Corneal critical barrier against the penetration of dexamethasone and lomefloxacin hydrochloride: evaluation by the activation energy for drug partition and diffusion in cornea

The cornea is a solid barrier against drug permeation. We searched the critical barrier of corneal drug permeation using a hydrophobic drug, dexamethasone (DM), and a hydrophilic drug, lomefloxacin hydrochloride (LFLX). The activation energies for permeability of DM and LFLX across the intact cornea were 88.0 and 42.1 kJ/mol, respectively. Their activation energies for permeability across the cornea without epithelium decreased to 33.1 and 16.6 kJ/mol, respectively. The results show that epithelium is the critical barrier on the cornea against the permeation of a hydrophobic drug of DM as well as a hydrophilic drug of LFLX. The activation energy of partition for DM (66.8 kJ/mol) was approximately 3-fold larger than that of diffusion (21.2 kJ/mol). The results indicate that the partition for the hydrophobic drug of DM to the corneal epithelium is the primary barrier. Thermodynamic evaluation of activation energy for the drug permeation parameters is a good approch to investigate the mechanism of drug permeability.     

Measurement of Liquid Film Thickness by a Fringe Method

A technique was developed and tested to measure the local thickness of a droplet or a liquid film on a surface of an opaque or thick single transparent plate by an interference fringe pattern that was easily formed by reflecting laser lights. Monochromatic epi-illumination through an objective lens of a conventional microscope was provided by a 5 mW or 300 mW laser and a filter to remove the noise caused by laser speckle. The incremental height difference of the liquid layer between neighboring maxima or minima of fringes was evaluated from the wavelength of the laser light and the refractive index of the liquid. Estimation error of a local inclination angle was discussed using ray tracing under parallel illumination approximation. Droplet profiles evaluated from the interferogram that were obtained by the present fringe method agreed well with those by Laser Focus Displacement Meter. Measurement was made to ensure the usefulness of the present technique. It was made clear that the contact angle of a liquid droplet could be obtained precisely and swiftly, even in small size or small contact angle, and that instantaneous three-dimensional profile of a liquid film on a bubble moving in a microchannel could be measured. The fringe method had sufficient potential to obtain more detailed information about three-dimensional characteristics of liquid film in flows such as the generation, breakdown, and growth of waves and the liquid film on a bubble at the beginning of movement.     

Corneal Critical Barrier against the Penetration of Dexamethasone and Lomefloxacin Hydrochloride: Evaluation by the Activation Energy for Drug Partition and Diffusion in Cornea

The cornea is a solid barrier against drug permeation. We searched the critical barrier of corneal drug permeation using a hydrophobic drug, dexamethasone (DM), and a hydrophilic drug, lomefloxacin hydrochloride (LFLX). The activation energies for permeability of DM and LFLX across the intact cornea were 88.0 and 42.1 kJ/mol, respectively. Their activation energies for permeability across the cornea without epithelium decreased to 33.1 and 16.6 kJ/mol, respectively. The results show that epithelium is the critical barrier on the cornea against the permeation of a hydrophobic drug of DM as well as a hydrophilic drug of LFLX. The activation energy of partition for DM (66.8 kJ/mol) was approximately 3-fold larger than that of diffusion (21.2 kJ/mol). The results indicate that the partition for the hydrophobic drug of DM to the corneal epithelium is the primary barrier. Thermodynamic evaluation of activation energy for the drug permeation parameters is a good approch to investigate the mechanism of drug permeability.     

Steam absorption into films of aqueous solution of LiBr flowing over multiple horizontal pipes

The absorbers of absorption chillers consist of horizontal tube banks, over the outer surfaces of which absorbent flows and inside of which cooling water runs. The dependence of the distribution of absorption rate on the position of the pipes is important but has not been studied previously. In this paper, the cases of one to three pipes are studied experimentally in the range of film Reynolds numbers between 5 and 40. Three different surfaces are tested to study the effect of wettability. Numerical calculations are also performed using the method proposed in our previous paper. The highest absorption rates are obtained for the pipes with higher knurls, and their distributions agree with the numerical predictions. The pipe position which shows the maximum absorption rate varies with flow rate but the maximum absorption rate does not vary greatly with flow rate. The heat transfer coefficient is minimum and almost constant with flow rate at the top pipe. At lower pipes it becomes larger, but tends to decrease with increasing flow rate. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25(7): 476–485, 1996     

Investigation of liquid film behavior at the onset of flooding during adiabatic counter-current air–water two-phase flow in an inclined pipe

The liquid film characteristics at the onset of flooding in an inclined pipe (16 mm i.d. and 2.2 m in length) have been investigated experimentally. A constant electric current method and visual observation were utilized to elucidate the flow mechanisms at the onset of flooding. Two mechanisms are clarified to control the flooding in lower flooding and upper flooding, respectively. The lower flooding occurred at lower liquid flow rate and high pipe inclination angle. In this mechanism, the liquid film does not block the pipe cross-section. On the other hand, the upper flooding occurred at higher liquid flow rate and low pipe inclination angle. In this case, blocking of the pipe cross-section by large wave and entrainment plays an important role. The experimental data indicated that there was no reversal motion of liquid film at the onset of flooding during the operation of both lower flooding and upper flooding. The effects of pipe inclination angle on the onset of flooding are also discussed.     

Dynamic equilibrium of self-assembled cyclic trimer and tetramer of 1-methyl-5-imidazolylcobalt(III)porphyrin

Dynamic equilibrium of self-assembled multi-porphyrin systems is of interest in obtaining switchable photoresponsive material, but rarely reported. 1-methyl-5-imidazolylcobalt(III)porphyrin ( 1Co ) synthesized here assembled automatically into cyclic trimer and tetramer by intermolecular imidazolyl-cobalt(III) coordination. The trimer-tetramer equilibrium was dependent on concentration and solvent, as examined by NMR spectrometry. In CDCl₃, the tetramer formation was favored at high concentrations, as the ratio of the trimer to the tetramer was 1:2 at 14.8 mM 1Co , and shifted to 1:8 at 74 mM. Further, when the sample was concentrated from a CHCl₃ solution to dryness, the ratio increased to 1:24 on dissolution. In CD₃OD, on the other hand, only the trimer was observed in the wide concentration range. Accordingly, both the trimeric and the tetrameric structures could be prepared selectively by the choice of concentration and solvent.     

Charge trapping characteristics of Al2O3/Al-rich Al2O3/SiO2 stacked films fabricated by radio-frequency magnetron co-sputtering

A thin-film structure comprising Al₂O₃/Al-rich Al₂O₃/SiO₂ was fabricated on Si substrate. We used radio-frequency magnetron co-sputtering with Al metal plates set on an Al₂O₃ target to fabricate the Al-rich Al₂O₃ thin film, which is used as a charge storage layer for nonvolatile Al₂O₃ memory. We investigated the charge trapping characteristics of the film. When the applied voltage between the gate and the substrate is increased, the hysteresis window of capacitance-voltage (C-V) characteristics becomes larger, which is caused by the charge trapping in the film. For a fabricated Al-O capacitor structure, we clarified experimentally that the maximum capacitance in the C-V hysteresis agrees well with the series capacitance of insulators and that the minimum capacitance agrees well with the series capacitance of the semiconductor depletion layer and stacked insulator. When the Al content in the Al-rich Al₂O₃ is increased, a large charge trap density is obtained. When the Al content in the Al-O is changed from 40 to 58%, the charge trap density increases from 0 to 18 × 10¹⁸ cm^− 3, which is 2.6 times larger than that of the trap memory using SiN as the charge storage layer. The device structure would be promising for low-cost nonvolatile memory.     

Abnormal serum lysophospholipids in multiple myeloma patients

Lysophosphatidylcholine (LPC) and lysophosphatidic acid (LPA) mediate various kinds of biological activities and play an important role in cellular signal transduction. We analyzed serum phospholipids obtained from 16 multiple myeloma (MM) patients and observed that serum LPA level was significantly higher in MM patients (5.3±0.5 nmol/mL) than in normal controls (1.7±0.3 nmol/mL). LPC level was also higher than that in normal controls, and it correlated significantly with the concentration of LPA (r=0.678, P<0.01). In MM patients, palmitic acid/linoleic acid ratios in phosphatidylcholine and LPC were higher than those in normal controls. In the 12-mon follow-up study of two patients with the immune globulin G type, we recognized that the increase of LPC, LPA, and arachidonic acid/linoleic acid ratio in phosphatidylinositol corresponded with a decline in the serum albumin level and choline esterase activity.