Design of bandpass–bandpass diplexers using rectangular-, T-, and L-shaped resonators for hybrid power amplifier and 5G applications

Analog Integrated Circuits and Signal Processing - In this paper, two bandpass–bandpass diplexers, based on L-, T- and rectangular-shaped resonators are designed and analyzed, which are used...     

Microstructural,hydraulic conductivity and geochemical changes of drying mature fine oil sand tailings in column experiments

This study offers new insights into two-lift deposition of mature fine tailings under atmospheric drying. The interaction of newly added lift and former lift(s) was evaluated using column experiments in terms of volumetric water content, electrical conductivity (EC), hydraulic conductivity, geochemistry and microstructure. Water content and EC followed the same trend and decreasing of water content appears to be responsible for significant reduction in EC. Evaporation on top of the column reduced the water content to almost zero. The obtained results support the coupling between the hydraulic and chemical processes that should be considered by active operators.     

A 0.2-W Heterostructure Barrier Varactor Frequency Tripler at 113 GHz

We present a high-power InAlAs/InGaAs/InP heterostructure barrier varactor (HBV) frequency tripler. The HBV device topology was designed for efficient thermal dissipation and high efficiency. To verify simulations, the device was flip-chip soldered onto embedding microstrip circuitry on an aluminum nitride substrate. This hybrid circuit was then mounted in a waveguide block without any movable tuners. From the resulting RF measurements, the maximum output power was 195 mW at 113 GHz, with a conversion efficiency of 15%. The measured 3-dB bandwidth was 1.5%     

Equilibrium,kinetic and thermodynamic study of removal of reactive orange 12 on platinum nanoparticle loaded on activated carbon as novel adsorbent

The proposed research describes the synthesis and characterization of platinum nanoparticles loaded on activated carbon (Pt-NP-AC) and its efficient application as novel adsorbent for efficient removal of reactive orange 12 (RO-12). The influences of effective parameters following the optimization of variables on removal percentages, their value was set as 0.015 g Pt-NP-AC, pH 1, contact time of 13 min. At optimum values of all variables at 25 and 50 mgL⁻¹ of RO-12 enthalpy (ΔH⁰) and entropy (ΔS⁰) changes was found to be 59.89 and 225.076, respectively, which negative value of ΔG⁰ shows a spontaneous nature, and the positive values of ΔH⁰ and ΔS⁰ indicate the endothermic nature and adsorption organized of dye molecule on the adsorbent surface. Experimental data was fitted to different kinetic models including first-order, pseudo-second-order, Elovich and intra-particle diffusion models, and it was seen that the adsorption process follows pseudo-second-order model in consideration to intra-particle diffusion mechanism. At optimum values of all variables, the adsorption process follows the second-order kinetic and Langmuir isotherm model with adsorption capacity 285.143 mg g⁻¹ at room temperature.     

Investigation of chitosan‐g‐PEG grafted nanoparticles as a half‐life enhancer carrier for tissue plasminogen activator delivery

Tissue plasminogen activator (tPA) a thrombolytic agent is commonly used for digesting the blood clot. tPA half‐life is low (4–6 min) and its administration needs a prolonged continuous infusion. Improving tPA half‐life could reduce enzyme dosage and enhance patient compliance. Nano‐carries could be used as delivery systems for the protection of enzymes physically, enhancing half‐life and increasing the stability of them. In this study, chitosan (CS) and polyethylene glycol (PEG) were used for the preparation of CS‐g‐PEG/tPA nanoparticles (NPs) via the ion gelation method. Particles’ size and loading capacity were optimised by central composite design. Then, NPs cytotoxicity, release profile, enzyme activity and in vivo half‐life and coagulation time were investigated. The results showed that NPs does not have significant cytotoxicity. Release study revealed that a burst effect happened in the first 5 min and resulted in releasing 30% of tPA. Loading tPA in NPs could decrease 25% of its activity but the half‐life of it increases in comparison to free tPA in vivo. Also, blood coagulation time has significantly affected (p ‐value = 0.041) by encapsulated tPA in comparison to free tPA. So, CS‐g‐PEG/tPA could increase enzyme half‐life during the time and could be used as a non‐toxic candidate delivery system for tPA.Inspec keywords: drug delivery systems, nanofabrication, drugs, nanomedicine, coagulation, biomedical materials, cellular biophysics, enzymes, biochemistry, toxicology, molecular biophysics, biological tissues, blood, nanoparticles, polymersOther keywords: chitosan‐g‐PEG grafted nanoparticles, half‐life enhancer carrier, tissue plasminogen activator delivery, tPA half‐life, prolonged continuous infusion, enzyme dosage, polyethylene glycol, cytotoxicity, enzyme activity, encapsulated tPA, enzyme half‐life, blood coagulation, time 5.0 min     

Seismic performance evaluation of steel moment resisting frames through incremental dynamic analysis

Earthquake hazards effect significant damage to structures and cause widespread failure throughout buildings. Moment resisting frames are widely used as lateral resisting systems when sufficient ductility is to be met. Generally three types of moment resisting frames are designed in practice namely Special, Intermediate and Ordinary Moment Frames, each of which has certain level of ductility. Comparative studies on the seismic performance of these three different types of structure are performed in this study. Analytical models of connections are employed including panel zone and beam to column joint model. Incremental dynamic analysis is then utilized to assess the structural dynamic behavior of the frames and to generate required data for performance based evaluations. Maximum annual probability of exceeding different limit states may reveal the superiority of a ductile structure in which a greater behavior factor is employed. Special moment resisting frames are expected to perform better once a certain level of ductility is to be met but the amount of superiority may be the subject of investigation especially from a performance based design standpoint.     

The effect of nano-size additives on the electrical conductivity of matrix suspension and properties of self-flowing low-cement high alumina refractory castables

Influence of two nano-size additives on electrical properties of suspension matrix of self-flowing low-cement high alumina refractory castable is investigated. For this purpose, castament FS 10 and FS 20 on the basis of polycarboxylate ether were considered. The self-flow value, workability and mechanical strength of the castable are evaluated and their relations with electrical conductivity are determined. Using these relations, the type and optimum amount of proper additive for these refractory castables are determined. It was shown that if the electrical conductivity of matrix suspension is less than 0.71 mS/cm, high alumina low-cement self-flowing refractory castable can be obtained. The best self-flow, sufficient working time and adequate mechanical strength in the castables are obtained with 0.08 wt.% FS 20.     

A mathematical model and ant colony algorithm for multi-manned assembly line balancing problem

In real-world assembly lines, that the size of the product is large (e.g., automotive industry), usually there are multi-manned workstations where a group of workers simultaneously perform different operations on the same individual product. This paper presents a mixed integer programming model to solve the balancing problem of the multi-manned assembly lines optimally. This model minimizes the total number of workers on the line as the first objective and the number of opened multi-manned workstations as the second one. Since this problem is well known as NP (nondeterministic polynomial-time)-hard, a heuristic approach based on the ant colony optimization approach is developed to solve the medium- and large-size scales of this problem. In the proposed algorithm, each ant tries to allocate given tasks to multi-manned workstations in order to build a balancing solution for the assembly line balancing problems by considering the precedence relations, multi-manned assembly line configuration, task times, and cycle time constraints. Through computational experiments, the performance of the proposed ACO is compared with some existing heuristic on various problem instances. The experimental results validate the effectiveness and efficiency of the proposed algorithm.     

Effect of persulfate on the oxidation of benzotriazole and humic acid by e-beam irradiation

These days, the use of persulfate in advanced oxidation processes (AOPs) has gained more attention as an emerging clean and efficient technology to degrade the organic pollutants. The objective of this study was to investigate the effect of the addition of persulfate on the oxidation of benzotriazole (BT) and humic acids (HAs) by irradiation. The degradation of BT (3.7 μM) was followed under the influence of persulfate addition (200-500 μM) in combination with a fixed radiation dose (15 Gy) in the absence and presence of HA (5 and 20mg/L) in deionized water. The main results obtained in this study on the degradation of BT in the presence of HA showed a different effect of S(2)O(8)(2-) addition during irradiation, depending on whether HA are oxidized or not-oxidized. (1) An inhibitory effect of S(2)O(8)(2-) was observed in the presence of non-oxidized HA. (2) The removal of BT was generally more important during irradiation in the presence of S(2)O(8)(2-) when HA is pre-oxidized. This could be explained by the different structures of humic acids. These differences of structures of HA were identified by physico-chemical parameters such as the absorbance in the UV (254 nm), the fluorescence and the SUVA measurement.     

Wideband radar cross section reduction using a novel design of artificial magnetic conductor structure with a triple‐layer chessboard configuration

A novel wideband three‐layer chessboard‐like structure is proposed to reduce the radar cross section (RCS) of the radar target. This configuration is composed of two artificial magnetic conductor (AMC) cells formed by two crossed ellipses with different sizes in two cells. A desired 180° ± 37° phase difference is achieved by combining these unit cells and the measured 10 dB RCS‐reduction bandwidth is extensively broadened to more than 96% (from 8.11 to 23.32 GHz, covering X, Ku, and K bands for different radars) in comparison with the other works. This characteristic is obtained by carefully adjusting the positions of all resonances using the proper sizes for the ellipses and the proper dielectric constants and thicknesses for the three layers. Although, the proposed design has three layers with the overall thickness of 2 mm, it is still thinner than most of the recent related works. This low‐profile structure is also cost‐effective due to the fact that 60% of the overall thickness is formed by an air substrate. The proposed cells are designed, simulated, and fabricated in a chessboard‐like configuration for both monostatic and bistatic RCSs. Simulations and measurements are in a good agreement, which shows the capabilities of the design.