Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Nonuniformity of phase structure in immiscible polymer blends

This article is focused on the phase structure development in immiscible polymer blends during melt mixing. Nonuniformity of the phase structure, i.e., the coexistence of areas containing particles with markedly different size distribution, was detected in quenched and compression molded samples of a number of various blends prepared by long and intensive mixing in the chamber of a Plasticorder. The same effect was found also for polystyrene/polyamide blends prepared in a twin‐screw extruder. It was shown that neglecting nonuniformity of the phase structure can lead to considerable error in evaluation of the effect of system parameters on the blend morphology. The reasons for the effect were discussed and it was found that inhomogeneous flow field in mixers is a plausible explanation of the nonuniform phase structure. POLYM. ENG. SCI., 2008. © 2008 Society of Plastics Engineers     

The influence of preparation conditions on the electrochemical behaviour of CuO in a Li/CuO cell

A dozen CuO samples prepared under various conditions and from different starting materials were evaluated as cathode materials for a primary Li/CuO cell. The “thin electrode” method was used for rapid evaluation of the samples. Both coulombic efficiency and discharge voltage depend considerably on the method of synthesis. No correlation was found between the specific surface area and the resistivity of the samples on the one hand and the cathode performance on the other. Best results were obtained from CuO prepared by the oxidation of Cu₂O under controlled temperature and time of oxidation.     

Reactive energy measurement using frequency controlled analog-to-pulse-rate converter

Contents This paper analyzes a problem of phase shifting and deseribes a novel method for electronic reactive energy measurement. The proposed measurement structure, composed of an integrator as a phase shifting circuit and a frequency controlled analog-to-pulse-rate converter, provides for the measurement completely in accordance with IEC definition of reactive energy, which is performed with simple but high performance metering device.

---

Die Blindverbrauchsmessung anhand eines netzsynchronisierten Analog-Frequenz-Wandlers

Übersicht In diesem Artikel wird das Problem der Phasenverschiebung analysiert und eine neue Meßmethode für elektronische Blindverbrauschsmessung aufgezeigt. Die vorgeschlagene Strucktur, bestehend aus einem Integrator als Phasenschieber und netzkontrolliertem Analog-Frequenz-Wandler, ermöglicht die Verwirklichung eines einfachen aber präzisen Elektrizitätszählers zur Messung der Blindenergie, dessen Arbeitsprinzip mit den IEC Empfehlungen vollkommen übereinstimmt.

     

Phase transformation and densification during pressureless sintering of Si3N4 with MgO and Y3Al5O12 additives

The - transformation of Si₃N₄ during liquid-phase sintering appears to be controlled by the growth of the -Si₃N₄ grains in the direction perpendicular to thec-axis in the case of MgO additive. The diffusion through the liquid is the rate-controlling step in the case of the Y₄Al₅O₁₂ additive. The density of the sintered body at the solid skeleton stage was influenced by the change in the - transformation rate and/or by a change of the transformation mechanism. The indirect proportionality between the -phase content in the starting powder and the density at the solid skeleton stage was found. The microstructure of the sintered body is influenced by both the -phase content in the starting powder and the chemical composition of the additive. Fine, uniform microstructure with a high aspect ratio of -grains is obtained, when the -phase content in the starting powder is as small as possible and when the - transformation is controlled by grain growth.     

Modal logic as metalogic

The goal of this paper is to show how modal logic may be conceived as recording the derived rules of a logical system in the system itself. This conception of modal logic was propounded by Dana Scott in the early seventies. Here, similar ideas are pursued in a context less classical than Scott's.First a family of propositional logical systems is considered, which is obtained by gradually adding structural rules to a variant of the nonassociative Lambek calculus. In this family one finds systems that correspond to the associative Lambek calculus, linear logic, relevant logics, BCK logic and intuitionistic logic. Above these basic systems, sequent systems parallel to the basic systems are constructed, which formalize various notions of derived rules for the basic systems. The deduction theorem is provable for the basic systems if, and only if, they are at least as strong as systems corresponding to linear logic, or BCK logic, depending on the language, and their deductive metalogic is not stronger than they are.However, though we do not always have the deduction theorem, we may always obtain a modal analogue of the deduction theorem for conservative modal extensions of the basic systems. Modal postulates which are necessary and sufficient for that are postulates of S4 plus modal postulates which mimic structural rules. For example, the modal postulates which Girard has recently considered in linear logic are necessary and sufficient for the modal analogue of the deduction theorem.All this may lead towards results about functional completeness in categories. When functional completeness, which is analogous to the deduction theorem, fails, we may perhaps envisage a modal analogue of functional completeness in a modal category, of which our original category is a full subcategory.     

Nature-Inspired Meta-Heuristics on Modern GPUs: State of the Art and Brief Survey of Selected Algorithms

Graphic processing units (GPUs) emerged recently as an exciting new hardware environment for a truly parallel implementation and execution of Nature and Bio-inspired Algorithms with excellent price-to-power ratio. In contrast to common multicore CPUs that contain up to tens of independent cores, the GPUs represent a massively parallel single-instruction multiple-data devices that can nowadays reach peak performance of hundreds and thousands of giga floating-point operations per second. Nature and Bio-inspired Algorithms implement parallel optimization strategies in which a single candidate solution, a group of candidate solutions (population), or multiple populations seek for optimal solution or set of solutions of given problem. Genetic algorithms (GA) constitute a family of traditional and very well-known nature-inspired populational meta-heuristic algorithms that have proved its usefulness on a plethora of tasks through the years. Differential evolution (DE) is another efficient populational meta-heuristic algorithm for real-parameter optimization. Particle swarm optimization (PSO) can be seen as nature-inspired multiagent method in which the interaction of simple independent agents yields intelligent collective behavior. Simulated annealing (SA) is global optimization algorithm which combines statistical mechanics and combinatorial optimization with inspiration in metallurgy. This survey provides a brief overview of the latest state-of-the-art research on the design, implementation, and applications of parallel GA, DE, PSO, and SA-based methods on the GPUs.     

Theory of porous electrodes—XI. The positive plate of the lead-acid battery

Partial differential equations describing the transport of mass and electricity in the pores of the positive electrode of a lead acid battery were derived. The theory is based on exact transport equations and on the assumption that the solid porous matrix has a metallic conductivity. Volume changes in both phases are taken into account. Numerical solutions obtained on a computer are presented for the case where the influence of electrolyte between the electrodes can be neglected. The solutions depend on the product of electrode thickness times current density, and on the initial porosity.