Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

Chaos control and noise suppression in external-cavitysemiconductor lasers

Feedback-induced chaos and intensity noise enhancement in a laser diode with external optical feedback are studied by computer simulations. The enhancement of relative intensity noise (RIN) that is often observed in experiments is considered as a result of the feedback-induced deterministic chaos and the intensity noise suppression is treated from the viewpoint of chaos control. Especially, the conventional noise suppressing technique known as a high-frequency injection modulation is turned into a problem of stabilizing chaos through parameter modulations. We developed an analytical method which allows to optimize the modulation frequency from the linear stability analysis of the dynamical model that describes the laser diode with external feedback. The robustness of the modulation with respect to the modulation frequency and depth is verified and the results suggest the feasibility of applying our method to actual noise suppression. The RIN in the low-frequency region (up to 100 MHz) is shown to be reduced to the solitary laser level when the feedback-induced chaos is effectively controlled with the optimized modulation frequency     

Pulmonary vascular disease and operative indications in complete atrioventricular canal defect in early infancy

Pulmonary vascular disease was morphometrically analyzed in 67 patients (mean age, 19 months) with isolated complete atrioventricular canal defect. Complete obstruction of the small pulmonary arterial lumen resulting from acute fibrous proliferation and atrophy of the peripheral arterial media, which were considered absolute operative contraindications, were characteristic in six patients with Down's syndrome. Morphometric analysis of medial thickness revealed that thinning of the media of the small pulmonary arteries is generally observed at around 6 months of age in patients with complete atrioventricular canal defect and that the media in patients who have complete atrioventricular canal defect and Down's syndrome was thinner than that in such patients without Down's syndrome. These results suggest that thinning of the media as a result of two factors--Down's syndrome and aging--facilitates the rapid occurrence of fibrous intimal proliferation. Therefore intracardiac repair is desirable within 6 months of life, before medial thinning, in patients with complete atrioventricular canal defect and Down's syndrome. Excluding patients with absolute operative contraindications, the scores of the index of pulmonary vascular disease in operative survivors were below 2.0 and death occurred when scores were more than 2.2. The pulmonary vascular resistances measured in room air and by the oxygen inhalation and tolazoline tests in patients with operative contraindications were more than 7.3, 3.8, and 6.6 units.m2, respectively. We thus conclude that lung biopsy should be undertaken for patients in whom pulmonary vascular resistance is beyond these values to determine the appropriateness of surgical intervention.     

Graphite formation on Ni film by chemical vapor deposition

Thin film formation of graphite by chemical vapor deposition using 2-methyl-1,2′-naphthyl ketone as a starting material was carried out on Ni film substrates. On Ni films directly deposited on quartz glass, the graphite films were obtained when the Ni film thickness was above 1 000 Å and above 5 000 Å at 700 °C and 1 000 °C, respectively. Depositions on thinner Ni film substrates comprise amorphous carbon (a-C) or graphite tubes which was owing to the thermal coagulation of the Ni film into droplets. On the other hand, graphite film was obtained on the Ni film with thickness 10 Å when a-C was inserted between the Ni film and the quartz glass. The coagulation of the Ni film is considered to be avoided by inserting a-C layer.     

Permeation of Zidovudine and Probenecid from Oily Bases Containing Alcohols Through Rat Skin

Permeation of zidovudine (3'-azido-3'-deoxythymidine, AZT) and probenecid from oily bases containing an alcohol through rat skin was examined. Isopropyl myristate (IPM), as an oily vehicle, showed a penetration enhancing effect for AZT and probenecid. Ethanol, n-propanol, and n-butanol were used as additives in IPM and were examined for their own permeation and the enhancing effect on the permeation of AZT and probenecid. The skin permeation of AZT and probenecid from IPM was enhanced by addition of the alcohol in IPM. The degree of the enhancement was decreased with increasing lipophilicity of the alcohol used. me permeation rate of the drug from those systems was shown to be governed by penetration-enhancing effects of the oily base and alcohol, and the penetration of the alcohol itself through the skin.     

Impulse breakdown voltages of triggered multistage vacuum gap

Several sealed-off triggered vacuum gaps are connected in series to improve hold-off voltage. The characteristics of impulse breakdown voltage of these series-connected gaps are investigated experimentally. The sum hold-off voltage of series-connected gaps decreases to a unit hold-off voltage when the maximum value of voltage division ratio across the gaps increases to unity. Self-breakdown probability of the series-connected gaps is always higher than that of a single gap under the same conditions. Hence, stage efficiency of the multistage gap decreases with increasing number of stages. Its value is 90 percent with 2-stage gap and 75 percent with 5-stage gap, respectively, under the same voltage division ratio and the same gap length (2.0 mm) in each stage. Triggered breakdown voltage of 2- or 3- stage gap is several hundred volts when all gaps are triggered simultaneously at the peak of the main impulse wave and a working voltage range is nearly 100 percent in this case. The working voltage range decreases with number of stages. Its value is 45 percent with 3-stage gap and 15 percent with 5-stage gap, respectively, when one triggered gap is fired for switching.     

Fibre Bragg grating compression-tuned over 110 nm

A fibre Bragg grating with a tuning range covering beyond the C- and L-bands has been realised, which represents the broadest tuning range reported of any Bragg grating. The device exhibits constant spectral response and polarisation mode dispersion within these bands.