
1.
2.
复旦大学计算机系设计、江苏启东电子仪器厂生产的DPT-35-Ⅰ简易开发装置,对一位机可以进行在线开发,软硬件同时调试,一次成型,简易、方便、迅速。 DPT-35-Ⅰ简易开发装置或称“EPROM仿真器”,除连续运行外,其余对8035的开发功能对5G14500均适用。需要5G14500连续运行时,可将开发装置放在设断点运行状态,断点地址送非一位机运行地址。例一位机指令存放在000~2FF单元,此时断点 相似文献
3.
Configuration-constrained potential energy surface calculations have been performed to investigate four-quasiparticle high-K configurations in neutron-deficient lead and polonium isotopes. A good agreement between the calculations and the experimental data has been found for the excitation energy of the observed Kπ = 19- state in 188Pb. Several lowly excited high-K states are predicted, and the large oblate deformation and low energy indicate high-K isomerism in these nuclei. 相似文献
4.
5.
基于0.5μmCMOS工艺设计了一种具有快速瞬态响应的高性能比较器电路。利用大带宽前级放大器与后级高增益放大器的有机结合,实现高精度比较的同时保证比较器具有快速的瞬态响应。此外,提出了一种有源箝位电路,通过对比较器中间结点电压的变化范围加以限制,从而进一步提升了比较器的瞬态响应速度。仿真验证结果表明,该比较器电路仅需10μA电流即可实现33ns以内的瞬态响应时间,增益高达110dB,分辨率在1.5μV左右。 相似文献
6.
白鲢鱼骨蛋白酶水解工艺研究 总被引:12,自引:0,他引:12
以白鲢鱼骨蛋白为对象,研究Alcalase、Flavorzyme两种蛋白酶的适宜水解条件,并采用正交试验对Alcalase与Flavorzyme分步水解白鲢鱼骨蛋白的工艺进行了优化。结果表明:Alcalase、Flavorzyme的适宜反应温度分别为55和50℃,适宜反应pH值分别为7.5和6.0。分步酶水解的适宜条件是在料液比1:4(W/V),起始pH8.0时,用1500U/g、PrAlcalase于55℃水解2h后,再用1500U/g、PrFlavorzyme水解2h,水解度达30.05%,氮收率达79.80%;比单独用Alcalase或Flavorzyme水解时,鱼骨蛋白的水解度分别提高了10.05%和10.07%,氮收率分别提高了4.54%和12.54%。 相似文献
7.
A soft x-ray Pulse Height Analysis (PHA) diagnostic with the recently introduced Silicon Drift Detector (SDD) and a new MCA system has been installed in HT-7 for the measure-ments of electron temperature. With the SDD detector, the x-ray emission can be detected in the energy range from 1 keV up to 20 keV. The extremely low anode capacity of SDD allows very high counting rates of x-ray above 200 kHz and short shaping times below 0.25μs to be measurede. In routine operation a counting rate of 120 kHz has been normally obtained with an energy resolution of better than 180 eV at 5.9 keV. The assembly is equipped with six SDD detectors measuring the soft x-ray emission integrated along six chords of the upper half plasma cross section. The preliminary results from the new soft x-ray PHA diagnostic are also presented in this paper. 相似文献
8.
9.
提出了一种新型低功耗、高稳态电平位移电路。该电路能将5 V输入电压转换为10 V输出电压,在电路的初态和电平转换过程中均保持高稳态。采用瞬态增强结构,能加速电平信号之间的转换,有效地减小了传输延迟,提高了电路稳定性。瞬态增强结构在稳定状态时不发挥作用,减小了静态功耗,获得了低功耗。基于标准0.35 μm BCD工艺和多5 V LDMOS耐压器件,对该电平位移电路在5 MHz频率下进行验证。结果表明,动态功耗仅为24.8 μA,上升沿响应速度仅为12.7 ns,下降沿响应速度仅为22.8 ns。该电路具有可靠性高、功耗低的优点。 相似文献
10.
提出了一种随温度折返式变化的电流限产生电路。该电路能起到系统级过温保护的作用。采用NTC热敏电阻来采样温度的变化信息,再放大后转换成电流,以便动态并线性地控制电流限。利用内嵌的多环路控制策略,动态引入边界限制调整环路,实现电流限的上限和下限箝位。基于标准0.35 μm CMOS工艺,对折返式电流限电路进行了实现与验证。仿真结果表明,当NTC热敏电阻上的电压大于500 mV或小于350 mV时,电流限设置电压分别维持在500 mV(上限)和250 mV(下限);当NTC热敏电阻上的电压在350~500 mV之间变化时,电流限电压会在上限与下限值之间随温度线性变化,变化率为1.67 mV/mV。 相似文献