Oxidation of Hastelloy-XR Alloy for Corrosion-Resistant Glass-Coating

The oxidation behavior of Hastelloy-XR alloy was investigated to obtain the optimum surface condition for corrosion-resistant glass-coatings. The surface morphology of oxide scales changed significantly with variation of temperatureand oxygen partial pressure (po2 ). The oxidation kinetics was mainly parabolic independent of oxidation conditions.The oxide scales were consisted of inner Cr2O3 and outer spinel layers. The phase component of spinel layers wereMn1.5Cr1.5O4 and (Mn,Ni)(Cr,Fe)2O4 for the oxygen partial pressures po2<10 kPa and po2>10 kPa, respectively.The optimum oxidation condition to obtain an oxide scale for well-adhered glass-coating to the substrate was 1248 Kand po2 =0.01 kPa for the oxidation time of 43 ks.     

钢表面化学气相沉积TiC晶体的择优取向

本文用化学气相沉积(CVD)法,以TiCl_4-CH_4-H_2为原料气体,在不锈钢表面获得了致密的TiC膜.研究了TiC的成膜速度、表面形貌和晶体择优取向与沉积条什的关系.结果表明,沉积温度T_(dep),碳钛比CH_4/TiCl_4强烈地影响了TiC的成膜速度、表面形貌和晶体择优取向.CH_4/TiCl_4低时,TiC晶体的择优取向为(220):而CH_4/TiCl_4高时,TiC晶体的择优取向为(200).TiC晶体的择优取向主要取决于气氛中活性碳的平衡浓度。     

Detection of Buckminsterfullerene in Usual Soots and Commercial Charcoals

Abstract

It was confirmed that soot produced by free burning of small hydrocarbons like benzene and cyclohexane generally contains less than 0.1 ppm of C₆₀. Small, but measurable amounts of C₆₀ were found in two samples of charcoal, providing the first indication of fullerene formation in the solid state.     

Oxidation of CVD Si3N4 at 1550° to 1650°C

A thermo gravimetric study of the oxidation behavior of chemically vapor-deposited amorphous and crystalline Si₃N₄ (CVD Si₃N₄) was made in dry oxygen (0.1 MPa) at 1550° to 1650°C. The specimens were prepared under various deposition conditions using a mixture of SiCl₄, NH₃, and H₂ gases. The crystalline CVD Si₃N₄ indicated a parabolic oxidation kinetics over the whole temperature range, whereas the amorphous CVD Si₃N₄ changed from a parabolic to a linear law with increased temperature. The oxidation mechanism is discussed in terms of the activation energy for the oxidation and the microstructure of the formed oxide films.     

Effect of Ba Filling Fraction on Thermoelectric Properties of p-type Ba_yFe_(1.6)Co_(2.4)Sb_(12)

1　ＩｎｔｒｏｄｕｃｔｉｏｎＴｈｅｅｌｅｃｔｒｉｃａｌｔｒａｎｓｐｏｒｔｐｒｏｐｅｒｔｉｅｓ (ｃｏｎｄｕｃｔｉｏｎｔｙｐｅ ,ｃａｒｒｉｅｒｃｏｎｃｅｎｔｒａｔｉｏｎ ,ｃａｒｒｉｅｒｍｏｂｉｌｉｔｙ ,ｃａｒｒｉｅｒｅｆｆｅｃｔｉｖｅｍａｓｓ)ａｎｄｔｈｅｔｈｅｒｍａｌｔｒａｎｓｐｏｒｔｐｒｏｐｅｒｔｉｅｓ (ａｔｏｍｄｉｓ ｐｌａｃｅｍｅｎｔｐａｒａｍｅｔｅｒ ,ｍｅａｎｆｒｅｅｐａｔｈｏｆｐｈｏｎｏｎ ,ｌａｔｔｉｃｅｔｈｅｒｍａｌｃｏｎｄｕｃｔｉｖｉｔｙ)ｏｆｆｉｌｌｅｄｓｋｕｔｔｅｒｕｄｉｔｅｃｏｍｐ…     

High-performance polymer photovoltaic devices with inverted structure prepared by thermal lamination

Use of a lamination process for the introduction of Au electrode, instead of conventional metal evaporation, improved the power conversion efficiency (PCE) of inverted-structure photovoltaic devices from 1.6% to 2.6% based on a bulk heterojunction of poly(3-hexylthiophene) (P3HT) and (6,6)-phenyl C₆₁ butyric acid methyl ester (PCBM). X-ray photoelectron spectroscopy indicated that a thin layer of P3HT is spontaneously formed at the air/polymer blend layer interface during the spin-coating process. It is suggested that the vacuum-evaporated gold could destroy the surface-segregated thin layer of P3HT, while the lamination process preserves the surface structure working as an electron-blocking layer. The insertion of a PEDOT:PSS layer, between the metal electrode and polymer layer, in the lamination process further improved the PCE to 3.3% with a short-circuit current density of 9.94 mA cm⁻², an open-circuit voltage of 0.60 V, and a fill factor of 55% under AM1.5 100 mW cm⁻² irradiation.     

Improving the detection of requirements discordances among stakeholders

This paper introduces a technique to identify requirements discordances among stakeholders. This technique is validated in experiments. An extended version of the goal-oriented requirements elicitation method, named attributed goal-oriented analysis (AGORA), and its supporting tool are used. Two types of requirements discordances among stakeholders are defined: the first arises from the different interpretations by the stakeholders and the second is the result of different evaluations of preferences. Discordances are detected by the preference matrices in AGORA. Each preference matrix represents both preferences of each stakeholder and the estimated preferences of other stakeholders. A supporting tool for the AGORA method was developed. This tool is a groupware that seamlessly combines face-to-face meetings for goal elicitation and distributed individual sessions for scoring preference values. The experimental results showed that the proposed classification of discordances was sound and that the occurrences of the requirements discordances could be detected by preference matrices.     

The high performance liquid chromatographic determination of total malondialdehyde in vegetable oil with dansyl hydrazine

A simple high-performance liquid chromatographic (h.p.l.c.) method has been developed for determining total malondialdehyde (MDA), including free MDA and MDA released from its precursor in vegetable oils. Free MDA was reacted with dansyl hydrazine in an acidic medium, and the product, 1-dansyl-pyrazole(DP), was determined by h.p.l.c. The reaction releasing MDA from its precursor requires Fe³⁺ in 5% hydrochloric acid medium. Recoveries of free MDA and tetramethoxypropane (used as an MDA precursor) in vegetable oils were satisfactory. During autoxidation, a remarkable difference between the DP values of methyl oleate, methyl linoleate and some vegetable oils, and that of methyl linolenate was observed. Only methyl linolenate released MDA during autoxidation. For autoxidised methyl linolenate the DP value correlated with the thiobarbituric acid(TBA) value, although the DP value was only 30% of the TBA value.     

Premature deactivation of soleus during the propulsive phase of cat jumping

It has been shown that cat soleus (SOL) forces remain nearly constant despite increases in electromyography (EMG) activity for increasing speeds of locomotion, while medial gastrocnemius (MG) forces and EMG activity increase in parallel. Furthermore, during jumping, average cat SOL forces decrease, while average EMG activity increases dramatically compared with walking conditions. Finally, during rapid paw-shake movements, SOL forces and EMG activities are nearly zero. Based on these results, we hypothesized that the SOL is deactivated, despite ankle extensor requirements, if the contractile conditions limit SOL force potential severely. The purposes of this study were to (i) investigate SOL EMG activity and force as a function of its contractile conditions during jumping, (ii) test whether SOL EMG activity is associated with SOL contractile conditions, and (iii) determine the functional implications of SOL EMG activity during jumping. It was found that the SOL was prematurely deactivated in two distinct phases during the propulsive phase of jumping, in which shortening speeds approached or even exceeded the maximal speed of muscle shortening. We concluded that the SOL was prematurely deactivated to save energy because its mechanical work output approached zero, and speculated that the first phase of deactivation might be caused by a decrease in group Ia firing associated with active shortening and the second by a pre-programmed response inherent to the central pattern generator.     

Characteristics of an absolutely calibrated flat-field extreme ultraviolet spectrometer in the 10-130 A range for fusion plasma diagnostics

A flat-field extreme ultraviolet (EUV) spectrometer with a nominal 2400 grooves/mm aberration-corrected ruled grating has been developed to analyze the emission spectrum in the wavelength range of 10 to 130 A from large helical device (LHD) plasmas. Spectral properties such as resolution, sensitivity, contribution of higher-order light, and background stray light have been studied using emission spectra mainly from intrinsic impurities, e.g., C and Fe. It is found that the spectrometer well resolves closely existing spectral lines of highly ionized medium- and high-Z impurities even in a very short wavelength range such as 10 to 20 A. As a result, it allows one to study the charge state distribution of elements in high-temperature fusion plasma. The ruled grating was then replaced by a laminar type holographic grating for the comparative study. The spectral resolution for the ruled grating (Dlambda approximately 0.08 A at 33.73 A) is clearly better than the holographic grating (Dlambda approximately 0.13 A at 33.73 A). Both gratings well suppress the higher-order light, e.g., the second-order light is only less than 11% of the first-order light for C vi(33.73 A). Relative sensitivity calibration with the wavelength has been done using bremsstrahlung continuum from the LHD plasmas. Absolute intensity calibration has been done by comparing the spectral intensities directly with the absolutely calibrated 1200 grooves/mm EUV spectrometer in the overlapping range of 90-120 A due to the absence of a good branching pair in 10-130 A. As a typical result on the present spectrometer well-resolved n=2-3 full transition arrays from Ne- to Li-like ions are measured for Fe and Ti and wavelengths of the spectral array are tabulated for each charge state. Spectroscopic comparison is also made between the 1200 grooves/mm and 2400 grooves/mm gratings in a range of 50-130 A.