Continuous hydrolysis of olive oil by lipase in microporous hydrophobic membrane bioreactor

Continuous hydrolysis of olive oil byCandida cylindracea’s lipase was studied in a microporous hydrophobic membrane bioreactor. Olive oil and buffer solution, fed continuously through two compartments partitioned by membrane, caused reaction at the interface of lipase-adsorbed membrane and buffer solution. Fatty acid was obtained in a single phase without being mixed with components of other phases. At all mean residence times, countercurrent flow mode was superior to cocurrent one. The lipase was adsorbed onto the membrane, and its adsorption was suggested to be partially specific from the experiments with enzymes having various levels of purity. The percent hydrolysis depended hyperbolically on the interfacial enzyme concentration. The hydrolysis seemed to be limited by diffusion of fat or fatty acid through the micropores of the membrane at higher interfacial enzyme concentrations. The lipase was stabilized significantly by glycerol added to the buffer solution. Satisfactory performance of the membrane bioreactor was obtained in a longterm continuous operation which lasted for 24 days by feeding buffer-glycerol (18.0%) solution over the adsorbed lipase. The operational half-life of the adsorbed enzyme was 15 days at 40 C.     

Superconductivity in SrTa2S5

A strontium tantalum sulfide, SrTa₂S₅, has a hexagonal structure with lattice constants of a =3.32 and c=24.1 Å. With decreasing temperature the electrical resistivity decreases monotonically and exhibits an abrupt superconducting transition at 3.16 K (midpoint). The diamagnetic susceptibility is observed below T_c. The magnetic susceptibility is nearly independent of temperature above T_c and shows Pauli paramagnetism.     

Effects of Annealing on Dielectric Loss and Microstructure of Aluminum Nitride Ceramics

The effect of annealing on tan δ and microstructures of aluminum nitride (AlN) ceramics were explored. Yttria was added as a sintering additive to AlN powders, and the powders were pressureless-sintered at 1900°C for 2 h in a nitrogen flow atmosphere. In succession to sintering, AlN samples were annealed at 720, 970 and 1210°C for 2 and 4 h. Very low tan δ values between 2.6 and 6.0 × 10⁻⁴ at 28 GHz were obtained when the AlN samples were annealed for 4 h at all the annealing temperatures.     

In-situ monitoring of the stabilization with hydrogen of free radicals thermally induced from coal using high pressure e.s.r., d.t.a. and p.d.a. equipment

High temperature, high pressure e.s.r. measurements of the hydrogenation reaction of Taiheiyo coal in the presence of catalysts were carried out to understand the stabilization of thermally and/or catalytically induced free radicals. A decrease in free radical concentration with increasing temperature was observed for ZnCl₂ and SnCl₂ · 2H₂O catalysts at 10MPa under hydrogen gas. High pressure modified single-cell d.t.a. and p.d.a. equipment augmented the uniquely designed high temperature, high pressure e.s.r. cell. The hydrogenation reaction was monitored under the same experimental conditions as for e.s.r. From the results of the combination of high temperature, high pressure e.s.r. with high pressure d.t.a. and p.d.a., it was established that H₂ molecules can react efficiently with free radicals from coal molecules created by the presence of ZnCl₂ and SnCl₂ · 2H₂O catalysts.     

Clonality in hepatocellular carcinoma: analysis of methylation pattern of polymorphic X-chromosome-linked phosphoglycerate kinase gene in females

Analysis of X-chromosome inactivation patterns in women has been used to assess the clonality of various tumors. In this report, we analyzed 27 liver tumors in women, including 18 samples obtained by the performance of ultrasonically guided thin-needle biopsies. By analysis of the heterogeneity of phosphoglycerate kinase gene, 11 of 27 (41%) cases were found to be heterozygous at the gene. Of these informative 11 cases with liver tumors, 7 cases were "large" tumors (> 25 mm in diameter) and 4 cases were "small" tumors (< 25 mm in diameter). All 7 large tumors showed monoclonal patterns by the phosphoglycerate kinase gene analysis. Of the 4 small tumors, 2 showed monoclonal, and 2 showed polyclonal patterns. The 2 with monoclonal patterns were pathologically diagnosed as hepatocellular carcinoma despite their small sizes (20 mm and 23 mm). Of the two with polyclonal patterns, the smallest one (15 mm) was diagnosed as benign adenomatous hyperplasia, and the other as hepatocellular carcinoma heavily infiltrated by lymphocytes. These data suggest that analysis of the methylation pattern of the phosphoglycerate kinase gene may be helpful on rare occasions in elucidating the nature of liver tumors but must in fact be used in conjunction with histological appearances to avoid errors secondary to inflammatory infiltrates.     

Development of a liquid tin microjet target for an efficient laser-produced plasma extreme ultraviolet source

A regenerative tin liquid microjet target was developed for a high average power extreme ultraviolet (EUV) source. The diameter of the target was smaller than 160 microm and good vacuum lower than 0.5 Pa was maintained during the operation. A maximum EUV conversion efficiency of 1.8% at the Nd:yttrium-aluminum-garnet laser intensity of around 2 x 10(11) Wcm(2) with a spot diameter of 175 microm (full width at half maximum) was observed. The angular distribution of the EUV emission remained almost isotropic, whereas suprathermal ions mainly emerged toward the target normal.     

Stochastic unit commitment problem

The electric power industry is undergoing restructuring and deregulation. We need to incorporate the uncertainty of electric power demand or power generators into the unit commitment problem. The unit commitment problem is to determine the schedule of power generating units and the generating level of each unit. The objective is to minimize the operational cost which is given by the sum of the fuel cost and the start‐up cost. In this paper we propose a new algorithm for the stochastic unit commitment problem which is based on column generation approach. The algorithm continues adding schedules from the dual solution of the restricted linear master program until the algorithm cannot generate new schedules. The schedule generation problem is solved by the calculation of dynamic programming on the scenario tree.     

Voltage Control of Static Var Compensator for a Remote System Interconnected by Long‐Distance AC Cables

The voltage variation in a remote system is large when the system is connected by long‐distance AC cables due to the cable capacitance. In Japan, the longest 54‐km 66‐kV AC submarine cable interconnection between the Kyushu mainland and Goto Islands was commissioned in 2005. It was requested to mitigate the voltage variation caused by switching off and on one circuit of the two circuits in the AC cables when a fault occurs. Since the conventional voltage control methods such as transformer tap changer or shunt capacitor and reactor banks are not sufficient because of their slow response time, a static var compensator (SVC) was installed on the Goto Islands. In such an application, an SVC control method should be developed so as not to override the existing voltage control systems. This paper describes the SVC control method developed for the Goto Islands AC interconnection project, which can be applied to similar situations. The effectiveness of the control method was verified by the results of effective value simulation and of field testing, which was implemented before the SVC was commissioned in 2007. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(3): 19–30, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22337     

Predictive Simulation of Deformation and Failure of Peat-Calcareous Soil Layered Ground Due to Multistage Test Embankment Loading

The continuous behaviour of a ground-embankment system from the stage of deformation up to failure was predicted with respect to an actual test embankment that had been constructed in stages on a soft ground made up of peat and calcareous soil. The behaviour prediction was carried out by employing soil-water coupled finite deformation analysis, which also included simulation of the embankment construction process. The information used in the analysis was limited to such things as the results of soil tests on soil materials (peat and calcareous soil) sampled from the ground, including their sensitivity ratios, and the embankment's construction history. The SYS Cam-clay model was used in the constitutive equations of the soils to determine the material constants of the soils and the initial conditions of the ground, and the computations were performed under plane strain conditions. As a result, the computed profiles of W-type ground settlement and of slip surfaces running through the embankment were found to be in good overall agreement with the actual profiles measured at the site. Furthermore, we found that this slippage is attributable to the undrained shear response of the soil elements in the calcareous soil layer, where slippage begins to occur during embankment loading. In other words, the slippage is caused by the rapid softening behaviour caused by the degradation of structure after the effective stress ratio reaches the vicinity of the critical state line.