Infrared absorption in Li-intercalated tungsten oxide

Thin films of amorphous and polycrystalline tungsten oxide were produced by reactive dc magnetron sputtering and nanocrystalline films were deposited by advanced gas evaporation. The films were submitted to electrochemical intercalation of Li ions before infrared reflectance measurements were carried out. For crystalline films, the reflectance in the wavelength region 10–30 μm increases upon intercalation, indicating an increasing free-electron contribution. On the other hand, all the films display an increased absorption at wavelengths less than 10 μm when intercalated. The thermal emittance could be varied from about 0.5 to 0.7–0.75 by intercalation in films with thicknesses in excess of 1 μm. Both absorption and interference contribute to the emittance contrast.     

Differential absorption lidar system for routine monitoring of tropospheric ozone

A differential absorption lidar system for routine profiling of tropospheric ozone for daytime and nighttime operation is described. The system uses stimulated Raman scattering in hydrogen and deuterium of 266-nm radiation from a quadrupled Nd:YAG laser. Ozone profiles from altitudes of 600 m to approximately 5 km have been obtained with analog detection. Implementing corrections for differential Rayleigh scattering, differential absorption from oxygen, sulphur dioxide, and nitrogen dioxide, and differential aerosol extinction and backscatter can reduce the total system inaccuracy to 5-15% for a clear day and 20-30% for a hazy day, except at the top of the mixed layer. Photon counting must be installed to increase the measurement range from 5 to 15 km. An example of an application of routine measurements of tropospheric ozone profiles is given.     

Amperometric biosensor for formic acid in air

The possibility of developing a simple, inexpensive and specific personal passive “real-time” air sampler incorporating a biosensor for formic acid was investigated. The sensor is based on the enzymatic reaction between formic acid and formate dehydrogenase (FDH) with nicotinamide adenine dinucleotide (NAD⁺) as a co-factor and Meldola's blue as mediator. An effective way to immobilise the enzyme, co-factor and Meldola's blue on screen-printed, disposable, electrodes was found to be in a mixture of glycerol and phosphate buffer covered with a gas-permeable membrane. Steady-state current was reached after 4–15 min and the limit of detection was calculated to be below 1 mg/m³. However, the response decreased by 50% after storage at −15°C for 1 day.     

A constraint-based variability modeling framework

Constraint-based variability modeling is a flexible, declarative approach to managing solution-space variability. Product variants are defined in a top-down manner by successively restricting the admissible combinations of product artifacts until a specific product variant is determined. In this paper, we illustrate the range of constraint-based variability modeling by discussing two of its extreme flavors: constraint-guarded variability modeling and constraint-driven variability modeling. The former applies model checking to establish the global consistency of product variants which are built by manual specification of variations points, whereas the latter uses synthesis technology to fully automatically generate product variants that satisfy all given constraints. Each flavor is illustrated by means of a concrete case study.     

The effect of microencapsulated phase change materials on the rheology of geopolymer and Portland cement mortars

The effect of microencapsulated phase-change materials (MPCM) on the rheological properties of pre-set geopolymer and Portland cement mortars was examined. Microcapsules with hydrophilic and hydrophobic shells were compared. The shear rate dependency of the viscosities fitted well to a double Carreau model. The zero shear viscosities are higher for geopolymer mortar, illustrating poorer workability. The time evolution of the viscosities was explored at shear rates of 1 and 10 s⁻¹. New empirical equations were developed to quantify the time-dependent viscosity changes. The highest shear rate disrupted the buildup of the mortar structures much more than the lower shear rate. Microcapsules with a hydrophobic shell affect the rheological properties much less than the microcapsules with a hydrophilic shell, due to the higher water adsorption onto the hydrophilic microcapsules. Shear forces was found to break down the initial structures within geopolymer mortars more easily than for Portland cement mortars, while the geopolymer reaction products are able to withstand shear forces better than Portland cement hydration products. Initially, the viscosity of geopolymer mortars increases relatively slowly during due to formation of geopolymer precursors; at longer times, there is a steeper viscosity rise caused by the development of a 3D-geopolymer network. Disruption of agglomerates causes the viscosities of portland cement mortars to decrease during the first few minutes, after which the hydration process (increasing viscosities) competes with shear-induced disruption of the structures (decreasing viscosities), resulting in a complex viscosity behavior.     

Polychlorinated naphthalenes in Swedish background air

Polychlorinated naphthalenes (PCNs) with four to eight chlorines were studied in air collected at two background stations in Sweden, one southerly and one northerly. Air was sampled with a high-volume sampler, and gas-phase adsorbents and filters were analyzed separately. The sum of TeCNs to HxCNs in the gaseous phase ranged between 1 and 10 pg/m3 with significantly higher concentrations at the southern location Hoburgen. HpCNs and OCN were below the detection limit. The highest concentrations were found in two samples from Hoburgen with the air masses coming from SW and W and during warm weather (+11 degrees C). The lowest concentration was found in a sample from the northern location Ammarn?s at cold weather (-22 degrees C) when the air came from the east. A correlation was found between logP and 1/T indicating that temperature has a larger effect than location on the concentration in the gas phase. The TeCNs constituted 50-75% in the gaseous phase. In most filter samples TeCNs and PeCNs were below the limit of quantitation. PUF samples with air trajectories from W to NE had relatively higher concentrations of late eluting TeCNs and PeCNs, while in samples with winds from SE to S the early eluting congeners dominated. Samples with early eluting congeners were mainly collected at lower temperature. TriCNs constituted the dominant homologue group both in the gaseous and particulate phase of air samples as well as in bulk deposition from a rural monitoring station south of Stockholm. The octanol-air partition coefficient described the gas/particle interaction well for samples collected at temperatures down to -8 degrees C.     

Contribution of biomass burning to atmospheric polycyclic aromatic hydrocarbons at three European background sites

Radiocarbon analysis of atmospheric polycyclic aromatic hydrocarbons (PAHs) from three background areas in Sweden, Croatia, and Greece was performed to apportion their origin between fossil and biomass combustion. Diagnostic ratios of PAHs implied that wood and coal combustion was relatively more important in the northern European site, while combustion of fossil fuels was the dominant source of PAHs to the two central-southern European background sites. The radiocarbon content (delta14C) of atmospheric PAHs in Sweden ranged between -388 per thousand and -381 per thousand, while more depleted values were observed for Greece (-914 per thousand) and Croatia (-888 per thousand). Using a 14C isotopic mass balance model it was calculated that biomass burning contributes nearly 10% of the total PAH burden in the studied southern European atmosphere with fossil fuel combustion making up the 90% balance. In contrast, biomass burning contributes about 50% of total PAHs in the atmosphere at the Swedish site. Our results suggest that the relative contributions of biomass burning and fossil fuels to atmospheric PAHs may differ considerably between countries, and therefore, different national control strategies might be needed if a further reduction of these pollutants is to be achieved on a continental-global scale.     

Curcumin Attenuates Environment-Derived Osteoarthritis by Sox9/NF-kB Signaling Axis

Inflammation has a fundamental impact on the pathophysiology of osteoarthritis (OA), a common form of degenerative arthritis. It has previously been established that curcumin, a component of turmeric (Curcuma longa), has anti-inflammatory properties. This research evaluates the potentials of curcumin on the pathophysiology of OA in vitro. To explore the anti-inflammatory efficacy of curcumin in an inflamed joint, an osteoarthritic environment (OA-EN) model consisting of fibroblasts, T-lymphocytes, 3D-chondrocytes is constructed and co-incubated with TNF-α, antisense oligonucleotides targeting NF-kB (ASO-NF-kB), or an IkB-kinase (IKK) inhibitor (BMS-345541). Our results show that OA-EN, similar to TNF-α, suppresses chondrocyte viability, which is accompanied by a significant decrease in cartilage-specific proteins (collagen II, CSPG, Sox9) and an increase in NF-kB-driven gene proteins participating in inflammation, apoptosis, and breakdown (NF-kB, MMP-9, Cox-2, Caspase-3). Conversely, similar to knockdown of NF-kB at the mRNA level or at the IKK level, curcumin suppresses NF-kB activation, NF-kB-promotes gene proteins derived from the OA-EN, and stimulates collagen II, CSPG, and Sox9 expression. Furthermore, co-immunoprecipitation assay shows that curcumin reduces OA-EN-mediated inflammation and chondrocyte apoptosis, with concomitant chondroprotective effects, due to modulation of Sox-9/NF-kB signaling axis. Finally, curcumin selectively hinders the interaction of p-NF-kB-p65 directly with DNA—this association is disrupted through DTT. These results suggest that curcumin suppresses inflammation in OA-EN via modulating NF-kB-Sox9 coupling and is essential for maintaining homeostasis in OA by balancing chondrocyte survival and inflammatory responses. This may contribute to the alternative treatment of OA with respect to the efficacy of curcumin.     

Alkyl ether and enol ether analogs of (Z)-5-decenyl acetate,a pheromone component of the turnip moth,Agrotis segetum: probing a proposed bioactive conformation for chain-elongated analogs

In order to test a previous conclusion that chain-elongated analogs of (Z)-5-decenyl acetate(1), a pheromone component of the turnip moth,Agrotis segetum, adopt a loop conformation of the terminal alkyl chain in the bioactive conformation, a series of alkyl ether and enol ether analogs of1 and (Z)-5-dodecenyl acetate(2) have been synthesized and tested using singlecell electrophysiology. In these analogs a methylene group in positions 7 and 9 of1 and in positions 7 and 11 in2 have been replaced by an oxygen atom in order to energetically facilitate the formation of a loop conformation in the chain-elongated analogs. The electrophysiological results in combination with molecular mechanics (MM2 and MM3) calculated conformational energies show that the activity decreases of the chain-elongated ether analogs are significantly smaller than that for2 and that these activity decreases parallel the conformational energies for a loop formation of the terminal chains in the analogs. The results support our previous conclusion that the terminal chain of chain-elongated analogs of1 adopts a loop conformation in their bioactive conformations.