排序方式: 共有24条查询结果,搜索用时 15 毫秒
1.
The FTO/TiO2 seed layer/TiO2 nanorods were prepared by ion beam deposition and hydrothermal methods. Under UV light, the photocurrent density of FTO/TiO2 seed layer/TiO2 nanorods can reach 1.39 mA/cm2, which is higher than that without seed layer and nanorods structure. Not only that, the FTO/TiO2 seed layer/TiO2 nanorods can also adsorb visible light, which overcomes the defect that traditional TiO2 can not absorb visible light. The photocurrent density of FTO/TiO2 seed layer/TiO2 nanorods can reach 0.21 mA/cm2 under visible light. The increased performance resulted from the deposition of the TiO2 seed layer, which can reduce the band gap of TiO2. FTO/TiO2 seed layer/TiO2 nanorods also exhibited high photodegradation ability for organic pollutant methylene blue (MB). Within 120 min, 77.3% MB can be degraded, and the degradation rates remained almost unchanged after four cycles. Not only that, compared with powdered photocatalysts, FTO/TiO2 seed layer/TiO2 nanorods is easy to recover, and it can be reused by rinsing it with water several times and drying it naturally after the reaction. 相似文献
2.
在岩石巴西劈裂试验中,垫条直径直接影响岩石抗拉强度的大小。为此,选取典型砂岩试样,进行了1.3 mm、1.8 mm、2.3 mm、2.9 mm、3.5 mm、4.0 mm 6种垫条直径的巴西劈裂试验。研究结果表明:(1)钢丝垫条直径从1.3 mm增大到4.0 mm,砂岩劈裂抗拉强度呈“减小—稳定—增大”的非单调变化规律,总体可以分为三个阶段,其中,垫条比为0.026~0.046、0.058~0.081时,砂岩的抗拉强度试验结果变化幅度较大,而且离散性比较明显;垫条比为0.046~0.058时,砂岩的抗拉强度趋于稳定,而且,试验结果离散性明显较小,破裂面平直,垫条对岩样的劈裂张拉破坏起到很好的导向控制作用。(2)钢丝垫条直径对岩石抗拉强度及破坏模式的影响,实际上是垫条直径与矿物颗粒粒径相互关系的影响,从试验结果来看,当垫条比为0.046~0.058时,也即垫条直径与矿物颗粒粒径比值在5.750~7.250时,试验得到的岩石劈裂抗拉强度比较稳定,离散性较小。因此,在岩石巴西劈裂试验中,建议根据岩石矿物颗粒大小选取合适的垫条直径,以保证试验结果的合理性和准确性。 相似文献
3.
4.
5.
<正> 甲基托布津(以下简称TM)是一种高效内吸性杀菌剂。其微量测定法已有三种:①薄层分析法;②高压液体色谱法;③紫外光谱法。其中①法精确度低,②、③法均需贵重的仪器设备,一般实验室难以满足,且紫外光谱法还得将样品用一定试剂进行较长时间处理,待TM转化成降解产物后再行测定,操作手续繁,分析周期长。为此,研究制定简单易行的TM分光光度测定法显得尤有必要。 相似文献
6.
7.
Gallium oxide(Ga2O3) thin films were prepared on Si substrate by magnetron sputtering. The obtained samples were comprehensively characterized by X-ray photoelectron spectroscopy(XPS) and scanning electron microscope(SEM). Ti, Pt, Ni and AZO were deposited on the Ga2O3 thin films as electrodes. This paper mainly studies the metal-semiconductor contact formed by these four materials on the films and the influence of annealing at 500℃ on the metal-semiconductor contact. The I-V characteristics show a good linear relationship, which indicates ohmic contact between Ga2O3 and other electrodes. 相似文献
8.
9.
串行通信控制器SCCs是MPC860T最强大的通信处理模块。通过配置QMC协议,使标准情况下只支持一条逻辑通道的SCC可以支持多达64条逻辑通道,进而支持具有广泛应用的E1/T1多时隙链路。本文阐述了MPC860T的SCC接口工作原理和QMC协议,重点研究了在SCC上实现QMC协议的基本设计方法及具体实现过程,并给出了主要功能函数的设计流程。 相似文献
10.