Distribution and connections of inspiratory premotor neurons in the brainstem of the pigeon (Columba livia)

We have recorded extracellular, inspiratory-related (IR) unit activity in the medulla at locations corresponding to those of neurons retrogradely labeled by injections of retrograde tracers in the lower brachial and upper thoracic spinal cord, injections that covered cell bodies and dendrites of motoneurons innervating inspiratory muscles. Bulbospinal neurons were distributed throughout the dorsomedial and ventrolateral medulla, from the spinomedullary junction through about 0.8 mm rostral to the obex. Almost all of the 104 IR units recorded were located in corresponding parts of the ventrolateral medulla, rostral to nucleus retroambigualis, where expiratory related units are found. Injections of biotinylated dextran amine at the recording sites labeled projections both to the spinal cord and to the brainstem. In the lower brachial and upper thoracic spinal cord, bulbospinal axons traveled predominantly in the contralateral dorsolateral funiculus and terminated in close relation to the dendrites of inspiratory motoneurons retrogradely labeled with cholera toxin B-chain. In the brainstem, there were predominantly ipsilateral projections to the nucleus retroambigualis, tracheosyringeal motor nucleus (XIIts), ventrolateral nucleus of the rostral medulla, infraolivary superior nucleus, ventrolateral parabrachial nucleus, and dorsomedial nucleus of the intercollicular complex. In all these nuclei, except XIIts, retrogradely labeled neurons were also found, indicating reciprocity of the connections. These results suggest the possibility of monosynaptic connections between inspiratory premotor neurons and inspiratory motoneurons, which, together with connections of IR neurons with other brainstem respiratory-vocal nuclei, seem likely to mediate the close coordination that exists in birds between the vocal and respiratory systems. The distribution of IR neurons in birds is similar to that of the rostral ventral respiratory group (rVRG) in mammals.     

FRACTURE ASSESSMENT FOR SECONDARY LOADS

The fracture assessment of structures subjected to secondary loading systems was studied by FEM-analysis of a few illustrative two-dimensional examples. The first example is an edge-cracked plate with a thermal gradient. The FEM-calculations revealed that a purely elastic analysis yielded J-values that are in most cases considerably more conservative than the ones calculated from an elastic-plastic analysis. The results were further compared with different engineering type non-linear estimates. As a second example a crack emanating from a semi-circular notch in a rectangular plate was chosen. The plate was subjected to uniaxial tension along its boundaries. It turned out that for the cases considered the J-values were fairly close to those elastically predicted.     

X-ray Fluorescence Uptake Measurement of Functionalized Gold Nanoparticles in Tumor Cell Microsamples

Quantitative cellular in vitro nanoparticle uptake measurements are possible with a large number of different techniques, however, all have their respective restrictions. Here, we demonstrate the application of synchrotron-based X-ray fluorescence imaging (XFI) on prostate tumor cells, which have internalized differently functionalized gold nanoparticles. Total nanoparticle uptake on the order of a few hundred picograms could be conveniently observed with microsamples consisting of only a few hundreds of cells. A comparison with mass spectroscopy quantification is provided, experimental results are both supported and sensitivity limits of this XFI approach extrapolated by Monte-Carlo simulations, yielding a minimum detectable nanoparticle mass of just 5 pg. This study demonstrates the high sensitivity level of XFI, allowing non-destructive uptake measurements with very small microsamples within just seconds of irradiation time.     

Phase Stability of Fine-Grained (Mg,Y)-PSZ

A fine-grained zirconia, which has been costabilized with yttria and magnesia, has been prepared. Its stability during subeutectoid annealing at 1100^deg;C, and its hydrothermal stability during hydrothermal treatment at 180^deg;C, have been determined and they are compared to those of Y-TZP and Mg-PSZ materials .     

Friction of linerboard based on recycled fiber

The purpose of this investigation was to study the origin of the differences in paper‐to‐paper friction of linerboards based on old corrugated containers (OCC). The sheets were subjected to two extraction stages and analyzed with respect to, surface roughness, and their content of low‐molecular‐mass lipophilic compounds (LLC). Friction was measured using a friction tester based on the horizontal plane principle. The surface roughness was measured using a Perthometer profiler and the low molecular mass lipophilic constituent of the paper sheets was determined by gas chromatography‐mass spectroscopy. The sheets were imaged using environmental scanning electron microscopy (ESEM), and the relative compositions of inorganic ions on the paper surfaces were determined by energy dispersive X‐ray spectroscopy (EDS). The results showed that a high amount of LLC in the sheets lead to low friction, due to lubrication. It was also observed that large CaCO₃ particles on the surface had a friction‐increasing effect, and that there was no relationship between the surface roughness and the friction. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 1511–1520, 2002     

Comparing variants of strategic ability: how uncertainty and memory influence general properties of games

Alternating-time temporal logic (ATL) is a modal logic that allows to reason about agents’ abilities in game-like scenarios. Semantic variants of ATL are usually built upon different assumptions about the kind of game that is played, including capabilities of agents (perfect vs. imperfect information, perfect vs. imperfect memory, etc.). ATL has been studied extensively in previous years; however, most of the research focused on model checking. Studies of other decision problems (e.g., satisfiability) and formal meta-properties of the logic (like axiomatization or expressivity) have been relatively scarce, and mostly limited to the basic variant of ATL where agents possess perfect information and perfect memory. In particular, a comparison between different semantic variants of the logic is largely left untouched. In this paper, we show that different semantics of ability in ATL give rise to different validity sets. The issue is important for several reasons. First, many logicians identify a logic with its set of true sentences. As a consequence, we prove that different notions of ability induce different strategic logics. Secondly, we show that different concepts of ability induce different general properties of games. Thirdly, the study can be seen as the first systematic step towards satisfiability-checking algorithms for ATL with imperfect information. We introduce sophisticated unfoldings of models and prove invariance results that are an important technical contribution to formal analysis of strategic logics.     

Technology and equipment for rational induction surface hardening of feed screws with recirculating balls

Conclusion At the National Enterprise Carl Zeiss Jena (East Germany) an improved method of continuous sequential induction hardening of feed screws with highly accurate length was worked out.The method was introduced into production jointly with the firm AEG-Elotherm (West Germany), which designed the corresponding equipment and apparatus.By continuous measurement of the length during continuous sequential surface hardening and immediate computer processing of the results of measurements it is possible by manual control of the speed of the inductor to maintain the elongation of the screw within previously specified narrow limits corresponding to the negative correction of the pitch of the thread envisaged in its cutting.Experience accumulated in recent years shows that the required absolute linear dimension of screws can be maintained with an accuracy of ±0.17 mm, regardless of the length of the screw (within the limits 0.5–4.0 m).Further improvement of the process will be effected chiefly by automating its control which at present is carried out manually.National Enterprise Carl Zeiss Jena (East Germany). AEG-Elotherm, Remscheid. Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 12, pp. 4–8, December, 1984.     

ExoPranayama: a biofeedback-driven actuated environment for supporting yoga breathing practices

Both breathing and internal self-awareness are an integral part of any yoga practice. We describe and discuss the development of ExoPranayama, an actuated environment that physically manifests users’ breathing in yoga. Through a series of trials with yoga practitioners and expert teachers, we explore its role in the practice of yoga. Our interview results reveal that biofeedback through the environment supported teaching and improved self-awareness, but it impacted group cohesion. Two practical uses of the technology emerged for supporting breath control in yoga: (1) biofeedback can provide new information about users’ current internal states; (2) machine-driven feedback provides users with a future state or goal and leads to improved cohesiveness.